Map KF135 Manual de instalación
Programming instructions for
KF135 / KF136
To program the remotes you will need to have all the remotes available for the car as
you will need to relearn them all.
1. Sit in the vehicle with the doors closed
2. Turn key to the ACC position and press the rear demist button 3 times, within 5 seconds, doors will
now lock.
3. You then press a button on the first remote to be trained, the door locks will cycle.
4. Then press a button on the 2nd remote to be trained and the door locks will cycle again.
5. Repeat this step for the rest of the remotes to be trained to the vehicle (if applicable). You can train
up to 8 remotes.
6. Turn the ignition to the OFF position to exit the learning mode
7. Your remotes are now programmed to the vehicle.
Warning! This remote contains a button/coin cell battery. If swallowed, a lithium battery can cause severe or fatal
injuries within 2 hours. Keep batteries out of reach of children. If you think batteries may have been swallowed or
placed inside any part of the body, seek medical attention immediately.
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Mando a distancia de Map
Map
Map KF316 Manual de instalación
Map
Map KF308 Manual de instalación
Map
Map KF308 Manual de instalación
Map
Map KF297 Manual de instalación
Map
Map KF935 Manual de instalación
Map
Map KF373 Manual de instalación
Map
Map KF297 Manual de instalación
Map
Map KF150 Manual de instalación
Map
Map KF308 Manual de instalación
Map
Map KF297 Manual de instalación
