4
Product Guide
Touch RFID
Key Managed
AssignedUseFunctionality
ProgrammingInstructions
Add Manager Keys
Manager Keys can be programmed to the locks at any time.
1
2
3
4
Go to alock requiring additional
ManagerKeys.
Touch and hold
for 5 seconds
(a two-tone beep will be heard after
5seconds) thenrelease.
The LED will flash.
While the LED is flashing, insert
the Programming Key.
A two-tone beep will beheard.
While the LED is flashing, insert
each additional Manager Key one
at atime.
A two-tone beep will be heardfor
each Manager Key programmed.
Insert the Programming Key.
A two-tone beep will beheard
andthe LEDwillturn off.
Repeat above steps for each lock
or follow instructions to Express
Register Manager Keys to quickly
program multiple locks to operate
with the same Manager Keys.
Replace Keys
The locks must be reprogrammed to prevent the lost/stolen keys from operating a lock.
1
2
To replace the Programming Key:
Notetheorderorserialnumber(foundonthelock’srear).
Contact supplier to purchase a replacement ProgrammingKey.
1a
1b
2a
2b
To replace the Manager Keys:
Collect all remaining and replacement Manager Keys.
Go to any lock operated by the lost/stolen ManagerKeys. Touch and
hold
for 5 seconds (a two-tone beep will be heard after 5
seconds) then release.
The LED will flash.
While the LED is flashing, insert the Programming Key.
A two-tone beep will be heard.
Insert the Programming Key again.
Three sets of two-tone beeps will be heard and the LED will turn off. All
previously programmed Manager Keys will be erased.
Follow instructions to Add ManagerKeysto program the remaining and
replacement Manager Keys to the locks.
