Unpacking: Check the product carefully. If it has been damaged in transit, report the
damage immediately by calling your dealer and/or the shipping company that delivered it.
Read Instructions. All the safety and operating instructions should be read before the
product is operated.
Follow Instructions. All operating and use instructions should be followed.
Replacement Parts. When replacement parts are required, be sure the replacement parts
have the same characteristics as the original part. Unauthorized substitutions may cause
damage to the unit.
Introduction
The Lumapower MVP supports input voltage from 6.5V to 10V. The MVP is fitted with pure
white LED module driven by a constant current regulation circuitry to achieve a consistent
level of light output for the useable life of the batteries. With Over discharge protection at
4.8V and current control protection to enhance battery life and safety. LumaPower only
recommends the use of PCB protected batteries.
Combination Battery Type Pcs
1 Rechargeable 18650 (3.7V)
2
2 Rechargeable 17670 (3.7V)
2
3 Rechargeable 17650 (3.7V)
2
4 Rechargeable 16340 (3.7V)
2
(5) (Primary 123A (3.0V)
**SEE NOTE**
(4)
WARNING: Primary CR123A batteries are not intended to be a primary
battery source for the MVP and should only be used for
backup/emergencies. The 12V output of 4 primary CR123A’s and their
increasing resistance due to the high current load of the MVP means they
they can damage the light or become over-heated. As the current demand
is only problematic on the high output setting primary CR123A batteries
can be used with the light on the LOW and MEDIUM settings safely but if
used on the HIGH setting runtimes must be kept under 4 minutes or
damage will occur. LumaPower will not warrant lights that have failed due
to failure to follow these directions.
The MVP features a forward clicky switch and multi-level SideKick control circuit with memory
functions.
Half-press the tail switch to power on MVP momentary, full press to lock it for constant on.
Cycle press the SideKick to select output mode.
Convertible Design
The MVP can be operate with 2x16340 , (with Secondary battery tube removed).
Reflectors/LED engine module can be easily upgrade.
Lanyard ring is removable.
