Lumens MS-10 Manual de usuario
To download the latest version of Quick Start
Guide, multilingual user manual, software, or
driver, etc., please visit Lumens
https://www.MyLumens.com/support
MS-10
Meeting System
User Manual - English
[Important]
1
Table of Contents
Chapter 1 Package Contents.................................................................... 2
Chapter 2 Product Overview and Interface............................................. 3
2.1 I/O functions Introduction......................................................................................3
Chapter 3 Connection and Instruction for Installation........................... 4
3.1 How to connect..........................................................................................................4
3.2 Instruction for installation ......................................................................................4
3.3 Device Size...................................................................................................................6
3.4 Relative Operation Position....................................................................................6
Chapter 4 Introduction of Remote Control and Setting Menu ............... 7
4.1 Remote Control..........................................................................................................7
4.2 Setting Menu ..............................................................................................................8
Chapter 5 Descriptions of Major Functions............................................ 9
5.1 Control the Camera...................................................................................................9
5.2 Use Skype for Video Conference...........................................................................9
5.3 Save the current screen position data.................................................................9
5.4 Adjust the direction and position of the screen (ePTZ)..................................9
5.5 Use the Auto Frame ..................................................................................................9
Chapter 6 Output Resolution ................................................................. 10
Chapter 7 Troubleshooting .................................................................... 11
Chapter 8 Safety Instructions ................................................................ 12
Copyright Information.............................................................................. 13
2
Chapter 1 Package Contents
MS-10
Quick Installation Guide
Remote Control
Power Cord
Power Adapter
3 PIN to 2 PIN
Connector
Appearance may vary
depending on country/region
(For Japan only)
USB 3.0 Cable
(Type B-Type A)
L-shaped Sheet Metal
x2
TV Mount Bracket
x2
TV Mount Sheet Metal
x4
Screw (1/4”-20UNC)
x8
M6 Screw
x4
Quick Installation Guide
3
Chapter 2 Product Overview and Interface
2.1 I/O functions Introduction
2.1.1 Front Panel
2.1.2 Rear Panel
2.1.3 LED Status Ring Indicator Description
Indicator
Description
OFF
Unpowered/not connected to USB
Green
In standby mode
Red
Audio mute
Blue
In use
Green light increase/
decrease
Increase/decrease speaker volume
LED Status Ring
Built-in Microphone
Lens
Speaker
USB 3.0 Port
Network Port
Anti-theft Lock Slot
Tripod Mount Lock Hole
Power Supply
Tripod Mount Lock Hole
4
Chapter 3 Connection and Instruction for Installation
3.1 How to connect
USB NIC Function
MS-10 USB 3.0 port supports network interface card function. Connecting the MS-10 network port to
the router allows you to access the Internet without connecting an network cable on the computer
Please download the driver from Lumens website
https://www.MyLumens.com/support
Supported Operating System
OS
Supported Version
Windows
Windows XP/7/8: Manual installation
Windows 10: Built-in drivers
MAC OS X
10.8 or above
Linux
USB NIC Linux driver for Kernel up to 5.6
3.2 Instruction for installation
The recommended installation height is the horizontal position of the human eyes after sitting down to get the
best image
A. If the TV does not have a TV mount
➊Screw MS-10 to TV Mount brackets
➋Screw the TV Mount brackets to the TV
(A)
(B)
Tripod Mount Lock Hole
Tripod Mount Lock Hole
Power Supply
Router
USB 3.0 Cable
HDMI Cable
Anti-theft Lock Slot
Computer
Monitor
5
B. If the TV has a TV mount
➊Screw MS-10 to TV Mount brackets
➋Place the sheet metal of the TV Mount on/under the TV mount and fasten it to the TV Mount bracket
with screws from inside out
<Remark> If MS-10 is installed under the TV, fasten MS-10 to the L-shaped sheet metal before
proceeding with steps ➊➋
<Remark> Depending on the screw lock points of different TVs, the stainless steel bracket after
installation is as shown in Figure (C) or (D)
(C)
(D)
6
3.3 Device Size
Length x Width x Height: 602.25mm × 73.7mm × 94.01mm
Weight: 1.5 kg
3.4 Relative Operation Position
7
Chapter 4 Introduction of Remote Control and Setting Menu
4.1 Remote Control
No.
Function Descriptions
1
Enable/Mask Images
2
Enable/Disable Auto Frame
Enable: Displayed in the upper right corner of the
screen
Disable: Displayed in the upper right corner of the
screen
※4K resolution does not support Auto Frame
3
ePTZ: Screen moving direction
Setting Menu On: Select function
4
HOME/OK Button
ePTZ: Back to the wide angle
Setting Menu On: Confirm button
5
Increase/decrease speaker volume
Increase volume: Increment of green light on the
LED status ring
Decrease volume: Decrease of green light on the
LED status ring
6
Turn on/off the setting menu
7
Call/Set the preset
Short press: Call the preset 1~3
Press and hold: Save the preset 1~3
8
Mute/Unmute
Mute: LED status indicator shows red
Unmute: LED status indicator shows blue
Press and hold for 3 seconds to switch to:
Enable/disable noise reduction
Enable noise reduction: Displayed in the upper
right corner of the screen
Disable noise reduction: Displayed in the upper
right corner of the screen
9
Reserved button, no function
10
Zooming in/out the image
8
4.2 Setting Menu
1st Level
Major Items
2nd Level
Minor Items
3rd Level
Adjustment Values
Function Descriptions
Image
Auto Frame
On/Off
The camera can automatically detect
the position of the human body and
adjust the person to the center of the
screen according to the number of
people in the meeting scene to
present the best image
Brightness
0~A~14
Contrast
0~A~14
Hue
0~A~14
Saturation
0~A~14
Sharpness
0~A~15
Gamma
0~A~4
Gain
0~A~14
Anti Flicker
50Hz/60Hz
Backlight Comp
On/Off
System
Language
Chinese/English
Mirror
On/Off
Flip
On/Off
Expert Mode
On/Off
The identifier frame will appear after
enabling Auto Frame. It helps users
to know the current detection
precision and if there is any on-site
tracking issue caused by
environment interference
Detection Sens.
Low/Mid/High
Adjust the detection sensitivity of
Auto Frame
Factory Reset
Device Info.
Firmware Version
9
Chapter 5 Descriptions of Major Functions
5.1 Control the Camera
1. Use the remote control to control MS-10.
2. It can be controlled using “USB PTZ Camera Controller” software.
Please download software from the Lumens website and USB PTZ Camera Controller
Manual.
5.2 Use Skype for Video Conference
Please refer to Chapter 4 Installation and Connections to finish connecting the MS-10
and computer. Start Skype, select a contact, and press to start the video conference.
If it doesn’t work, please refer to the following steps to setup the camera:
1. Start Skype -> [Setting] -> [Audio & Video]
2. Select [Lumens MS-10 Camera]
3. Select Speaker/Microphone [Lumens MS-10 Speakphone]
After the setting is completed, the video conference is ready to begin.
<Remark> It can also be used with Zoom, Teams, Google Meet and other video software
5.3 Save the current screen position data
Press and hold the remote control number keys [1 ~ 3] to save the preset, and [Save OK]
will display in the upper right corner of the screen.
After saving, short press the number keys to call the preset.
5.4 Adjust the direction and position of the screen (ePTZ)
1. Confirm that the screen is Zoom+
2. Press [] or [] on the remote control to adjust the angle upward or downward.
3. Press [] or [] on the remote control to adjust the angle to the right or left.
5.5 Use the Auto Frame
Press [Auto Frame] on the remote control. The camera will automatically detect the
locations of people, and automatically adjust the zoom to the most appropriate size to
accommodate all the participants according to change of the conference venues and the
number of people.
Tabla de contenidos
Manuales populares de Sistema de altavoces de otras marcas
Sondpex
Sondpex Active Speaker System and Digital Music... Manual de usuario
JVC
JVC NX-PN7 Manual de usuario
Marshall Amplification
Marshall Amplification AR-DM61-BT Manual de usuario
Yamaha
Yamaha NX-A01 - Speaker Sys Manual de usuario
SE Audiotechnik
SE Audiotechnik I-LINE Manual de usuario
Gemini
Gemini WRX-843 Series Manual de usuario