Lock'er Down 2018 Manual de usuario
Instructions for Model 2018
1. If you have a combination lock, it is easier to set the
combination before installing the safe.
2. Open console and remove the three screws in the floor of
console.
3. Place the front plate inside the console with the studs up but do
not attach fasteners.
4. Put the lid assembly in as shown in Fig 1, turn and pull up to top.
5. Install the flange nuts attaching the top to the front bracket to
hold the top in place.
6. With the lid open, place the back bracket to the top plate with
two flange nuts.
7. Insert the three provided screws to hold the front and rear
brackets to the console floor.
8. Now tighten the four flange nuts and you are done.
Enjoy your purchase.
Top Assembly Front Plate Rear Plate
See back for USB
Extension
installation.
1. Use the included tool to remove the USB receptacle.
2. Unplug the cable from the rear.
3. Plug the included extension cable into the vehicle harness and route it
Either inside the safe or outside, your preference.
Tabla de contenidos
Otros manuales de Seguro de Lock'er Down
Manuales populares de Seguro de otras marcas
Honeywell
Honeywell 2077D - 1.21 Cubic Foot Anti-Theft Safe Manual de usuario
Hornady
Hornady SnapSafe Trunk Safe II Manual de usuario
SPORTS AFIELD
SPORTS AFIELD SA-HD5-BIO Manual de usuario
Honeywell
Honeywell 5912 Manual de usuario
Phoenix
Phoenix FS1280F Manual de usuario
Phoenix
Phoenix SS0992K Hoja de información del producto
Technomax
Technomax Trony Series Manual
SPORTS AFIELD
SPORTS AFIELD INSTINCT BIOMETRIC Series Manual de usuario
RICHTER CZECH
RICHTER CZECH LA Manual de operación
Olymp
Olymp GOsafe 110 Manual de usuario
Phoenix
Phoenix SS0100E Hoja de información del producto
Clarke
Clarke Strong-Arm CS1000K Manual de instrucciones