9
a. 1 LED ash → low-weight panel (< 30 kg).
b. 2 LED ashes → low-to-medium-weight panel (> 30 kg and < 50 kg).
c. 3 LED ashes → medium-to-high-weight panel (> 50 kg and < 70 kg).
d. 4 LED ashes → high-weight panel (> 70 kg and < 90 kg).
**If the weight detected is over 90 kg, the door will become blocked. Flashing red LED.
4. Opening: at this me, the red LED of the driver will indicate the level of speed/weight to be applied to open
the panel, according to the eort needed to move it (panel weight).
5. Once the 4th movement is complete, the door will wait for a maximum of 10 s to set the SELF-CLOSURE
me in AUTO mode. Move the door, PUSH&GO to close, to determine this me. If the PUSH&GO closure
manoeuvre is not carried out within the 10 seconds, the door will automacally close and set the me to 5
seconds by default.
**IMPORTANT: THE PANEL MUST WEIGH AT LEAST 15 KG FOR THE OPERATOR TO FUNCTION
PROPERLY (smooth, sleek movements).
OPERATING MODE
The door has 2 operang modes:
1. PUSH&GO: The door will open with the PUSH&GO command, and will automacally close aer the me set
in automac adjustment step 5 has elapsed.
2. AUTO: This opon is available if the oponal TC MAG·NET S card is installed (95372.K1).
The door will open in PUSH&GO mode, with radars or with buons connected to the terminal of the
TC MAG·NET S card and will automacally close aer the me set in automac adjustment step 5 has elapsed.
“OPEN DOOR” MODE
Open the door, and once the opening manoeuvre is complete (before it starts to close, i.e. when the door is
fully open), hold the door for the number of seconds set in automac adjustment step 5, prevenng it from
carrying out the closure manoeuvre. The driver will detect that we want to acvate the OPEN DOOR mode.
To return to the PUSH&GO/AUTO mode, simply push lightly (PUSH&GO) to close it and the driver will return
to its automac mode.
