Magnavox MHT983 Manual de usuario

FCC NOTICE:

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of

the following measures:

lReorient or relocate the receiving antenna.

lIncrease the separation between the equipment and receiver.

lConnect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

lConsult the dealer or an experienced radio/TV technician for help.

FCC STATEMENT:

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference

that may cause undesired operation. The antenna(s) used for this

transmitter must be installed to provide a separation distance of at least

20 cm from all persons and must not be co-located or operating in

conjunction with any other antenna or transmitter.

FCC WARNING:

To assure continued operation, follow the attached installation instructions and

use only shield cables when connecting to other devices. Changes or

modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

2ANH7-393MET1426

LOCATION OF CONTROL

SOURCE

LIGHT

VOLUME

LINE IN

STANDBY / AUXIN

DC IN

AUX IN

LINE IN

FRONT VIEW TOP VIEW

REAR VIEW

912 14

13 15

16 17 18

10 11

LOCATION OF CONTROLS

1. Loud Speakers with LED Decorative Lights

2. Subwoofer with LED Decorative Lights

3. Remote Sensor

4. Cradle (To hold Remote Control/External Audio Player/Cell Phone)

5. DJ Scratching Effect Knob

6. SOURCE Button

7. LIGHT On/Off Button

8. Standby On/Off Button

9. (Skip Backward) Button

10. (Play/Pause) Button

11. (Skip Forward) Button

12. (Bluetooth) Indicator

13. LINE IN Indicator

14. STANDBY/AUX IN Indicator

15. VOLUME +/- Buttons

16. DC 12V Jack

17. LINE IN (3.5mm Stereo) Jack

18. AUX IN (RCA) Jacks

LOCATION OF CONTROL (REMOTE CONTROL)

1. Standby On/OFF Button

2. SOURCE Button

3. (Volume Up) Button

4. (Skip Backward) Button

5. (Play/Pause) Button

6. (Skip Forward) Button

7. MUTE Button

8. (Volume Down) Button

9. LIGHT Button

SOURCE

LIGHT

MUTE

POWER SOURCE

POWER SOURCE (Remote Control)

DC IN

AUX IN

LINE IN

REAR VIEW

Connect the small plug from the supplied AC/DC Adaptor to the DC 12V Jack on the rear of

unit. Connect the AC/DC Adaptor into any convenient household outlet has AC 100-240V,

50/60Hz as illustrated below. The STANDBY/AUX IN Indicator on the top of unit will

illuminate.

Notes:

1. The AC Adaptor is intended to be correctly orientated in a vertical or floor mount position.

2. To save energy, unplug the AC/DC Adaptor from wall outlet if not using the unit for

extended periods.

In first time use, slide the insulation film from the battery tray and discard it as illustrated follows:

When the button cell is consumed, replace it as follows:

1. Push the tab on the battery tray and slide it out as illustrated below:

2. Install a new CR 2025 button cell to the battery tray as the polarity makings on the rear of

remote control cabinet.

3. Close the battery tray.

BATTERY PRECAUTIONS:

EFFECTIVE RANGE OF REMOTE TRANSMITTER

Follow these Battery Precaution when using a battery in this device:

1. Use only the size and type of battery specified.

2. Be sure to follow the correct polarity when installing the battery as indicated in the battery

compartment. A reversed battery may cause damage to the device.

3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old

batteries with fresh ones.

4. If the batteries in the device are consumed or the device is not to be used for a long

period of time, remove the batteries to prevent damage or injury from possible battery

leakage.

5. Do not try to recharge the battery not intended to be recharged; it can overheat and

rupture. (Follow battery manufacturer’s instructions.)

6. Do not dispose of battery in fire. Battery may explode or leak.

7. Clean the battery contacts and also those of the device prior to battery installation.

8. This product contains a coin/button cell battery. If the coin/button cell battery is

swallowed, it can cause severe internal burn in just 2 hours and can lead to death.

Keep new and used batteries away from children. If the battery compartment does not

close securely, stop using the product and keep it away from children.

If you think batteries might have been swallowed or placed inside any part of the body,

seek immediate medical attention.

The effective range of the remote transmitter is

16 Feet (5 Meter); +/- 30° as illustrated on right:

Notes:

1. When there is an obstacle between the unit

and the transmitter, the transmitter may not

operate.

2. When direct sunlight, an incandescent

lamp, fluorescent lamp or any other strong

light shines on the REMOTE SENSOR of

the unit, the unit remote operation may be

unstable.

Remote sensor

16 Feet (5 Meter)

SOURCE

LIGHT

MUTE

OPERATION

General Operation:

1. Connect the unit to AC power as previously instructed. The unit will enter to standby

mode and the STANDBY/AUX IN Indicator on the top of unit will illuminate.

2. Press the Button on the unit or Remote Control to power on the unit from standby

mode.

3. Press the SOURCE Button on the unit or Remote Control repeatedly to switch to desired

playback mode. The corresponding indicator will illuminate (or blink) with you selection

(see list below):

Playback Modes: Indicator:

BT (Bluetooth) Indicator will illuminate (and blink)

LINE IN LINE IN Indicator will illuminate

AUX IN STANDBY/AUX IN Indicator will illuminate and blink

4. During playback:

• Press the Volume +/- buttons on the unit or the +/- buttons on the Remote Control to

adjust volume level.

• Press the LIGHT Button on the unit or Remote Control to turn off the Decorative LED

Lights on the speakers. Press again to turn it on.

• Turn the DJ scratching Effect Knob to create DJ scratching effects.

• Press the MUTE Button on the Remote Control to mute the sound; press again to

turn it back.

5. When finished listening, press the Button on the unit or Remote Control to turn the

unit to standby mode. The STANDBY/AUX IN Indicator on the top of unit will illuminate.

NOTE:

For energy saving, if long period of time not using the unit. Unplug the AC/DC Adaptor

from wall outlet.

BT Mode:

BT (Bluetooth) pairing:

First time use or re-pairing the unit to a new BT Device, pair as follows:

1. Power on the unit and enter to BT mode as previously instructed, the Indicator on the

top of unit will illuminate and blink.

2. Power on the external BT Device and enter to BT searching mode. Start pairing following

the on screen instructions from the external BT Device. When paired, the Indicator will

stop blinking.

3. If pairing is complete you may now play music with your external BT Device.

4. During playback:

• Press the Button on the unit or Remote Control to pause; press again to resume

to normal playback.

• Press and release the or buttons on the unit or Remote Control repeatedly

to skip tracks.

• Press the Volume +/- buttons on the unit or the +/- buttons on the Remote Control to

adjust volume level.

• Press the LIGHT Button on the unit or Remote Control to turn off the Decorative LED

Lights on the speakers. Press again to turn it on.

• Turn the DJ Effect Knob to create DJ effects.

• Press the MUTE Button on the Remote Control to mute the sound; press again to

turn it back.

5. When finished listening, press the Button on the unit or Remote Control to turn the

unit to standby mode. The STANDBY/AUX IN Indicator on the top of unit will illuminate.

Notes:

• When the external BT Device searched the unit, our model number “MHT983” will

appear on the display of external BT Device.

• If while pairing you are asked for a code please try "0000" or "1234".

Normal operation after pairing:

1. Power on the external BT Device and enter to BT playback mode.

2. Power on the unit and enter to BT mode as previously instructed. The Indicator will

illuminate and blink.

3. Wait a few seconds until the unit is automatically paired to the external BT Device. The

Indicator will stop blinking.

4. After pairing is complete you may now play music with your external BT Device.

LINE IN:

Listen from an external Audio Player such as MP3 Player, Discman…etc.

1. In power off mode, connect one end of supplied Audio Connection Cable to the AUX

Out/Line Out/Phone Jack on the external Audio Player.

2. Connect the other end of the cable to the AUX IN Jack on the rear of unit as illustrated

below:

3. Power on the unit and enter to AUX IN mode as previously instructed, the LINE IN

Indicator on the top of unit will illuminate.

4. Play the music on the connected Audio Player as usual.

(Make sure the volume level of the connected Audio Player is turned to high level.)

5. When finished listening, press the Button on the unit or Remote Control to turn the

unit to standby mode. The STANDBY/AUX IN Indicator on the top of unit will illuminate.

AUX IN:

Listen from an external Audio/Video Player such as Television, DVD Player…etc.

1. In power off mode, connect one end of RCA Audio/Video Connection Cable (not includ-

ed) to the RCA Audio Out Jacks on the external Audio/Video Player.

2. Connect the other end of the cable to the AUX IN Jacks on the rear of unit as illustrated

below:

3. Power on the unit and enter to AUX IN mode as previously instructed, the STAND-

BY/AUX IN Indicator on the top of unit will illuminate and blink.

4. Play the music on the connected Audio/Video Player as usual.

(Make sure the volume level of the connected Audio Player is turned to high level.)

5. When finished listening, press the Button on the unit or Remote Control to turn the

unit to standby mode. The STANDBY/AUX IN Indicator on the top of unit will illuminate.

TO EARPHONE INPUT

DC IN

AUX IN

LINE IN

REAR VIEW

DC IN

AUX IN

LINE IN

REAR VIEW

OUT OUTPUT

Otros manuales para MHT983

Tabla de contenidos

Otros manuales de Oradores de Magnavox

Magnavox

Magnavox MSH318 Manual de usuario

Magnavox

Magnavox MSB5300 Manual de usuario

Magnavox

Magnavox SoundRing SB3700/37 Manual de usuario

Magnavox

Magnavox MSH315V Manual de usuario

Magnavox

Magnavox MMA3639 Manual de usuario

Magnavox

Magnavox MMA3623 Manual de usuario

Magnavox

Magnavox MMA3680 Manual de usuario

Magnavox

Magnavox MMA3717 Manual de usuario

Magnavox

Magnavox MSB2600 Manual de usuario

Magnavox

Magnavox MSB4560 Manual de usuario

Magnavox

Magnavox MMA3743 Manual de usuario

Magnavox

Magnavox MSH315V Manual de usuario

Magnavox

Magnavox MHT843n Manual de usuario

Magnavox

Magnavox MHT833 Manual de usuario

Magnavox

Magnavox MMA3627 Manual de usuario

Magnavox

Magnavox A1 8030 Manual de usuario

Magnavox

Magnavox MSB5305 Instrucciones de instalación

Magnavox

Magnavox Soundbar MSB4550 Manual de usuario

Magnavox

Magnavox MMA3628 Manual de usuario

Manuales populares de Oradores de otras marcas

argon audio

argon audio IE20 Manual de usuario

Denon

Denon SC-N7 Manual de usuario

Gemline

Gemline Ace 3952 Manual de usuario

Focal

Focal ON WALL 300 Manual de instrucciones

HEADRUSH

HEADRUSH Maximus HRSP 5024 Manual de usuario

SoundLogic

SoundLogic BCCS-6/6395 Manual de usuario

Peavey

Peavey DTH 218 Manual de usuario

Avantree

Avantree Pluto Air Manual de usuario

Morel

Morel Integra Series INTEGRA OVATION 4 Manual de usuario

Oppo

Oppo SONICA Manual de usuario

Bose

Bose SoundLink Wireless Music System Manual de usuario

Rocksteady

Rocksteady Stadium Manual de usuario

Bowers & Wilkins

Bowers & Wilkins 4 Manual de usuario

Sonance

Sonance SONOS OUTDOOR Series Manual de usuario

Electro-Voice

Electro-Voice EVID FM4.2 Manual de usuario

Pioneer

Pioneer XW-HTD630 Manual de usuario

Onn

Onn BWA16AA002 Manual de usuario

HP GL313AA - USB Speakers PC Multimedia Manual de usuario