Micromax D303 Manual de usuario

D303 L3 Service Manual

1：Technical Specifications

Particular

Remarks

Key Matrix For Flashing

Chipset

MT6572W

Android Version

Android4.4

Frequency

1.3GHz

Network Mode

850MHz/900MHz/1800MHz/1900MHz B1, B8

Rom

RAM

512MB

Internal SD Card memory

Expandable Memory

32G

Factory mode code

Press vol+/ Vol-/ power key at the same time

Good Earpiece volume

32Ω± 15%

Good Loudspeaker volume

8Ω± 5%

Good MIC volume

2.2kΩ± 5%

Good Vibrator volume

30Ω± 5%

D303 L3 Service Manual

2：CAUTIONS

I. Flashing & Servicing must be undertaken by qualified personnel only.

II. Ensure all work is carried out at an anti-static workstation and that an anti-static wrist strap is worn.

III. Use only approved Tools & components as specified in the parts list.

IV. Ensure all components, modules, screws, and insulators are correctly re-fitted after servicing and

alignment

V. Ensure all cables and wires are repositioned correctly if Handset disassembled

VI. Electrostatic discharge can easily damage the sensitive components of electronic products.

Therefore, Service Centre must Adhere the precautions which mentioned above.

3. L3 Service Manual

RF IC (U501)

TP slot (J802)

CPU

（U101）

RF PA

（U605）

TF connector

（J1201）

POWER IC

(U401)

RF antenna

Slot（E601）

Earphone jack

(J1003)

Main camera

(J902)

WCDMA

PA(U606 U601）

4 in 1 chip

（U701）

I/O

connector

(J1203)

Front camera

Connector

(J901)

Battery

connector

（J1202）

PWPKEY

（S1101）

FLASH（U301）

LCD Slot

(J801)

(MIC101)

proximity

sensor

(U1102)

Side key

connector (S1102，

S1103)

D303 L3 Service Manual

1. Unable to load Software:

Solution:

First check the computer can recognize the device or not, if not, Re-load it.

Then check the USB port to master control circuit is normal or not.：format the flash and upgrade again if fail

in the Proceed of downloading.

Use a fresh data cable

Check the I/O connector soldering quality ,if not ,Re-sold it or change it.

Check the CPU work normally or not. Re-Solder the CPU or change it

2. No power on

I/O

connector

CPU

D303 L3 Service Manual

Solution:

Flash the handset with latest SW

heck the battery have capacity or not ,if not ,Change it

Charging with transferred to 4.0 V dc power supply to the mainboard on battery Reordering ,check

The mainboard work current, the normal starting current will be from 100 ma jump to light screen

Enter boot LOGO 400 ma to completely started around 500 ma, if the current not right then check

There have short circuit or open circuit phenomenon or not.

Check the Power IC work normally or not ,Re-Solder it or change it

The output voltage normally or not

Check the crystal work normally or not ,Re-Solder it or change it

Check the CPU work normally or not, Re-Solder CPU or change it

3. Not charging:

Solution:

crystal

CPU

Power

D303 L3 Service Manual

Flash the handset with latest SW

Plug in the charger to check whether the machine has a charging icon, if don’t have, then check the

5V power pin of USB port connect the mainboard or not

Check the voltage of battery when charging If it reaches 4.2V, has shown in front of the

Transmission, now maybe is the battery bad so that no charging.

Check the I/O connector work well or not ,if not , Re-Solder or change it

Check the charging switch work well or not ,if not , Re-Solder or change it

Check the Power IC work normally or not, Re-Solder CPU or change it

Check the CPU work normally or not. Re-Solder the CPU or change it

4. LCD / Display problem:

Solution:

I/O

connector

Power IC

Charge

switch

D303 L3 Service Manual

Flash the handset with latest SW

Check the connect ribbon cable saddle normally or not ,Re-assembly LCD.

Check the LCD connector work normally or not, Re-Solder LCD connector

Check the CPU work normally or not, Re-Solder CPU or change it

5. Touch panel is not working

Solution:

CPU

LCD slot

D303 L3 Service Manual

Flash the handset with latest SW

Check the connect ribbon cable saddle normally or not ,Re-assembly TP.

Check the TP slot work normally or not, Re-Solder TP slot ;

Check the CPU work normally or not, Re-Solder CPU or change it

6. LCD backlight not on or dark

Solution:

Flash the handset with latest SW

TP slot

CPU

D303 L3 Service Manual

Check the connect ribbon cable saddle normally or not ,Re-assembly LCD.

Check the LCD connector work normally or not, Re-Solder LCD connector or change it

Check the Back driver work normally or not, Re-Solder Back driver or change it;

Check the CPU work normally or not, Re-Solder CPU or change it

7. SIM not detecting:

Solution:

Flash the handset with latest SW

CPU

LCD

connector

Back

driver

D303 L3 Service Manual

Check if the SIM card is obviously damaged, if yes, Replace the SIM card socket

Check if the ground impedance of each pin of the SIM card socket(except the ground pin)is low(lower than

grade ),if yes, Replace the varistor of the corresponding pin;

Check if the series resistors on each network of the SIM card have pseudo soldering ,if yes, Carry out repair

soldering of the series resistors on each signal line;

Check the Power IC normally or not, then Re-Solder Power IC or change it.

Check the CPU normally or not, then Re-Solder CPU or change it.

8. SD card not detecting:

Solution:

Flash the handset with latest SW

Check if the SD card is obviously damaged, if yes, Replace the SD card socket

SIM

Connector

CPU

Power IC

D303 L3 Service Manual

Check if the ground impedance of each pin of the SD card socket(except the ground pin)is low(lower than

grade ),if yes, Replace the varistor of the corresponding pin;

Check if the series resistors on each network of the SD card have pseudo soldering ,if yes, Carry out repair

soldering of the series resistors on each signal line;

Check the Power IC normally or not, then Re-Solder Power IC or change it.

Check the CPU normally or not, then Re-Solder CPU or change it.

9. Front camera is not working:

Solution:

Flash the handset with latest SW

Check if the Camera is obviously damaged, if yes, Replace the Camera ;

Connector

CPU

Power IC

Otros manuales de Teléfono móvil de Micromax

Micromax

Micromax aq4501 Manual de usuario

Micromax

Micromax A089 Manual de usuario

Micromax

Micromax A119 Manual de usuario

Micromax

Micromax A117 Manual de usuario

Micromax

Micromax L2 Manual de usuario

Micromax

Micromax Q427+ Guía de referencia

Micromax

Micromax A190 Manual de usuario

Micromax

Micromax X725 Manual de usuario

Micromax

Micromax Q2+ Manual de usuario

Micromax

Micromax A067 Manual de usuario

Micromax

Micromax AD4500 Manual de usuario

Micromax

Micromax Q301 Manual de usuario

Micromax

Micromax A46 Manual de usuario

Micromax

Micromax X395- Convertible Manual de usuario

Micromax

Micromax q36 Manual de usuario

Micromax

Micromax EG111 Manual de usuario

Micromax

Micromax X249 Manual de usuario

Micromax

Micromax S120 Manual de usuario

Micromax

Micromax Selfie 3 E460 Manual de usuario

Micromax

Micromax X512 Manual de usuario

Micromax

Micromax Q452 Manual de usuario

Micromax

Micromax X457 Manual de usuario

Micromax

Micromax X412 Manual de usuario

Micromax

Micromax A310 Manual de usuario

Manuales populares de Teléfono móvil de otras marcas

Zte

Zte BLADE A520 Manual de usuario

Nokia

Nokia Lumia 620 Manual de usuario

Blackbe;rry

Blackbe;rry KEYone Manual de usuario

Bea-fon

Bea-fon X5 Premium Manual de usuario

Blackbe;rry

Blackbe;rry 8707 Series Manual de usuario

Blackbe;rry

Blackbe;rry Storm Instrucciones de funcionamiento

LG LM-X420QN Manual de usuario

LifeWatch

LifeWatch V Manual de usuario

Bea-fon

Bea-fon SILVER LINE SL860 Manual de usuario

IKI Mobile

IKI Mobile KF4.5i Manual de usuario

Hitech

Hitech HT-850 Manual de usuario

Yezz

Yezz Fashion F10 Manual de usuario

Point Mobile

Point Mobile PM60 Manual de usuario

Blackbe;rry

Blackbe;rry Q10 Manual de usuario

Blackbe;rry

Blackbe;rry Bold 9900 Manual de usuario

Blackbe;rry

Blackbe;rry STORM 9500 - VERSION 5.0 Manual de usuario

LG LM-K420EMW Manual de usuario

ISAFE MOBILE

ISAFE MOBILE IS655.2 Manual de usuario