button to delete all transmitters, (ATT: can not be recover once delete, be careful), press the 【back】button to
cancel.
3．2．3 Keys Function Setting
It need to reset the keys function of transmitters when a difference between the watch displaying function and
button function on the transmitter, after the customer finish adding the transmitters. In standby status, press the
【setting】button and into the system setting menu, same as picture 3-5, then press the 【up/down】button and
move to the keys function setting, same as picture 3-6, then press into it, firstly set the no. of zone, press the
【up/down】button to adjust the numerical value, long pressing the 【setting】button to skip position, same as
picture 3-19.
After setting the zone no., press twice of the 【setting】button and into the keys function setting, as picture 3-23
shows, when it screening “water”, please trigger your wanted button for water function, the watch sound a “di”
and screen a “ setting successfully” indicate the add is ok, then press the 【up/down】button to reset the other
function “call,check out, order, service, cancel” ( For hospital mode will be “Medication,Call,SOS, Needle,
Service,Cancel”) buttons, trigger the related buttons when you have a need.
You can use the same method to setting the keys function of other zones, if need to be a same setting for all the
zones, you can copy a finished zone setting details to the other ones, same as picture 3-23, press the 【setting】
button, move to the line “ copy no.0001 to all”, same as picture 3-24, press the 【setting】button again, when a
dialog box appear, press the【setting】button to confirm or press the【back】button to cancel. (You must firstly
add the transmitters then for the keys function setting)
Picture 3-22 Picture 3-23 Picture 3-24
3．2．4 Pager ID
After finishing the setting, users can allocate numbers for different demand (01-99 optional). In the standby
state, long press 【setting】once to enter the system setting menu, as shown in picture 3-5. Then press【up/down】
to move to “Pager ID”, like picture 3-6. Next press【setting】to enter the menu, and press【up/down】to adjust
the numeral value, as shown in 3-25. After that press 【back】to quit.
Picture 3-25
