
In your packaging, you will be supplied with an installation guide, but some
important information is outlined below.
Also supplied are 4 U-Shaped clamps, suitable for 76mm Diameter posts.
(Other sizes are available upon request.)
3.1 IMPORTANT INFORMATION
Always observe the correct polarity when making electrical connections. Reverse polarity
connection to a battery is a re hazard and may damage your solar regulator/charge
controller.
Do not walk or drop objects on the panel front or rear.
Do not use mirrors or any other objects to concentrate sunlight on the solar panels.
Always handle with care.
3.2 MOUNTING
Choose a location that is free from shade and as close as possible to South facing (in the
Northern hemisphere).
Always x to a solid and supportive surface capable of withstanding all expected loads
including the weight of the panel as well as those imposed by wind and snow.
For optimum performance tilt the panel at an angle of 70° facing south.
3.3 MAINTENENCE
Occasionally wipe the solar panel with a damp cloth (use only water and mild detergent) to
remove the build-up of dirt, salt, etc.
Batteries should be maintained in accordance with manufacturer’s instructions.
(printed on the side of the battery)
All wiring and connections should be regularly checked for integrity and corrosion.
3.4 TROUBLESHOOTING
If your solar panel does not seem to be performing properly start by addressing the following;
Inspect all electrical connections for any sign of corrosion or loose wiring.
Test the panel’s open circuit voltage (Voc). To reduce risk of sparking cover the panel before
disconnecting. Using a multi-meter set to DC Volts, measure the voltage across the +ve and
–ve terminals of the panel. In bright sunny conditions a reading of approx. 18to 22V should
be seen.
Verify the condition of the battery. Over time a battery will lose its ability to recharge,
especially after repeated heavy cycles of charge and deep discharge. Contact the battery’s
manufacturer for more detailed guidelines on battery testing.
Make sure your system is properly sized for your power requirements.
3.0 SOLAR PANEL INSTALLATION (optional extra)