Alcohol filler（１）：
As shown in picture B: open fireplace panel door, you will see a plastic tube mouth (there is
a power switch inside the machine ) connected the random distribution hose into alcohol
bucket purchased back.When turn on the filling switch, it can automatically extract the
alcohol to the fireplace fuel tank (if it is the initial power-up,filling pump will automatically
start to fill .If the fuel tank does not reach a high level within 25 minutes, the machine will
alarm and stop working.) After all filled up, it will automatically stop filling.And then pull out
the hose by hand clenched roots.Please pay attention not to drip alcohol. Ignite and use
after wipe clean.
Alcohol filler（２）：
Picture C shows: on the right side of the machine, there is a white interface.When you
design external storage tank in the first design time, please connect random configure the
hose here and connect random distribution hose into external storage tank.When pressing
filling witch, you can automatically extract alcohol and fill into fuel tank (when use in the
initial power-up, filling pump will automatically start to fill. If the fuel tank does not reach a
high level within 25 minutes, the machine will alarm and stop working) until the tank is filled
fully with voice prompts then it will stop to add the fuel automatically .when the machine
starts to work,, if lack of fuel storage tank inside the machine, the machine will automatically
replenish combustion, such cycle, as long as the external storage fuel tank full. you can
always use the boot cycle.After this interface connected ,it can add alcohol without artificial
to the auxiliary for long . (Suggested use this interface function).
Special note:when choose filler moment (1) ,ensure that the fireplace in the off state and no
