Matco Tools MWLFL2800 Manual de usuario

INSTRUCTION MANUAL

S2880, REV B

30W COB Rechargeable

Worklight

Powerful 30W COB

ﬂoodlight with dual power

source produces super

bright light up to 2800

lumen with wide spread

illumination

This ﬂoodlight works with

two power source:

• 115/220V AC

• Rechargeable Li ion

Battery

Aluminum die cast housing

in premium power coated

ﬁnish with Rubberised

Edge Guard making it

Impact Resistant

IK07 Rated

Protected against impact

of 0.5 kg mass dropped

from 400 mm height

Detachable 7.4V 4400

mAh rechargeable Li-ion

battery pack and can also

be used a power bank

Comes with detachable

magnet base to latch onto

any metallic surface

Can be mounted on tripod

for outdoor sites

IK07

RoHs

Detachable

Magnetic Base

30W COB

ﬂoodlight

Knob to

secure

attachment in

place

Rubberised

Edge Guard

POWER

SOURCE

Rechargeable

Li-ion Battery

AC Supply

WORKING

MODES

Two Modes:

1) 100% Intensity

2) 50% intensity

One Mode:

100% Intensity

LUMEN 1) 100% Intensity: 2800 Lm

2) 50% Intensity: 1400 Lm

100% Intensity: 2800 Lm

RUN TIME 1) 100% Intensity: 2 hrs

2) 50% Intensity: 4 hrs -

SPECIFICATIONS

CHARGING

TIME

3HRS IP54

WATER & DUST

PROOF RATING

115/220V AC

5V USB CABLE

POWER SOURCE

SAFETY INFORMATION

• Check for damaged parts and any other

conditions that may aect the operation

of this product. Replace damaged parts

immediately.

• Do not use the lamp in the immediate vicinity

of inﬂammable materials or gases.

• Only use the accessories included with the

product .

• Keep the lamp out of reach of unauthorised

persons, especially children.

• Do not point the light directly in your own or

any other person’s or animal’s eyes.

PACKAGE CONTENT

NOMENCLATURE

OPERATING INSTRUCTIONS (REFER

“NOMENCLATURE”)

Charging

1. Fully charge the battery before the ﬁrst use

on battery source.

2. Turn o the light and connect to the supplied

charger cable.

3. When the battery is fully charged, all the

indicator LEDs will constantly turn GREEN .

4. Full charging takes about 3 hours.

OPERATION

Mount the magnetic base on the bracket as

shown below to mount the light on a metal

surface.

USE WITH BATTERY POWER

• To switch ON the light press the button

labeled ON/OFF at the back of the unit.

• To change the intensity of light press the

button labeled 50%/100%.

• Power Bank- Insert a USB cable in the USB

slot and the device connected with the

battery will start charging

DESCRIPTION QUANTITY

Light 1

Magnetic base 1

Battery pack 1

Charging cable 1

ALight

BAdjusting Knob

CBracket

DMagnetic

EHandle

FButtons

GBattery Pack

HSocket

IAdaptor

Side View

Back View

Charging

input port

ON/OFF

USB output port

Intensity control

Battery Level Indicator

USE WITH AC POWER

1. Remove the battery from the light by

opening both the locks on the top and

bottom of the battery.

2. Assemble the adaptor and insert the cable

inside socket of the light.

3. Switch ON the power to switch on the light.

Note: There is no intensity setting for use in AC

power source

MAINTENANCE

• Before cleaning the LED worklight,

disconnect the USB cable(if being charged)

and allow the worklight to cool down

suciently.

• Clean with a dry or slightly moist, clean, lint-

free cloth and a mild detergent if required.

• Do not use cleaners that contain abrasives

or solvents.

• Check the LED worklight for damage before

each use. If the lens is damaged it must be

replaced immediately.

• Clean any dirt from the housing or the

lens immediately, since it could cause

overheating.

Note: The light source of this luminaire is not

replacable; when the light source reaches its

end of life the whole luminaire shall be replaced

DISPOSAL

The components or the used products must

be given to companies that specialize in the

disposal and recycling of industrial waste.

Otros manuales de Luz de trabajo de Matco Tools

Matco Tools

Matco Tools SL360MDLX Manual de usuario

Matco Tools

Matco Tools MWLALUM Manual de usuario

Matco Tools

Matco Tools UTL12 Manual de usuario

Matco Tools

Matco Tools UTL10A Manual de usuario

Matco Tools

Matco Tools M26LED Manual de usuario

Matco Tools

Matco Tools MWL60SMD Manual de usuario

Matco Tools

Matco Tools MCL1828LED Manual de usuario

Matco Tools

Matco Tools MWL40SMD Manual de usuario

Matco Tools

Matco Tools MWLHHTL Manual de usuario

Matco Tools

Matco Tools MFLCOB25 Manual de usuario

Matco Tools

Matco Tools MWLPS Manual de usuario

Matco Tools

Matco Tools M24LED Manual del producto

Matco Tools

Matco Tools MWLSFDC Manual de usuario

Matco Tools

Matco Tools MWLHH300UV Manual de usuario

Matco Tools

Matco Tools MPVL8 Manual de usuario

Matco Tools

Matco Tools MWLCR4 Manual de usuario

Matco Tools

Matco Tools MSL11 Manual de usuario

Matco Tools

Matco Tools SL360MDLX Manual de usuario

Matco Tools

Matco Tools MWL90SMD Manual de usuario

Manuales populares de Luz de trabajo de otras marcas

ANSMANN

ANSMANN POWERLIGHT 5.1 Manual de usuario

RTRMAX

RTRMAX RTX1868 Manual de usuario

FeinTech

FeinTech LAL00220 Manual de usuario

Bunker Hill Security

Bunker Hill Security 64735 Manual de usuario

Goobay

Goobay 30450 Manual de usuario

REV Ritter

REV Ritter SPOT Manual de usuario

Ignition

Ignition Stagepix Line 100 IP Manual de usuario

SCANGRIP

SCANGRIP DUO CONNECT Manual de usuario

Bosch

Bosch GLI 18 V Manual de usuario

Bayco

Bayco SL-1514 Manual de usuario

EUFAB

EUFAB SMD LED 8+1 Manual de usuario

DeWalt

DeWalt DCL510 Manual de usuario

PowerSmith

PowerSmith PWLD080T Manual de usuario

MaxLite

MaxLite 73683 Manual de usuario

Heitronic

Heitronic Trend 27867 Manual de usuario

Monzana

Monzana Gore MZCL10 Manual de usuario

EINHELL

EINHELL TE-CL 18/2000 LiAC Manual de usuario

Bayco

Bayco NIGHTSTICK Dual-Light Xtreme Lumens... Manual de usuario