Matchmaster Digimatch Explorer 01MM-DE7 Manual de usuario

Step 1

Turn UHF element and open UHF Dipole

to 90º to boom until they snap into place.

See diagram.

Step 3

Attach ribbon lead to G Unit by removing

wing nuts and place one lead end on top

of each nut. Replace wing nut and tighten.

Step 4a

Strip coax cable as shown in Fig 4A.

Fold shielding braid back over cable jacket.

01MM-DE7

UHF/VHF Caravan Antenna Installation Instructions

Cable Jacket

Shielding Braid

Dielectric

Core Conductor

▲

6 m m

▲

6 m m

Step 2

Attach double folded dipole ('G' Unit®) to boom using

the 6mm (1/4") hex head bolt washers & wing nut.

Ensure elements are on the top side of the boom & the

'G' Unit®is attached to the topside of the boom using

the hole closest to the UHF element.

See diagram.

For areas where UHF is horizontal and VHF vertical polarized, or

visa-versa, attach UHF section 90º to VHF section. See Fig 9A.

Step 5

Select RG6 connector with plain knurled body that is

supplied. Place “F” connector on back to front and

twist to ensure that all braid is flat. See Fig 5.

Step 4

Cut rubber boot seal as in Fig 4.

Feed balun cable through boot seal.

EXPLORER

Step 6

Then insert cable into rear of connector and

twist connector clockwise until dielectric is

flush with the bottom nut as in Fig 6.

Ensure that 2-3mm of centre

core conductor protrudes past the nut.

Step 7

Attach nut of connector to “Female connector” on antenna

and tighten finger tight.

WARNING OVER TIGHTENING MAY DAMAGE CIRCUIT BOARD.

Slide boot seal onto balun lid. See Fig 7.

Step 8

Assemble “U” bolt into boom.

See Fig8.

NB In vertical polarized areas,

mount “U” bolt in the holes

punched at 90 degrees

on adjacent face of boom.

Step 9

Attach antenna to mast and point to

transmitter as per Fig 9. Rotate

antenna to achieve best results.

Attach cable to mast with UV grade

insulation tape or UV grade cable ties

to support cable weight and avoid

damage to connection from

wind whiping cable from side to side.

To Transmitter

For any technical enquiries, please call our technical department

at Matchmaster on 1800-AERIAL (N.Z. 0800-AERIAL).

DE7 1-05

Step 9A – OPTIONAL

For areas where UHF is horizontal and VHF

is vertical polarized or visa-versa, attach UHF section

90º to boom as per diagram

or VHF section 90º to boom.

Refer to the caravan reception guide for

signal polarity in region required.

Tabla de contenidos

Otros manuales de Antena de Matchmaster

Matchmaster

Matchmaster 04MM-RP03 Manual de usuario

Matchmaster

Matchmaster Digimatch 03MM-DC21V Manual de usuario

Matchmaster

Matchmaster DigiMatch 02MM-DG91 Manual de usuario

Matchmaster

Matchmaster DiGiMATCH 03MM-BIGRAY Manual de usuario

Matchmaster

Matchmaster DIGIMATCH 01MM-DE13 Manual de usuario

Matchmaster

Matchmaster 01MM-DG27 Manual de usuario

Matchmaster

Matchmaster Digimatch 01MM-DC21A Manual de usuario

Manuales populares de Antena de otras marcas

Alfa Network

Alfa Network APA-L01 Manual de usuario

Naval

Naval PR-422CA Manual de usuario

Feig Electronic

Feig Electronic ID ISC.ANTH200/200 Series Manual de usuario

TERK Technologies

TERK Technologies TV44 Manual de usuario

Directive Systems & Engineering

Directive Systems & Engineering DSE2324LYRMK Manual de usuario

HP J8999A Manual de usuario

MobilSat

MobilSat MSP-S Manual de usuario

Steren

Steren ANT-UHF 13 Manual de usuario

Novatel

Novatel 600-G Manual de operación

Radio Shack

Radio Shack Amplified VHF/UHF/FM Indoor Antenna Manual de usuario

TRENDnet

TRENDnet TEW-AO12O Manual de usuario

Radio Shack

Radio Shack 15-1837 Manual de usuario

CommScope

CommScope CMAX-OMFX-43M-I53 Manual de usuario

Ramsey Electronics

Ramsey Electronics DAP25 Manual de usuario

COBHAM

COBHAM SAILOR 800 VSAT Manual de uso y cuidado

Trango Systems

Trango Systems AD900-9 Manual de usuario

Steren

Steren ANT-100 Manual de usuario

Proxim

Proxim 5054-PA-23 Manual de usuario