Microtek 201SD Manual de usuario

FCC Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that

may cause undesired operation.

FCC Warning

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to

provide reasonable protection against harmful interference in a residential

installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful

interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

Caution:

To comply with the limits for an FCC Class B computing device, always use the

shielded signal cord supplied with this unit.

The Federal Communications Commission warns that changes or modifications of

the unit not expressly approved by the party responsible for compliance could void

the user’s authority to operate the equipment.

CE mark for Class B ITE (Following European standard EN55022/

1998; EN61000-3-2/1995; EN61000-3-3/1995, EN55024/1998,

EN60950/1992+A1+A2+A3+A4+A11)

Radio Frequency Interference Statement

Warning:

This is a Class B product. In a domestic environment, this product may cause radio

interference, in which case the user may be required to take adequate measures.

Canadian Doc Notice

For Class B Computing Devices

This digital apparatus does not exceed the Class B limits for radio noise emissions

from a digital apparatus as set out in the Radio Interference Regulation of the

Canadian Department of Communications.

“Le présent appareil numérique n’èmet pas de bruits radioélectriques dépassant les

limites applicables aux appareils numériques de la class B prescrites dans le

Règlement sur le brouillage radioélectrique édicté par le ministère des

Communications du Canada.”

Energy Star Notice

As an ENERGY STAR Partner, Microtek International, Inc. has

determined that this monitor meets the ENERGY STAR guidelines

for energy efficiency.

Table of Contents

Introduction ................................................................................. 5

Product Features.................................................................... 5

Unpacking .............................................................................. 6

Precautions ............................................................................ 6

Cleaning ................................................................................. 7

Connecting the Monitor .............................................................. 8

Adjusting theViewing Angle ....................................................... 9

Operating the Monitor ............................................................... 10

A.The Control Panel............................................................ 10

B. Hot Keys .......................................................................... 11

C. Adjusting the Monitor’s Display .................................... 11

The OSD MenuTable ........................................................... 12

Specifications ............................................................................ 13

SupportedTiming ...................................................................... 14

Troubleshooting......................................................................... 15

Introduction

Congratulations on the purchase of your new LCD monitor!With

a 20.1"TFT active matrix color crystal display and offering a

maximum resolution of 1600 x 1200 pixels, your 20.1" LCD

monitor offers sharp and vibrant color display with low

radiation emission. And with its low power consumption, the

monitor helps you reduce your power bill as well.

Product Features

• 20.1” high-contrastTFT color Liquid Crystal Display

• Supports UXGA resolution of 1600 x 1200 pixels

• VESA DPMS-compliant, power saving feature: Automatically

powers down the monitor after a defined period of inactivity

• Compatible withWindows 95/98/2000/XP and Mac OS 9.x/OS X

• Easy-to-use OSD (On-Screen Display)

• Plug & Play capability: Conforms to VESA standards, and

supports DDC1/2B specifications

• Multiscan function for perfect graphic performance:

Supports XGA 1024 x 768, SVGA 800 x 600,VGA 640 x 480 and

720 x 350, SXGA 1280 x 1024, UXGA 1600 x 1200

• Built-in speakers included

Unpacking

Before unpacking your LCD monitor, prepare a stable, level, and

clean surface near a wall outlet for the monitor.

1. Set the LCD monitor box in an upright position, and open

from the top of the box before removing the right/left

cushions.

2. Check to see that you have the following accessories:

• LCD monitor

• Power cord

• VGA cable (15-pin D-sub)

• DVI cable

• Audio cable

• User’s manual

Note: Remember to save your original box and packaging

material in case you need to transport or ship the monitor. If

you have to return your unit for service and the original

packaging has been discarded, please contact your dealer or

nearest service center for advice or replacement of packaging.

Precautions

• Read all of these warnings, and save the manual for later use.

• Follow all warnings and instructions on the product.

• Do not cover or block the vent holes in the case.

• Do not insert sharp objects or spill liquid into the LCD

monitor through the cabinet slots; this may cause accidental

fire, electric shock or failure.

• Disconnect the power plug from the AC outlet if you are not

going to use the monitor for an extended period of time.

• Do not attempt to service this product yourself, as opening or

removing the cover may expose you to dangerous voltage

points or other risks.

• Do not touch the screen directly with your fingers, as you

may damage the screen; oil is from your skin is difficult to

remove.

• Do not apply pressure to the screen, as the screen is very

delicate.

• Keep the monitor away from extremely hot, cold or humid

places.

• Do not place the monitor directly under sunlight, in dusty

surroundings, or near equipment which may generate strong

magnetic fields.

Cleaning

Warning:

If you drop any material or liquid such as water onto the

monitor when cleaning, unplug the power cable immediately

and contact your dealer or the nearest service center. Always

make sure your hands are dry when unplugging the power

cable.

Caution:

• For safety reasons, turn off the power switch and unplug the

monitor before cleaning.

• Do not scratch or rub the screen with a hard object.

• Never use any of the following solvents on the LCD monitor:

Thinner; spray-type cleaners; benzene; wax; abrasive

cleaners; and acid or alkaline solvents. Harsh chemicals such

as these may cause damage to the cabinet and the LCD

screen.

• Rubbing the cabinet with products made of rubber or plastic

for prolonged periods of time may cause degeneration or

loss of paint on the cabinet.

Cabinet

• Remove dirt with a lightly moistened cloth and a mild solvent

detergent.Then wipe the cabinet with a soft, dry cloth.

LCD

• Periodic cleaning with a soft, dry cloth is recommended.

• Do not use tissue to clean the LCD screen, as this may

damage the screen.

Connecting the Monitor

• Turn off your PC and the LCD monitor before connecting

your LCD monitor to the computer.

• Place the monitor on a flat and level surface.

• Usage of incorrect voltage will cause malfunction and may

cause fire or electric shock.

• Do not pull or bend the power cable, or place the monitor or

any heavy objects on the cables. If the cables are damaged,

fire or electric shock may ensue.

12 3 4

1. DC power jack: Connects to the power cord.

2. VGA: Connects with theVGA cable (15-pin D-Sub).

3. DVI: Connects with the DVI cable.

4. Audio jack: Connects with the Audio cable.

Adjusting the Viewing Angle

For optimal viewing, the viewing angle of the monitor may be

adjusted 35 degrees up and 3 degrees down.

Down: 3°

Up: 35°

Operating the Monitor

A.The Control Panel

1. Auto: Automatically fixes, centers and fine-tunes the video

signal to eliminate noise and distortion.

2. OSD Menu/select: Displays the OSD menu, and selects a

submenu item.

3. Adjustment button —: Indicates cursor movement, or

decreases the value of a selected OSD setting.

4. Adjustment button +: Indicates cursor movement, or

increases the value of a selected OSD setting.

5. Power switch ( ): Turns power for the LCD monitor ON

or OFF.

6. Power LED: Indicates various status levels for the monitor,

such as Green (Normal operation), and Orange (Power

management, depending on the mode of operating).

AUTO

Tabla de contenidos

Otros manuales de Monitor de Microtek

Microtek

Microtek 527C Manual de usuario

Microtek

Microtek 515M Manual de usuario

Microtek

Microtek 525M Manual de usuario

Microtek

Microtek 710S Manual de usuario

Microtek

Microtek 714S Manual de usuario

Microtek

Microtek 515C Manual de usuario

Microtek

Microtek C786 Manual de usuario

Microtek

Microtek C580 Manual de usuario

Microtek

Microtek 997M Manual de usuario

Microtek

Microtek 914SD Manual de usuario

Microtek

Microtek C788 Manual de usuario

Microtek

Microtek C589P Manual de usuario

Microtek

Microtek 714M Manual de usuario

Microtek

Microtek JTX V5 Manual de usuario

Microtek

Microtek C783 Manual de usuario

Microtek

Microtek 722S Manual de usuario

Microtek

Microtek JTX V7s Manual de usuario

Microtek

Microtek 715C Manual de usuario

Microtek

Microtek C586P Manual de usuario

Microtek

Microtek 729S Manual de usuario

Microtek

Microtek 815C Manual de usuario

Microtek

Microtek C893 Manual de usuario

Microtek

Microtek C580 Manual de usuario

Microtek

Microtek C997SD Manual de usuario

Manuales populares de Monitor de otras marcas

Linear Acoustic

Linear Acoustic LQ-1000 Manual de usuario

AOC

AOC I2579V Manual de usuario

Gateway

Gateway FPD1520 Manual de usuario

Furuno

Furuno Mu 120c Manual de usuario

Asus

Asus VB171D - 17" LCD Monitor Manual de usuario

Dell

Dell S2230MX Instrucciones de uso

Philips

Philips 107C64 Manual de usuario

Dell

Dell S2409WFP Manual de usuario

EverFocus

EverFocus EN-7517E Manual de usuario

Panasonic

Panasonic TH152UX1 - 152" PLASMA TV Manual de usuario

Dell

Dell Precision 7680 Manual de instrucciones

LG 50PM1M - - 50" Plasma Panel Manual de usuario

Bosch

Bosch DDU 9 Manual de usuario

Acer

Acer A231HL Manual de usuario

Philips

Philips 86BDL4152T Manual de usuario

NEC

NEC AccuSync LCD5V Manual de usuario

Emay

Emay SleepO2 Manual de usuario

IBM

IBM 6360 Instrucciones de instalación