Meike Speedlite MK430 Manual de usuario
简体中文
English
一.Warning
1. Do not use the unit in the presence of flammable or explosive gas.
2. When the speedlite is dropped or damaged,do not touch any exposured inner metal parts
3. Stop the speedlite and take out the battery if there's heat,smoke or smell of burning to av-
id catching fire.
4. If the corrosive liquid leaked from the battery and get in your eyes,please clean your eyes
with clear water and consult your doctor.
5. The speedlite should not be dabbled in water, rain, sweat or moisture, to avoid catching
fire or causing electric shock.
6. Do not use the speedlite to photo the people who need concentrate on his work,or may
cause accident.
7. Do not use the speedlite to photo people's eyes nearly,or may damage their retinal of their
eyes.Do not use the speedlite to an infant within 1 meter.
8. It's forbidden to use activity reaent such as diluent or benzene to clean the components.
Never store the components in somewhere there are camphor and benzene,or the plastic
package would be damaged and catch fire or electric shock.
9. Do not leave the small accessories to somewhere the children can reach,so as to avoid
the children swallow them.If it happened,please consult the doctor at once.
10. Do not attempt to disassemble or repair the components of the flash,to avoid catching fire
or causing electric shock.
11. Please use the standard size(AA) or other ordinary rechargeable batteries.Make sure to
place the positive and negative of the batteries correctly.
12. To prevent overheating the flash head and shorten the operating life,do not flash contin-
uously for more than twenty times at the (1/1) largest setting.
-1-
Bedienungsanleitung24.de
二.Features
High GN: 42
Wireless trigger sensor
Recycle time 3 second (with 4 pcs AA alkaline cell)
Compatible with I -TTL flash automatically
Support Multi-flash lighting Appliction (s1/s2 mode)
Power saving mode
Accurate brightness control
LCD display
Metal hot shoe
Support front curtain synchronous
Support rear-curtain synchronous
Temperature detection Automatically (overheating protection)
Memory function
-2-
Bedienungsanleitung24.de
三.Components
-3-
1. Reflector panel
2. Wide-angle diffuser
3. Flash head
4. Wireless trigger sensor
5. Battery cover
6. Hot Shoe
7. Locking ring
8. Hot shoe pin
9. Locking pin
6
7 8
9
1
2
3
4
5
Bedienungsanleitung24.de
Components
-4-
10. LCD display
11. Mode switch button
12. Charging indicator
13. Test button(PILOT)
14. Zoom button
15.Power ON/OFF
16. Adjustment button
<left right button>
17. SET button
PILO T MODE ZOOM ON/O FF
10
13
11
12
16
15
14
16
17
Bedienungsanleitung24.de
四.Installation
-5-
1. Insert batteries
a. Slide the battery compartment cover in the direction of the arrow to open it.
b. Insert the batteries follow the direction inside the battery compartment cover,
Make sure to place the positive and negative of the batteries correctly.
c. Slide the battery compartment cover in the direction of the arrow to close it.
Note: Please use 4 pcs standard AA batteries.Please don't use damage batteries,
so as to avoid short circuit.
1
2
a b c
1
2
Bedienungsanleitung24.de
Installation
2. Install the speedlite on the camera.
a. Rotate the locking ring in the direction of the arrow to the hightest point.
b. Mount the speedlight into the camera`s hot shoe completely.
c. Turn the locking ring in the direction of the arrow tighten, Loosen the locking ring to the
top, then remove the flashlight from camera`s hot shoe, If you detach the speedlight.
a b c
-6-
Bedienungsanleitung24.de
-7-
Status of charging
indicator Meaning
Operation
Charging
The batteries
are full
Normal
Stop about 2 minutes,
waiting for flash cooling
Turn off to change battery
or turn on again
Normal
Status of charging indicator
Test status of charging indicator after turn on the speedlite.
solid red light
red light not lit
low power or charging time
exceeds 20 seconds
red light bink
LO-bA
LCDscreen shows
Bedienungsanleitung24.de
-8-
五.Basic functions
1.Basic Operations
Operation of the buttons:
Components
<Power Switch>
<Mode Switch Button>
<LEFT>and <RIGHT> button Press this button to adjust the output power of the speedlite.
<ZOOM> button
Press this button and the up and down keys to adjust the focal range
of the speedlite. Press once,the focal range will be among 18/20/24/
28/35/50/70/85/105/135/150/180MM
<Pilot> Button Press this button to test the input brightness of the speedlite.
Operation
Press once, the mode will change among the TTL/M/ /S1/S2.
The power of flashlight can be opened or closed by holding this
button for 2 seconds.
Bedienungsanleitung24.de
Basic functions
-9-
2.Turn on/ off the speedlite
2.2
P
Speedlite test
ress (PILOT),then the speedlite is flashing.
2.1 Turn on the speed light power
Press the botton ON/OFF for 2 seconds to turn on the
speedlight, then LCD screen steady. When the indicator
red light is blinking, this means the light is in charging;
the light turns solid when it finishes the charging, then
the light can work.
Bedienungsanleitung24.de
Tabla de contenidos
