Manitowoc I1406 Series Instrucciones de funcionamiento y seguridad

Manitowoc Ice

2110 South 26th Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA 000013291

Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879 Page 1 of 2

Web Site - www.manitowocice.com Rev 00

COMPRESSOR REPLACEMENT

I1406 SERIES

1. Disconnect the power to the ice machine at the electrical 6. Unbraze the suction line at the compressor port. Unbraze

panel. (pushing the power button to the off position the discharge port at the compressor.

will not disconnect line voltage). Unbraze the bottom joint at the compressor discharge port.

2. Remove all the panels (top, front left, and right sides). Cut the tubing when replacing filter drier.

3. Recover all refrigerant from the ice machine. Do not unbraze the filter drier.

4. Remove the right rear back panel and top rail.

Note:

(Orientation is done while facing the front of the ice machine)

Note: When replacing the compressor in a Remote

Ice Machine; be sure to unbraze the suction

and process port at the compressor, replace

the filter drier. Cut tubing to replace the

filter dryer. Do not unbraze filter drier.

Remember that there are four points of

recovery on a remote.

5. Remove the wiring or plug from the compressor terminals.

7. Remove the compressor from the ice machine. Make

sure compressor ports are crimped and brazed shut.

Unbraze

I1406

Compressor

plug location

I1406

Compressor

position

Filter Drier

Cut the tubing

4 Recovery

Points

Manitowoc Ice

2110 South 26th Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA 000013291

Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879 Page 2 of 2

Web Site - www.manitowocice.com Rev 00

COMPRESSOR REPLACEMENT

I1406 SERIES

9. Insert the NEW compressor into the Ice Machine, and

Position the compressor as shown.

11. Purge the system with nitrogen before and during

all brazing operations.

I1406 Air, Water, & Remote Ice Machines

12. Position the tubes back into compressor.

13. Replace the filter drier before evacuating the refrigeration

system of the ice machine.

Secure in place while brazing the joints

10. Reinsert the old tubing into the new compressor ports. Braze all tubing into place.

Insert 1/2 OD discharge tube into the discharge port of 14. Evacuate to 500 microns minimum.

the compressor. Insert 5/8 OD suction tube and bushing Insure that all the tubing is not rubbing against

supplied with the kit, (if required) port of the compressor. anything in the ice machine.

Braze tubes into the compressor ports. Insure that the thermistor and clip are replaced back onto

the 1/2 OD discharge tube and the new thermistor boot

Adjust the tubing to fit without rubbing supplied in the kit.

any other tubing or parts of the ice machine. 15. Reinstall the corner post and then the top rail.

16. Be sure to replace the run capacitor supplied with

compressor kit.

17. Weigh in correct refrigerant charge from the nameplate

found on the ice machine.

18. Reconnect the compressor with the wiring harness.

19. Reinstall all the other remaining outer panels.

20. Reconnect the power and turn on power switch.

Test and run the ice machine.

Suction tube

position.

New

Compressor

Discharge tube

connection position

Suction

Tube

Discharge

Tube

Thermistor boot

Otros manuales de Máquina de hielo de Manitowoc

Manitowoc

Manitowoc EC18 Manual de usuario

Manitowoc

Manitowoc MAC 6 K058 Manual de usuario

Manitowoc

Manitowoc Q 7628973 Manual de usuario

Manitowoc

Manitowoc RNS012 Manual de usuario

Manitowoc

Manitowoc B150 Manual de usuario

Manitowoc

Manitowoc B Series Manual de usuario

Manitowoc

Manitowoc Indigo I0300 Manual de usuario

Manitowoc

Manitowoc MARINE MODEL S1800 Manual de usuario

Manitowoc

Manitowoc Q450 Manual de usuario

Manitowoc

Manitowoc CORNELIUS ENDURO K00342 Manual de usuario

Manitowoc

Manitowoc ADAPTER KIT K00365 Manual de usuario

Manitowoc

Manitowoc NEO Manual de usuario

Manitowoc

Manitowoc Marine Q800 Guía

Manitowoc

Manitowoc Multiplex Ms-8 Manual de usuario

Manitowoc

Manitowoc FS9000 Manual de usuario

Manitowoc

Manitowoc EC Series Manual de instrucciones y seguridad

Manitowoc

Manitowoc CrystalCraft Premier Manual de usuario

Manitowoc

Manitowoc S600M Manual de instrucciones y seguridad

Manitowoc

Manitowoc Indigo Guía de inicio rápido

Manitowoc

Manitowoc M-90 Instrucciones de uso

Manitowoc

Manitowoc P Series Manual del propietario

Manitowoc

Manitowoc S series Manual de usuario

Manitowoc

Manitowoc UDE065A Manual de usuario

Manitowoc

Manitowoc ECS018A Manual de usuario

Manuales populares de Máquina de hielo de otras marcas

Hoshizaki

Hoshizaki KMD-460MWJ Manual de usuario

Sub-Zero

Sub-Zero 315I Instrucciones de uso

Unold

Unold 48945 Manual de usuario

Kenmore

Kenmore 2217402A Manual de usuario

Cornelius

Cornelius WM600 Instrucciones de funcionamiento

GE XPIO43SCSS Manual de usuario

Hoshizaki

Hoshizaki KMD-901MAH Manual de usuario

Whynter

Whynter FIM-450HA Manual de usuario

U-Line

U-Line UMCR014-SC01A Manual de instalación

Andrew James

Andrew James AJ000522 Manual de usuario

Scotsman

Scotsman CME1356 Manual de usuario

Scotsman

Scotsman ACM 25 Manual de usuario

Kärcher

Kärcher IP 120 Manual de usuario

U-Line

U-Line SS1095 Manual de usuario

Maytag

Maytag MIM1554WRS - Ice Maker Manual de usuario

Hoshizaki

Hoshizaki KM-630MAH Manual de usuario

Princess

Princess Yonanas Manual de usuario

Unold

Unold 48946 Manual de usuario