Manhattan 461825 Manual de usuario

Installation Instruction

Above Fireplace Pull Down TV Mount

INTRODUCTION：

Please read through these instructions completely to be sure you’re comfortable with this easy

install process. Also check yourTV owner’s manual to see if there are any special requirements

for mounting yourTV.

If you do not understand these instructions or have doubts about the safety of the installation,

assembly or use of this product, contact your Customer Service.

CAUTION: Avoid potential personal injuries and property damage!

●This product is designed for use in wood stud, solid concrete, and concrete block walls

- DO NOT install into drywall alone!!

●Make sure that mountingscrews are anchored into the center of the stud. Use a stud

finder to locate the edge of the wood stud, then draw stud center line in the middle

point of the edges.

●The wall must be capable of supporting five times the weight of the TV and mount combined.

●Do not use this product for any purpose not explicitly specified by manufacturer.

●Manufacturer is not responsible for damage or injury caused by incorrect assembly or use.

●The temperature at the front of the fireplace mantle must never exceed 45℃（113℉）

IMPORTANT SAFETY INSTRUCTIONS

TOOLS NEEDED FOR ASSEMBLY

Wood Stud Install

Concrete Install

Wrench Pencil Level Screw

driver Electric

Drill Socket

Wrench Stud

Finder Wood

Drill Bit Masonry

Drill Bit Hammer

(3/8 in.)

10 mm

(7/32 in.)

5.5 mm

Model

Display size

Minimum display weight

Maximum display weight

Minimum VESA size

Maximum VESA size

Swivel range

Tilt range

Rotation range

461825/461276

40"-70"

16.5 lbs

78 lbs

200 x 200 mm

600 x 400 mm

+/- 45°

+5°/-15°

+/- 6°

Mount your television conveniently

above your fireplace using this Above

Fireplace Mount.

The mount allows you to keep

the TV safely up and out of the way

when not in use, then you can pull

it down to eye level for comfortable

viewing

PART INCLUDED

WARNING:This product contains small items that could be a choking hazard if swallowed.

Before starting assembly, verify all parts are included and undamaged. If any

parts are missing or damaged, do not return the damaged item to your dealer;

contact Customer Service. Never use damaged parts!

NOTE: Not all hardware included will be used.

Parts for assembly

Hardware

02 03 04

06 M5x30mm x2

05 x2

07 M6 Nut x4

A M8x45mm x4

F 6mm washer x4

J ST6.3x55 Lag Bolts x4

K ￠6 washer x4

L Plastic wall Anchor x4

G 5mm washer x4 H ￠6 plastic spacer x4 I ￠8 plastic spacer x4

B M8x20mm x4 C M6x30mm x4 D M6x16mm x4 E M5x16mm x4

10 5mm Hex key x1 11 T Hex key x1

08 M6x12mm x2 09

￠6 washer x4

01 x1

02 x1 03 x2 04 x1

16 in.

ASSEMBLY

STEP 1.1: Attach Wall Plate to Wall ( Wood Stud Option )

CAUTION: Avoid potential personal injuries and property damage!

●Drywall covering the wall mustnot exceed 5/8 in.

●Minimum wood stud size: 2 x 4 in.or 38 x 89 mm. (1.5 x 3.5 in)

●Horizontal space between fasteners:16 in.

1: Locate your stud. Verify and mark the center of the stud by finding the stud edges using a pencil

and an edge-to-edge stud finder. ( fig 1.1 1.2 )

2: Drill pilot holes using a 3/16 in.diameter drill bit. ( fig 1.3 )

3: Install wall plate assembly using four lag bolts J K

and Washer . Tighten the lag bolts

J only

until they are pulled firmly against the wall plate assembly. Do not over tighten. Over tightening

can damage the screw, reducing it's holding power.

16 in.

(406 mm)

1.1 1.2

1.4

3 in

3/16 in

1.3

CAUTION: Avoid potential personal injury or property damage! All lag bolts MUST BE firmly

tightened to prevent unwanted movement of the wall plate assembly. Ensure the

wall plate is securely fastened to the wall before continuing on to the next step 2.

J K

CAUTION:

DO NOT

install into

drywall alone

STEP 1.2: Attach Wall Plate to Wall ( Solid Concrete or Concrete Block Option )

2.1 2.2

CAUTION: Avoid potential personal injuries and property damage!

●Mount the wall plate assembly directly onto theconcrete surface

●Minimum solid concrete thickness: 8in

●Minimum concrete block size: 8x 8 x 16 in.

1. Position the wall plate template on the wall at your desired height. Level the wall plate and mark

the hole locations. (fig 2.1)

2. Drill four pilot holes using a 3/8 in.diameter masonry drill bit. (fig 2.2)

IMPORTANT: Pilot holes must be drilled to a depth of 3 in. Never drill into the mortar

between blocks.

10mm

(3/8 in.)

75mm(3 in)

J K

2.3 2.4

3. LInsert four anchors .Be sure the anchors

are seated flush with the concrete surface.(fig 2.3)

4. Install wall plate assembly using four lag bolts and four washers . Tighten the lag bolts

only until they are pulled firmly against the wall plate assembly,but do not over tighten.

Over-tightening can damage the screw, reducing it's holding power. (fig 2.4)

STEP 2: Attach TV Bracket to TV

A B

F G

H I

C D E

4.1

4.Place a towel or blanket on a flat surface, then place your television face down on it Using the

two screws, attach the connecting rodto the bracket .

. (By 5mm hex key )(fig 3.2)

3.1 3.2

M6M5 M8

1.Select TV Screw Diameter

3.Attach the bracket to the back of the TV using the appropriate screws/washers (Flat Back) or

spacer/screw/washer (Round Back / Extra Space). (fig 3.1)

IMPORTANT: Ensure TV bracket is securely fastened before moving on to the next step.

2. Select TV Screw Length

Hand thread screws into the threaded

inserts on the back of your TV to determine

which screw diameter (M5, M6 or M8) to

use.

FLAT BACK ROUND BACK CABLESINSET HOLES

If your TV has a flat back AND you want your TV closer to the

wall, use the shorter screws.

Spacers and longer screws are supplied to accommodate:

● Round/irregular back TVs

● TVs with inset mounting holes

● Extra space needed for cables

Too Long

Too Short

Correct

CAUTION:

Verify adequate thread

engagement with your

screw/washer/spacer

combination AND

TV bracket

-Too short will not hold the TV.

-Too long will damage the TV.

STEP 3: Assemble Your Bracket

STEP 4: Hang TV onto Bracket

09 07

Assemble front panel onto TV bracket as illustrated. (fig 4.1)

Secure using four washer and four nut in the corner holes shown.

4.1

HEAVY! You may need assistance with this step.

Two people liftthe TV and hang the bracket

on the front panel

. Then use a Philips

screwdriver to tighten the two locking screws, which secures the bracket to the front panel

(fig 5.1)

Attach the wall plate cover 05 to the wall board.(fig 5.2)

5.2

5.1

TV ADJUSTMENTS

Adjust the spring pressure to balance the weight of the display so that it can be easily moved and will

maintain its position using either a ratchet wrench or the hex key

provided. (fig 6.1)

Tilt adjustment

Loosen the tilt lock knob on side, adjust the TV to desired view angle,then tighten the knob horizontal

level adjustment.

Slightly loosen the four nuts counterclockwise. Hold TV and gently turn to desired position. When level,

re-tighten the nuts to lockin the position. (fig 6.2)

6.1 6.2

knob

140°

+/- 6°

+/- 45°

+/- 18°

130mm

550mm

+5°

-15°

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Soporte de TV de Manhattan

Manhattan

Manhattan 461764 Manual de usuario

Manhattan

Manhattan 423786 Manual de usuario

Manhattan

Manhattan 423731 Manual de usuario

Manhattan

Manhattan 461825 Manual de usuario

Manhattan

Manhattan 461641 Manual de usuario

Manhattan

Manhattan 423717 Manual de usuario

Manhattan

Manhattan 423625 Manual de usuario

Manhattan

Manhattan 461672 Manual de usuario

Manhattan

Manhattan 461238 Manual de usuario

Manhattan

Manhattan 423748 Manual de usuario

Manhattan

Manhattan 462280 Manual de usuario

Manhattan

Manhattan 461238 Manual de usuario

Manhattan

Manhattan 461702 Manual de usuario

Manhattan

Manhattan 424752 Manual de usuario

Manhattan

Manhattan 423670 Manual de usuario

Manhattan

Manhattan 424691 Manual de usuario

Manhattan

Manhattan 461917 Manual de usuario

Manhattan

Manhattan 424691 Manual de usuario

Manhattan

Manhattan 462266 Manual de usuario

Manhattan

Manhattan 423625 Manual de usuario

Manhattan

Manhattan 423670 Manual de usuario

Manhattan

Manhattan 423625 Manual de usuario

Manhattan

Manhattan 461702 Manual de usuario

Manuales populares de Soporte de TV de otras marcas

Ergotron

Ergotron Neo Flex Cantilever UHD Manual de usuario

StarTech.com

StarTech.com FPCEILBTB Manual de usuario

VonHaus

VonHaus 05/038 Manual de usuario

Techlink

Techlink ECHO TV Manual de usuario

Sandstrom

Sandstrom SSTVMC12X Manual de usuario

Sony

Sony SU-WL700 Guía

ICW

ICW SCACC18 Manual de usuario

LG WM-L640V Manual de usuario

Gembird

Gembird WM-65ST-01 Manual de usuario

ERARD

ERARD FiTUP XXL 035320 Manual de usuario

PEERLESS

PEERLESS PLCK-1 Guía

Kanto

Kanto RCF180 Manual de usuario

GEM

GEM GEM GP001 Manual de usuario

Gladiator Joe

Gladiator Joe GJ0A0053 Manual de usuario

Vivotek

Vivotek AM-105 Manual de usuario

Vivo

Vivo VESA STAND-VAD1B Manual de usuario

AmazonBasics

AmazonBasics B07QG3LMG4 Manual de usuario

Secura

Secura QLF210 Manual de usuario