Maytronics Dolphin DYNAMIC 2002 Guía de configuración
Repair instructions for - TOP1
Table of Contents
I. Tools needed for repair Page 3
II. Dismantling the Dolphin Page 4
III. Testing and replacing main components Page 11
–Analyze power s pply Page 11
–Analyze cable Page 12
–Repair/replace cable Page 14
–Replace motor nit Page 21
IV. Replacing br shes Page 22
V. Replacing filter bags Page 25
2
*NOTE: Some images may differ slightly in shape color etc.
I. Tools needed for repair
•Dolphin tester
•Dolphin key
•Screwdriver or screw g n
•Needle nose pliers
•Wire c tters
•Wire strippers
•Cable crimper
•1.5 x 50mm hex screwdriver
Please note: when repairing any Dolphin cleaner
only hand-tighten screws. Do not over tighten! For
automatic screw guns use low torque setting only.
3
II. Dismantling the Dolphin
Remove screws
attaching handle to
body.
Remove handle. Use
gentle press re from a
screwdriver to help pry
it away from the body
if necessary.
4
II. Dismantling the Dolphin
Flip the nit over and
remove the bottom
plate.
5
Remove the two
screws attaching the
plastic screen to the
body.
II. Dismantling the Dolphin
Remove the plastic
screen.
6
Use the silver key to
remove cable from
motor nit.
II. Dismantling the Dolphin
Unpl g cable by gently
p lling pward.
7
Remove the 12 screws
(6 per side) that hold
the side panels to the
chassis.
II. Dismantling the Dolphin
Location of screws.
6 per side.
8
Remove the side
panels.
II. Dismantling the Dolphin
Note that the cable
passes thro gh the
panel on one side of
the nit.
9
The br shes and tracks
are now free to be
removed.
II. Dismantling the Dolphin
Note: the center g ide
wheel contains a
removable slot for the
drive shaft. This m st
be removed to replace
the motor.
10
Also, it’s easiest to
wind the tracks aro nd
the center g ide wheel
first and then attach to
nit.
Tabla de contenidos
