midstreamlighting.com call +44 (0) 207 584 8310
2 3
MODUS INSTALLATION GUIDANCE
Contents
24 mm standard wrench
#8, #10 and #14 allen keys
Powered drill-screwdriver with adjustable torque (clutch)r
Torx T30 insert bit for powered screwdriver (to be used
with M6 screws)
Torx T30 manual screwdriver
Monkey pliers
Electrician scissors for wires
Slotted manual screwdriver for connector’s screws
(blade dimensions: 3,5(w) x 0,6(t)mm)
DO NOT USE PERCUSSION DRILLS!
Equipment list
Wear safety shoes to protect yourself from material
dropping
Never energize the lamp if wiring operation are not
completed
H&S check
1. General notes
Section PAGE
1 General notes 2
2 Safety instructions 3
3 Contents 3
4 Bracket mounting and aiming 4
5 Visor mounting 6
6 Floodlight connection 7
7 Electrical connection 8
8 Electrical specifications 10
9 Dimensions 10
10 Weight and Windage 11
This user manual contains important information on safe
operation of the Luminaire.
Read and follow all safety notes and all instructions. Save this
manual for future reference.
Make sure that it is available to all persons using this device.
All wiring should be done by a licensed electrician in
accordance with state codes, local codes, and National
Electric Code (NEC) standards or International Electro
technical Commission (IEC) standards.
The Luminaire is suitable for wet locations.
NOTE: Prior to starting the installation, check the equipment
list to be sure of using the correct tools (mounting screw(s) and nut(s) are not
supplied).
DO
Store the Luminaire with care, avoiding placing the lenses
to the ground which may scratch or damage them
To avoid damaging the Luminaire, keep it in the original
packaging when storing
When handling the Luminaire, wear industrial safety
gloves and safety boots
Operate on circuitry when the electrical power supply is
disconnected
DO NOT
Apply mains voltage through the control system cable.
This will damage the luminaire that will no longer be
covered by warranty
Unnecessarily remove the Luminaire from the box
Leave the LED Luminaire switched on when rested on the
ground with optics facing down
Place the Luminaire with the lens on the pavement, dirt
and metal surfaces
Clean the lenses with any industrial detergent, but with
water-soaked cloth if needed
1
A
2 3 456 7 8 9 10 11 12
B
C
D
E
F
G
H
1 2 3 4 5 67 8 9 10 11 12
H
G
F
E
D
C
B
A
MIDSTREAM
209.2
370
439
80°
95°
175.8
209
REV. DOCUMENT N° DESCRIPTION ZONE DATE DRAWN CHECKED
A0 ST00118A006A0 Dim. changed, inner reflecting side added 15/3/19 FG PC
B0 ST00118A006B0 Layout variation 29/5/19 FG PC
This drawing is property of MIDSTREAM LIGHTING LTD. All rights reserved the partial or total reproduction of it is forbidden without express consent.
MIDSTREAM LIGHTING LTD - 1 CHESHAM STREET - LONDON - SW1X 8ND - UNITED KINGDOM - Ph +44 207 584 8310
Drawing Number ST00118A006B0 29-Mag-19
Date
1:2 1/1
Description Scale Sheet
FG PC MIDSTREAM 1.75 Kg B0
Drawing by Checked by Approved by Weight Rev.
1 12 RIVET_D3_2 POP RIVET 3.2 DIA x 6.0 LG ALUMINUM (LB4701002) RIVETTO BUSSOLA AL ø4, STELO INOX
2 1 ST00118P006B0 HYDRA SYMMETRIC VISOR
3 1 ST00118P01900 REFLECTING SIDE
POS QTY PART NUMBER DESCRIPTION NOTE
FINISHING:
POWDER COATING FOR OUTDOOR (POLYESTER)
AVG THICKNESS 80 micron
MATT FINISH - GLOSS 20 +10
COLOUR: BLACK RAL 9005
SHEET THICKNESS: 1 mm
A0
A0
B0
A0
2
3
1
Fitting bracket Set of connectorsVisor with screws and washers
x1 Modus 300
x2 Modus 600
x3 Modus 900
Caribiner hook and cable
Two persons
required to complete
the installation
Contains parts and
assemblies susceptible to
damage by electostatic
discharge (ESD)
The Luminaire should be
positioned so that prolonged
staring into the luminaire at
a distance closer than 4m
(13 ft) is not expected
Hard Hats, Safety shoes,
Hi-Vis vest and Safety
Gloves must be worn
at all times
Disconnect the electrical
supply power before
commencing the installation:
failure to do so could result
in serious injury
The luminaire is not to be
placed face down on any
surface other than the
provided foam pad
The light source of this
appliance must only be
replaced by the manufacturer,
its after-sales service or
qualified personnel
Do not use a
generator!
3. Contents
2. Safety instructions
Use the device only as described in this user manual. Any other
use or use under other operating conditions is considered to be
improper and may result in personal injury or property damage
as well as voiding the warranty.
No liability will be assumed for damages resulting from improper
installation.
Only persons with sufficient physical, sensorial, and intellectual
abilities and having corresponding knowledge and experience
may use this device.
