8
3.2 Display sequence table
10 Accumulated energy (Default position)
11 Accumulated volume according to flow sensor
12 Display test, see fig.3.2
13 Accumulated volume for pulse input 1
14 Accumulated volume for pulse input 2
15 Error code, see Error code
16 Error time, [Minutes]
20 Momentary power
21 Momentary flow
22 High temperature, 0 decimals
23 Low temperature, 0 decimals
24 Temperature difference, 1 decimal
30 Account days, when values are stored, [YYMMDD]
31 Account days, Accumulated energy
32 Account days, Accumulated volume according to flow sensor
33 Account days, Accumulated volume according to energy
calculation
34 Account days, Accumulated volume pulse input 1, [gal]
35 Account days, Accumulated volume pulse input 2, [gal]
36 Possible error code, at time of storage of account days
37 Possible accumulated error time, at the time of storage account
days, [Minutes]
40 Monthly registers, date when values are stored, [YYMMDD]
41 Monthly registers, Accumulated energy
42 Monthly registers, Accumulated volume according to flow sensor
43 Monthly registers, Accumulated volume according to energy
calculation
44 Monthly registers, Accumulated volume pulse input 1, [m3]
45 Monthly registers, Accumulated volume pulse input 2, [m3]
46 Possible error code, at time of storage of monthly register
47 Possible accumulated error time, at the time of storage,
[Minutes]
4x Following monthly registers (loop back)
50 Operating time, [Hours]
51 Relevant date, [YYMMDD]
52 Relevant time, [HH.MM]
53 Recommended date for battery replacement, [YYMMDD]
60 Communication address, Primary address
A0 Communication address, Secondary address (normally same as
meter S/N)
bx Calculator serial number (S/N)
63 Pulse value [l/p]
64 Placing of flow sensor, [H/L], L = Low, H = High
70 Accumulated volume corresponding to accumulated energy
73 Last remote reading of accumulated energy
74 Time since latest remote reading of accumulated energy, [Hours]
75 Accumulated total error time, [Minutes]
1The calculator has two values for accumulated volume. Sequence 11 is calculated
relative to flow pulses. Value 70 is incremented in conjunction with energy
calculation.
