5Instruction Manual
SECTION 4 - OPERATION OF THE SERIES AD9
The pump will always power up in the last used
see Sec. 5.1
NOTE:
If the power to the pump is cut less than 15
seconds after the last programmed values have
been set, the latest changes will NOT be stored
in nonvolatile memory. Allow at least 15 seconds
before disconnecting from power to ensure that
the latest changes are stored.
4.1 PUMP START/STOP
the
time the pump strokes, the
4.2 PUMP SPEED
hold the
hold the
4.3 PRIMING THE PUMP
down the
complete, push the
to the last used control mode.
Display Overview:
Icon/Alarm Area
Prime Stroke Rate
Stroke Length
Theoretical Flow
1. Icon/Alarm Area: The icon indicates the
pump is in prime mode. Depending on advanced
see Sec. 4.5
2. Stroke Length: The numeric stroke length
value indicates the current stroke length setting
3. Prime Stroke Rate: Indicates the stroke speed
4. Theoretical Flow: The theoretical flow
see Sec. 6.6 for calibration
information
NOTE:
The prime stroke rate is independent of the
current control mode stroke rate.
