LUCCI FUTURA ECO Guía

V2.1 Published on 11. 2016

LUCCI

FUTURA ECO DIMMABLE LED

CEILING FAN

INSTALLATION

OPERATION

MAINTENANCE

WARRANTY INFORMATION

CAUTION

READ INSTRUCTIONS CAREFULLY FOR SAFE

INSTALLATION AND FAN OPERATION.

Futura Eco Installation Instructions

1 | P a g e

THANK YOU FOR PURCHASING

Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read all

instructions before using the product and keep all instructions for future reference

SAFETY PRECAUTIONS

1. In Europe: This appliance can be used by children aged from 8 years and above and persons with reduced

physical, sensory or mental capabilities or lack of experience and knowledge if they have been given

supervision or instruction concerning the use of the appliance in a safe way and understand the hazards

involved. Cleaning and maintenance shall not be undertaken by children without supervision.

2. In Australia: The appliance is not intended for use by persons (including children) with reduced physical,

sensory or mental capabilities, or lack of experience and knowledge, unless they have been given

supervision or instruction concerning the use of the appliance by a person responsible for their safety.

3. Children should be supervised to ensure that they do not play with the appliance.

4. An all-pole disconnection switch must be incorporated into the fixed wiring, in accordance with local wiring

rules.

IN AUSTRALIA

WARNING:

FOR SAFE USE OF THIS FAN AN ALL-POLE DISCONNECTION

MUST BE INCORPORATED INTO THE FIXED WIRING IN

ACCORDANCE WITH THE WIRING RULES.

As outline in clause 7.12.2 of AS/NZS 60335-1 for meeting the minimum

electrical safety of this standard.

Please note warranty will be void if installation is without a means for an

all-pole disconnection incorporated in the fixed wiring in accordance with

the wiring rules.

Example: If a fan is connected to a circuit that can be isolated via an all-

pole safety switch at the switchboard, then this is considered to be an

all-pole disconnection to the ceiling fan electrical circuit, meeting the

requirements of clause 7.12.2 of AS/NZS 60335.1.

Futura Eco Installation Instructions

2 | P a g e

A single-pole switch also must be placed in the same room as the

fan as per local wiring regulations AS3000

5. Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities.

Contact your local government for information regarding the collection systems available. If electrical

appliances are disposed of in landfills or dumps, hazardous substances can leak into the ground water

and get into the food chain, damaging your health and well-being.

6. The structure to which the fan is to be mounted must be capable of supporting a weight of 40kg.

7. The fan should be mounted so that the blades are at least 2.3 m above the floor in Europe or 2.1 m above

the floor in Australia.

8. This fan is suitable for indoor and outdoor areas provided the fan is fully undercover with a minimum of 2

walls. The ceiling fan must be positioned in a location protected from water, wind, dust and salt. Exposure

to these elements will void the warranty. Mounting the fan in a situation where it is subject to water or

moisture is dangerous.

9. Only a licensed electrician should execute the installation.

Futura Eco Installation Instructions

3 | P a g e

BEFORE INSTALLATION

Unpack your ceiling fan carefully. Remove all parts and hardware. Examine all parts, you should have the

following:

Hanger bracket x 1

Remote receiver x 1

LED driver x 1

Pre-assembled fan motor, down rod and canopy cover x 1

LED light kit x 1

Blades x 4

Screw for hanger bracket x 2

Flat washer x 2

Spring washer x 2

Balancing kits x 1 set

Wall plugs for screw x 2

Motor screws for blades x 13

Remote hand set x 1 set

Fig. 1

Futura Eco Installation Instructions

4 | P a g e

INSTALLING THE MOUNTING BRACKET

•The ceiling fan must be installed in a location so that the blades are spaced 300mm from the tip of the blade to the

nearest objects or walls.

•Secure the hanging bracket to the ceiling joist or structure that is capable of carrying a load of at least 40kg, with

two long screws provided. Ensure at least 30mm of the screw is threaded into the support.

NOTE: The bracket screws provided are for use with wooden structures only. For structures other than wood,

the appropriate screw type MUST be used.

Angled ceiling Installation

This fan hanging system supports a maximum 20 degree angled

ceiling installation.

Fig. 2

Fig. 3

Futura Eco Installation Instructions

5 | P a g e

INSTALLING THE FAN

1. Carefully lift the fan and place the down rod ball assembly into the spacing allocated in the mounting bracket and

lock the ball into place. Insert the LED driver into the lower layer of the mounting bracket and then insert the remote

receiver into the top layer of the mounting bracket. Fig. 4

2. Refer to the wiring diagram provided for Electrical Connection/installation. Fig. 5

WARNING: To prevent electrical shock or risk of fire, do not attempt to perform the electrical connection wiring

yourself. All electrical connections must be carried out by a licensed electrician.

NOTE: An additional all pole disconnection switch must be included in the fixed wiring.

3. After completing the electrical wiring at the mounting bracket terminal and connecting the remote receiver power

input wires and fixed wiring via the 4-ports quick connectors (1); connect the LED driver power input wires and

remote receiver power output wires via the 2-ports quick connectors (2); connect the LED driver PWM signal input

wires and remote receiver PWM signal output wires via the 2-ports quick connectors (3); connect the remote receiver

fan output and motor input wires via the 4-ports quick connectors (4); also connect the LED driver output wires and

LED light wires via the 2-ports quick connectors (5). Fig. 5

4. Cover the mounting bracket with the canopy cover. Ensure all electrical wirings is tucked inside the canopy and that

it is not damaged during this step, and secure with screws. Fig. 6

Finally attach the canopy cover to the canopy screws by turning it clockwise. Fig. 6

Fig. 4

Fig. 5

Futura Eco Installation Instructions

6 | P a g e

5. Insert the blades through the side slot of the motor and align with the 3 holes. If the holes do not align, the blade is

upside down. The blade should fit securely and the screws should slot into the blade screw holes.

Insert the screw driver with screw through the key hole of the lamp bracket. Secure the blades with 3 blade screws.

Ensure all screws are tightened evenly to reduce the chance of warping or unbalancing. Repeat this process for all

blades. Fig. 7

6. Attach the LED light kit to the lamp base and connect wires to the LED light kit via the quick connectors. Insert the

housing assembly screws into the larger ends of key hole slots and turn the LED light kit body clockwise until the

housing assembly screws are firmly situated in the narrow ends of the keyhole slots. Fig. 8

Fig. 6

Fig. 7

Fig. 8

Futura Eco Installation Instructions

7 | P a g e

USING YOUR CEILING FAN

REMOTE CONTROL

Your ceiling fan is controlled via the remote control. There are 4 buttons (HI, MED, LOW, OFF) to control the fan speed

and one button to control light on/off and dimming function. Fig. 11

Before operating the remote, the following must be considered.

-2 x AAA 1.5V (size) batteries are required to operate the remote control. Remove the battery cover from the back

of the remote and insert 2 x AAA batteries. Ensure the polarities are correct as shown in the battery compartment.

(Batteries not included.)

-The remote (transmitter) and receiver must be configured so that communication between each other is paired

up. This is achieved by setting the DIP switch on the receiver and remote on the same setting.

Note: The DIP switch assembly has 4 switches which can be setup to 16 different transmitting code combinations.

This is practical when there is more than 1 remote/receiver pair operating locally or in the same room.

Note: To access the receiver DIP switches, remove the DIP switch cover.

Fig. 9 Remote battery compartment Fig. 10 Receiver DIP switch

OPERATING THE REMOTE:

Before you start using the remote, take the time to read through this section and get familiar with the buttons and function

of each button.

1. LED Indicator

The red LED indicator on the top of the transmitter will flash when the

buttons are active.

BUTTONS ON THE REMOTE

2. HI: Press the button to set fan running at High speed.

3. MED: Press the button to set fan running at Medium speed.

4. LOW: Press the button to set fan running at Low speed.

5. OFF: Press the button to turn OFF the fan.

6. : Press the button to turn ON/ OFF the light and press and hold

the button to access the light dimming function.

The remote has memory function. If the fan or light is turned off by the

isolating switch, it will memorise and recover the last status when turned on next.

Fig. 11

Futura Eco Installation Instructions

8 | P a g e

REVERSING SWITCH

Your ceiling fan can operate in either summer or winter mode.

SUMMER Mode: The reverse switch shall be in the “down” (SUMMER) position to make the fan rotate in an anticlockwise

direction. The airflow will be directed downwards, for cooling in summer.

WINTER Mode: The reverse switch shall be in the “up” (WINTER) position to make the fan rotate in a clockwise direction.

The airflow will be directed upwards assisting in the circulation of warm air, for energy conservation in winter.

Reverse Switch

AFTER INSTALLATION

WOBBLE:

NOTE: ceiling fans tend to move during operation due to the fact that they are mounted on a rubber grommet. If the fan

was mounted rigidly to the ceiling it would cause excessive vibration. Movement of a few centimetres is quite acceptable

and DOES NOT suggest any problem.

TO REDUCE THE FAN WOBBLE: please check that all screws which fix the mounting bracket and down rod are secure.

BALANCING KIT: A balancing kit is provided to balance the ceiling fan on initial installation. Please refer to the instruction

on how to use the balancing kit. The balancing kit can be used to assist re-balancing should the ceiling fan become un-

balanced again. Store your balancing kit away after installation for future use if required.

NOISE:

When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and frequency

signals superimposed in the electricity for off-peak hot water control, may cause a change in fan motor noise. This is

normal. Please allow a 24-hour “settling -in” period, most noises associated with a new fan disappear during this time.

The manufacturer’s warranty covers actual faults that may develop and NOT minor complaints such as hearing the motor

run –All electric motors are audible to some extent.

Fig. 12

Futura Eco Installation Instructions

9 | P a g e

CARE & CLEANING

Periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush or lint free cloth to avoid

scratching the paint finish. Please turn off electricity power when you do so.

Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and create the possibility

of an electrical shock.

The motor has a permanently lubricated ball bearing. There is no need to oil.

NOTE: Always turn OFF the power at the mains switch before attempting to clean your fan.

TECHNICAL INFORMATION

Futura ECO LED

SERIES models

Rated

Voltage

Rated

power

(motor)

Rated power lamp

Lamp type

48 inch blade fan only

220-240 VAC

60W

18W,LED Life time:

30,000H

LED Driver Model No.:

KLC-016-031A1

52 inch blade fan only

220-240 VAC

70W

18W, LED Life time:

30,000H

LED Driver Model No.:

KLC-016-031A1

Otros manuales para FUTURA ECO

Tabla de contenidos

Otros manuales de Admirador de LUCCI

LUCCI

LUCCI Airfusion Aria Manual de usuario

LUCCI

LUCCI NAUTICA Manual de usuario

LUCCI

LUCCI BREEZER SERIES Manual de usuario

LUCCI

LUCCI AIRFUSION BREEZE Manual de servicio

LUCCI

LUCCI AIRFUSION CLIMATE II LD52WH Manual de usuario

LUCCI

LUCCI AIRFUSION TURBO III Manual de usuario

LUCCI

LUCCI AIRFUSION COMMAND II Series Manual de usuario

LUCCI

LUCCI ATLANTA Guía de instalación

LUCCI

LUCCI FUTURA ECO SERIES Manual de usuario

LUCCI

LUCCI Futura 48 inch Manual de usuario

LUCCI

LUCCI AIRFUSION RESORT Manual de usuario

LUCCI

LUCCI ARRAY DC Manual de usuario

LUCCI

LUCCI GRENADA Series Guía de instalación

LUCCI

LUCCI AIRFUSION BREEZE Manual de usuario

LUCCI

LUCCI 200280 Manual de usuario

LUCCI

LUCCI Airfusion Penta Manual del propietario

LUCCI

LUCCI MXSQ8PW Guía de instalación

LUCCI

LUCCI Airfusion Aria Manual de servicio

LUCCI

LUCCI NEWPORT Guía de instalación

LUCCI

LUCCI Airfusion Radar Manual de usuario

LUCCI

LUCCI AIRFUSION CAROLINA Manual de usuario

LUCCI

LUCCI FIJIAN II Manual de usuario

LUCCI

LUCCI AIRFUSION AKMANI Manual del propietario

LUCCI

LUCCI FUTURA ECO Instrucciones de instalación y funcionamiento

Manuales populares de Admirador de otras marcas

ELTA FANS

ELTA FANS H03VV-F Manual de usuario

Hunter

Hunter 20714 Manual de instrucciones

Emerson

Emerson CARRERA VERANDA CF542ORB00 Manual de usuario

Hunter

Hunter Caraway Manual de instrucciones

Panasonic

Panasonic FV-15NLFS1 Manual de usuario

Kompernass

Kompernass KH 1150 Manual de usuario

VES

VES FALA100/12V/TR Manual de usuario

Vertiv

Vertiv Liebert DCD Manual de usuario

Westinghouse

Westinghouse GFP Series Manual de usuario

Venmar

Venmar KUBIX HRV PLUS Series Manual de usuario

Maico

Maico ECR 31 Manual de usuario

Sonnenkonig

Sonnenkonig Dinky Manual de usuario

S&P

S&P ECOWATT HXBR Manual de usuario

Wider

Wider IMP03369BH Manual de usuario

Panasonic

Panasonic F-60DHN Manual de usuario

Hinkley

Hinkley HIGHLAND Manual de usuario

Broan

Broan 766BN Manual de usuario

Premium

Premium PFS16022 Instrucciones de montaje