Maxford Gee Bee Y40 Manual de usuario
Distributed by Maxford USA Corp. DBA: Green RC Models USA
Gee Bee Y 40” Electronic Scale ARF Instruction
Out of box parts and all hardware
Use the push rod for elevator, rudder is
pull-pull.
Install elevator control horns
Elevator control horn
Install pull-pull rudder control horns Use those 3 bigger screws with nuts for
rudder control horns Tail wheel Install tail wheel
Install vertical stabilizer
Distributed by Maxford USA Corp. DBA: Green RC Models USA
Install ailerons servos You need 2 12” servo extensions and
12” Y harness (We sell as well)
Use our SG90, SG50 or same size mini
servos
Install aileron control horn Main landing Gear
Step 1
Step 2 Step 3 Step 4
Step 5
Distributed by Maxford USA Corp. DBA: Green RC Models USA
One wheel done. Install wing to the fuselage Screw on wing bolts.
Install motor the mount box. Screws are
not come with hardware. It supposes to
come with your motor.
Install mount box to the fuselage. Use screws and nut come with the kit. Motor mount was designed with a little
bit down thrust.
Test your power system.
Install fiberglass cowl. Install wing holders. Two on each side. Cut and paste tail.
CG: 2 3/8” (60mm) from the wing front edge
Control Throw:
Ailerons - 27mm up and down, Elevator - 25 mm up and down, Rudder - 30mm up and down
Tabla de contenidos
Otros manuales de Juguete de Maxford
Maxford
Maxford Antonov An-2 Manual de usuario
Maxford
Maxford Hughes H-1 Manual de usuario
Maxford
Maxford L-4 Grasshopper Manual de usuario
Maxford
Maxford Jenny Manual de usuario
Maxford
Maxford FIESELER Fi-156c STORCH V2 Manual de usuario
Maxford
Maxford 40" EP Gee Bee Y Scale ARF V2 Manual de usuario
Maxford
Maxford Nieuport 28 Manual de usuario
