Professional
FM Transceiver
4
BATTERY INFORMATION
Do not recharge the battery pack if it is already fully charged. This may shorten the life of the▼
battery pack or damage the battery pack.
Do not charge the battery or transceiver if it is damp. Dry before charging to avoid danger.▼
WARNING:
When keys or other conducting items come into contact with the battery terminal, the battery may cause
damage or be dangerous. If the battery terminal does short circuit it will generate excessive heat,
please be careful when you carry or are using the battery, put the battery or the radio into an
insulated container. Do not put it into metal container.
How to Charge
Plug the AC adaptor into the power outlet, and then1.
plug the cable of the AC adaptor into the DC jack
located on the back of the charger. The backlight
lights orange (1s) and then goes out. Wait before
charging.
Plug the battery or transceiver into the charger.2.
Make sure that the battery terminals are firmly in contact
with the charging terminals. The backlight will
ash red. Pre-charging begins.
After pre-charging for about 5 minutes, the3.
backlight will stop ashing. Charging begins.
It takes approximately 4 hours to fully charge the battery. When the lamp goes to green, the charging 4.
is nished. Remove the battery or the transceiver equipped with the battery from the charger.
Ac Input
