EN
CS 110 Door Controls / Rev. A 05 – 3
3. General safety instructions
Failure to comply with the documentation could
result in life-threatening danger!
Be sure to follow all the safety instructions in this docu-
ment.
Warranty
The warranty with regard to function and safety is only valid
if the warnings and safety instructions in these operating
instructions are observed.
MFZ Antriebe GmbH + Co. KG accepts no liability for personal
injury or material damage arising from failure to observe the
warnings and safety instructions.
MFZ shall not provide a warranty and does not accept any
liability for damage arising from the use of non-approved
replacement parts or accessories.
Use for the intended purpose
The CS 110 control unit is intended exclusively for the
purpose of controlling door systems that have mechanical or
electronic (AVE) travel limit systems.
Keep remote control units out of the reach of children and
do not allow children to play with xed regulating or control
devices.
Target group
Only qualied and trained specialist tters are allowed to
install the door operator and carry out mechanical servicing
work.
Qualied and trained specialist tters must have the follow-
ing:
− - Knowledge of the general and specic safety and
accident-prevention regulations
−- Knowledge of all the relevant regulations
−Training in the use and care of appropriate safety equip-
ment
−The ability to recognise the risks associated with the instal-
lation work
Only qualied and trained electricians are allowed to connect
up the door operator to the power supply and to carry out
electrical servicing work.
Qualied and trained electricians must have the following:
− Knowledge of the general and specic safety and accident-
prevention regulations
−Knowledge of the relevant electrotechnical regulations
−Training in the use and care of appropriate safety equip-
ment
−The ability to recognise the risks associated with electricity
Instructions relating to installation and connection
−Before commencing electrical works, the system must be
disconnected from the power supply. Measures must be
taken to ensure that the power supply remains switched off
for the duration of the works.
−The local safety regulations must be observed.
−Power cables must be laid separately from control cables.
Regulations and test specications
The following regulations must be complied with when
connecting, programming or servicing the unit. (The list is not
exhaustive.)
Construction product standards
− EN 13241-1 (Products without re resistance or smoke
control characteristics)
−EN 12445 (Safety in use of power operated doors - Test
methods)
−EN 12453 (Safety in use of power operated doors - Requi-
rements)
−– EN 12635 (Garage doors and gates - Installation and
use)
−EN 12978 (Safety devices for power operated doors and
gates - Requirements and test methods)
