4. When the linking is complete, the receiver LED will change to solid red
and receiver will start to response to the transmitter after 2 seconds. Please
refer to the table below for the LED status of the receiver's condition.
Receiving signals and ID is matched. : On
Receiving signals, but ID is matched. : Off
No signal reception. : Off
Receiver ID memory is empty. : Blink per second
Change the transmitter ID
The transmitter has a individual randomize ID that is created in the factory,
Even it is almost have no chance to meet the same ID transmitter in the same
fly field, in case it does happen. The transmitter has an ID set up function.
By holding the “PDM” button to turn on the transmitter, the two LED will
blink. Press the “PDM” bottom to random change a new ID, the new ID will
active when the transmitter turn on next time, Once you have set up a new ID
for your transmitter, please must remember to re-Link your receiver with
your transmitter before flight.
You can go back to the original factory set ID by holding the “PDM” when
turn on the transmitter, without press the “PDM” bottom, turn it off and on
again to get back the original ID.
Range check the radio
A range check must be performed before the first flight of a new model. It is
not necessary to do a range check before every flight (but is not a bad idea to
perform a range check before the first flight of each day). A range check is
the final opportunity to reveal any radio malfunctions, and to be certain the
system has adequate operational range.
1. There is "Power Down Mode" build in for doing a ground range check
To activate the "Power Down Mode" by pressing the “PDM” button
on the right upper panel of the transmitter. The Green LED will turn
off to indicate the PDM is working. During this mode, the RF power is
reduced so the range test can be performed.
2. Walk away from the model while simultaneously operating the controls.
Have an assistant stand by the model and signal what the controls are
doing to confirm that they operate correctly. You should be able to walk
30 - 50 paces approximately from the model without losing control.
3. If everything operates correctly, return to the model. The "Power Down
Mode" continues for 60 seconds and after that the power will go back to
the normal level. To exit the "Power Down Mode" before the 60 seconds,
press the "PDM" key again.
4. NEVER start flying when the "Power Down Mode" is active.
