1.Safety guidance:
Thank you for using our product. In order to use this product safely and
effectively, you use this product,Please read the entire contents of this manual
carefully before.This manual contains: an introduction to this product and
Important information such as safe installation and use, please keep it for
reference. Related to installation and use The instructions must be strictly
followed.
Note ：The equipment is packed in good condition when leaving the factory.
Please operate according to the user manual. Failure to follow the
manual operation will cause failures and problems, or human failure will
cause the machine to fail.
●Before using the product, please open it and check carefully to ensure that the lamp has no
damage caused by transportation.
●The lamp is suitable for use in dry environments.
●Installation and operation of lamps should be performed by professionals.
●Use a secure rope when fixing the device, and hold the bottom when moving the light.
●The equipment must be installed in a well-ventilated area.
●Make sure that the vents are clear to prevent the lamp from overheating during operation.
●Before operation, ensure that the power supply voltage matches the power supply voltage
required by the device.
●Ground the conductor to prevent electric shock.
●Do not use the lamp in the environment above 40 ℃.
●There may be a small amount of smoke or odor when the new lamp is working, and it will
disappear after 15 minutes of operation.
●Do not place flammable objects next to the lamp during operation to prevent fire.
●Before turning on the lamp, please carefully check the power cord for damage, and replace
it immediately if damaged.
●The surface temperature of the lamp can reach 75 °C during operation. Do not touch it
with bare hands.
●Avoid flammable liquid, water or metal conductors entering the lamp to avoid electric
shock or fire. If foreign objects enter the lamp, please cut off the power immediately.
●Avoid operating in dirty and messy environments, and regularly clean and maintain the
lamps.
●Do not touch the wires when the lamp is running to prevent electric shock.
●Avoid twisting the power cord with other wires.
