Midland CT310 Manual de usuario
DUAL BAND VHF/UHF TRANSCEIVER
› INSTRUCTION MANUAL
CT310
SPECIAL FEATURES
Memory
channels
FM radio 3 colors display
200
Index
Unpacking 1
Supplied Accessories 1
Maintenance 2
Main features 3
Programming software 3
Charging Operation 4
Battery Charger Type 4
Charging notes 4
How to Charge 4
How to Store the Battery 6
Warning 6
Installation & Connection 7
Installing / Removing the Antenna 7
Installing / Removing the Belt Clip 7
Installing Optional Speaker / Microphone 7
Getting acquainted 8
LCD Display 9
Turn the Radio On & O 10
Adjusting Volume 10
Switch between Main band and Sub band 10
Switch between Channel mode and VFO mode 10
Channel Adjusting 10
Frequency Adjusting 11
Frequency Input by Keypad 11
Channel Input by Keypad 11
FM Channel Searching 11
Receiving 12
Transmitting 12
Emergency Alarm 12
Side key PF2 function instruction 13
Edit channel 13
Delete channel 14
Programming scan 14
Turn On/ O FM Radio 14
CTCSS/DCS Setup 15
CTCSS/DCS Scan 15
Oset Frequency Direction Setup 15
Frequency/Channel Scan 16
Channel Scan Skip 16
Frequency Reverse 16
TX Power selection 17
Stopwatch function 17
DTMF code Transmit and Enquiry 17
Keypad lock 17
Single-band Switching 18
Function Menu Setup 18
Function Menu setup 20
Display Mode Setup 26
Resume Factory Default 26
Technical specification 27
CT310 Instruction Manual | 1
CT310 transceiver will provide you with reliable, clear and ecient
communication service. This sturdy and reliable transceiver introduces
innovative DSP digital signal processing technology, high degree integration
and it is including plenty of professional functions.
The transceiver is including plenty of TX, RX channels, as well as UU, VV and
UV standby modes which is able to realize cross band function, 51 groups of
CTCSS encode/decode and 1 group of user-defined CTCSS encode/decode,
1024 groups of DCS encode/decode, 5TONE encode/decode, DTMF
encode/ decode, built-in FM radio functions, etc..
It is a meticulous build functional and Multi frequency band radio for radio
amateur.
Unpacking
Please carefully unpack the transceiver. We recommend that you identify all
items before discarding the packing material.
If any items are missing or have been damaged during shipment, please contact
with dealers immediately.
Supplied Accessories
• CT310 transceiver with belt clip
• Li-Ion battery pack 7.4V 1200mAh
• Desktop charger
• Wall adaptor
2 | CT310 Instruction Manual
Maintenance
Your Two Way Radio is an electronic product of exact design and should be
treated with care.
The suggestions below will help you to fulfill any warranty obligations and to
enjoy this product for many years.
• Do not attempt to open the radio for any reason! The radio’s precision
mechanics and electronics require experience and specialized equipment;
for the same reason, the radio should under no circumstances be realigned
as it has already been calibrated for maximum performance. Unauthorized
opening of the transceiver will void the warranty.
• Do not store the Radio under the sunshine or in hot areas.
• High temperatures can shorten the life of electronic devices, and warp or
melt certain plastics.
• Do not store the radio in dusty and dirty areas.
• Keep the Radio dry. Rainwater or damp will corrode electronic circuits.
• If it appears that the Radio diuses peculiar smell or smoke, please shut o
its power immediately and take o the charger or battery from the radio.
• Do not transmit without antenna.
CT310 Instruction Manual | 3
Main features
• VHF/UHF dual band and channel displayed
• Operating modes: UHF/VHF, UHF/UHF, VHF/VHF
• Output power 5W UHF/VHF
• 200 memory channels
• 51 CTCSS tones and 1024 DCS codes
• 1750/1450/1000/2100Hz repeater tones
• SOS Emergency function
• FM radio receiver (76-107.95MHz)
• VOX, Scan, frequency band scan
• Mode selection: channel/frequency/name
• Talk Around feature (TX = RX)
• Frequency step: 2.5/5/6.25/10/12.5/20/25/30/50KHz
• Adjustable frequency oset: 0 – 69.9975MHz
• Dual transmission (PTT and SUB PTT keys)
• Stop Watch
• Automatic power o 30min/3 hrs
• Li-Ion battery pack 7.4V 1200mAh
• 2pin Kenwood accessory jack
Programming software
Thanks to the Midland Programming software PRG-G10, it is possible to
increase the performance of your radio or to reduce its functionality by
enabling or disabling some features.
For further information, please consult the Programming software manual.
When programming the transceiver, read the factory initial data first, then
rewrite the frequency and signaling etc., otherwise errors may occur because
of dierent frequency band etc.
4 | CT310 Instruction Manual
Charging Operation
The battery is not charged at the factory, please charge it before use. Charge
the battery for the first time after purchase or extended storage (more than
2 months) may not bring the battery to its normal operating capacity. After
repeating fully charge/discharge cycle for two or three times, the operating
capacity will reach the best performance. The battery life is over when its
operating time decreases even though it is fully and correctly charged. Replace
the battery.
Battery Charger Type
Please use the original charger by Midland; other models may cause explosion
and injure people. After installing the battery, if the radio red light twinkles, it
means that the battery is discharged; please charge it. .
Charging notes
• After the battery is charged to its highest capacity, don’t charge anymore.
• Do not short-circuit the battery terminals or throw the battery into fire.
• Never attempt to remove the casing from the battery pack.
• Please turn the power o before charging. It will aect the battery life when
charging the power-on radio.
• If the radio still shows low power after the normal charge, please change
the battery.
• The average usage time of battery pack is 11 hours. Average usage time is
5% for transmitting, 5% for receiving and 90% for standby.
How to Charge
1. Plug the AC adaptor into the AC outlet, then plug the cable of AC adaptor
into the DC jack, the indicator lights orange for 1s and turns into GREEN-
--waits to charge.
2. Slide the battery or transceiver with battery into the charger; make sure the
battery terminals are in contact with the charging terminals well. LED turns
into twinkling RED---pre-charging begins.
3. Pre-charging for about 5 minutes, LED twinkles stop then charging begins.
4. It takes about 4 hours to fully charge the battery, when LED turns into
GREEN — fully charged.
CT310 Instruction Manual | 5
NOTE: When charging a power-on transceiver equipped with battery, the LED
will not turn into green to show the full charge status; it will be indicated only
when you turn o the transceiver: because when the transceiver is turned on, it
would consumes energy and the charger cannot detect when the battery has been
fully charged.
Charging Process:
Standby (self-examine orange lights
1 second when power on)
Green light
Pre-charging (pre-charging stage) Red light twinkles for about 5
minutes
Charging RED light lightens for about 4 hours
Full charged Green light
LED Indicator:
STATUS LED
Self-examine when power on Orange (for 1 second)
(No battery) Green
Pre-charging Red light twinkles for 5 minutes
Charge normally Red
Full Charged Green
Trouble Red twinkles for a long time
NOTE: Trouble means battery heating, battery short-circuit or charger short-
circuit.
6 | CT310 Instruction Manual
Charging Prompt
1. Self-examination: When charging, ORANGE light twinkles for 1 second
and goes out. That means the charger has passed its self-examination and
it can charge the battery normally. If the light remains orange or the red
light twinkles, which means the charger can not pass its self-examination
or charge the battery.
2. Trickle pre-charging: When the battery has been inserted into the charger
and red light twinkles (it means the remnant voltage is low), the charger
trickle charges the battery (pre-charging status), until the battery reaches
a certain electric quantity, the charger automatically turns into normal
charging. And if the red light stops twinkling, (it means the remnant voltage
meets a certain electric quantity), the charger will charge the battery
normally.
NOTE:The time for Trickle pre-charging does not exceed 30m. After 30m, if
the red indicator is still twinkling, it means it is unable to charge battery. Please
kindly check battery and charger.
How to Store the Battery
If the battery needs to be stored for a long period, the battery should be
removed from the radio. Its state of charge should be 50-100% charged.
It should be kept in low temperature, dry environment.
Kkeep away from hot places and direct sunlight.
Warning
• Do not short circuit battery terminals.
• Never attempt to remove the casing from the battery pack.
• Never assemble the battery in dangerous surroundings, spark may cause
explosion.
• Do not put the battery in hot environment or throw it into fire, it may also
cause explosion.
Tabla de contenidos
Otros manuales de Radio bidireccional de Midland
Midland
Midland MICROMOBILE MXT105B Manual de usuario
Midland
Midland GXT600 Series Manual de usuario
Midland
Midland XT-70 Manual
Midland
Midland CT210 Manual de usuario
Midland
Midland ALAN 95 D80 PLUS Manual de usuario
Midland
Midland LXT380VP3 Manual de usuario
Midland
Midland 777 Manual de usuario
Midland
Midland X-Talker T290 Series Manual de usuario
Midland
Midland GXT-250 Manual de usuario
Midland
Midland BR180 Manual de usuario
Midland
Midland GXT500 Series Manual de usuario
Midland
Midland LXT490VP3 Manual de usuario
Midland
Midland LXT314 Manual
Midland
Midland X-Tra Talk LXT600 Series Manual de usuario
Midland
Midland LXT460 Series Manual de usuario
Midland
Midland X-TRA TALK LXT490 Series Manual de usuario
Midland
Midland x-talker t70 series Manual de usuario
Midland
Midland X-TRA TALK LXT110 Series Manual
Midland
Midland MICRO MOBILE MXT115V Manual de usuario
Midland
Midland GXT710 Series Manual de usuario
