Lighthouse Remote Series Manual de usuario
Lighthouse Worldwide Solutions
REMOTE 2014P, 3014P, 5014P Airborne Particle Counter
Gen C
Operating Manual
Copyright © 2011 by Lighthouse Worldwide Solutions. All rights reserved. No part of this
document may be reproduced by any means except as permitted in writing by Lighthouse
Worldwide Solutions.
The information contained herein constitutes valuable trade secrets of Lighthouse Worldwide
Solutions. You are not permitted to disclose or allow to be disclosed such information except as
permitted in writing by Lighthouse Worldwide Solutions.
The information contained herein is subject to change without notice. Lighthouse Worldwide
Solutions is not responsible for any damages arising out of your use of the LMS program.
REMOTE 2014P™, REMOTE 3014P™, REMOTE 5014P™ and LMS™ are trademarks of
Lighthouse Worldwide Solutions.
Microsoft®, Microsoft Windows™, and Excel™ are trademarks of Microsoft Corporation.
LWS PN 248083408-1 Rev 1
EU DECLARATION OF CONFORMITY
Manufacturer’s Name: Lighthouse Worldwide Solutions, Inc.
Manufacturer’s Address: Lighthouse Worldwide Solutions, Inc.
1221 Disk Drive
Medford, OR 97501 USA
Declares that the product:
Product Name: Remote Airborne Particle Counter
Model Number(s): REMOTE 2014P, 3014P, 5014P
Conforms to the following Product Specifications:
SAFETY EN61010-1:2001 Safety Requirements for Electrical Equipment for
Measurement, Control, and Laboratory Use Part 1:
General Requirements IEC 61010-1:2000
Safety Requirements for Electrical Equipment for
Measurement, Control and Laboratory Use, Part 1:
General Requirements
LASER SAFETY Guidance on Laser Products: Conforms to FDA 21 CFR
Chapter 1 Subchapter 1
EMC EN61326 Electrical Equipment for Measurement, Control and
Laboratory Use EMC Requirements Part 1: General
Requirements Includes Amendment A1:1998; IEC
61326:1997 + A1:1998
UL 61010A-1 - UL Standard for Safety Electrical Equipment for Laboratory Use; Part 1: General Requirements
Replaces UL 3101-1
Supplementary information
The product herewith complies with the requirements of the Low Voltage Directive 73/23/EEC amended by
Directive 93/68/EEC and the EMC Directive 89/336/EEC amended by Directive 93/68/EEC and carries the
CE marking accordingly.
Fremont, CA, May 15, 2007 William L. Shade – V.P. Engineering
00
248083408-1 Rev 1 t-i
Table of Contents
About this Manual
Text Conventions ........................................................................................................................... i
Additional Help .............................................................................................................................. i
Chapter 1 General Safety
Laser Safety Information ............................................................................................... 1-1
Chapter 2 Introduction
Overview ........................................................................................................................ 2-1
Description ..................................................................................................................... 2-1
Accessories .................................................................................................................... 2-2
Annual Calibration ......................................................................................................... 2-2
REMOTE 2014P Specifications .................................................................................... 2-3
REMOTE 3014P Specifications .................................................................................... 2-4
REMOTE 5014P Specifications .................................................................................... 2-5
Chapter 3 Unpacking, Inspecting and Installing
Initial Inspection ............................................................................................................ 3-1
Unpacking ...................................................................................................................... 3-1
Shipping Instructions ..................................................................................................... 3-2
Understanding the LEDs .................................................................................... 3-3
Connections ................................................................................................................... 3-4
Communication Ports ........................................................................................ 3-5
4-20mA Analog Inputs ...................................................................................... 3-6
Analog Sensors ...................................................................................... 3-6
DIP Switches ...................................................................................................... 3-7
Power ................................................................................................................. 3-7
Power Switch ..................................................................................................... 3-7
Remote Display Connector ................................................................................ 3-8
Peripheral Interface Connector .......................................................................... 3-8
USB Communications ....................................................................................... 3-8
Using the USB Port to connect to a PC ................................................. 3-9
Ethernet Configuration ................................................................................................ 3-10
Definitions of Terms Used ........................................................................................... 3-11
Preparing for Network Installation .............................................................................. 3-12
Lighthouse REMOTE 2014P, 3014P 5014P Operating Manual
t-ii 248083408-1 Rev 1
Equipment Required: ....................................................................................... 3-12
Software Required: .......................................................................................... 3-12
Additional Requirements: ................................................................................ 3-12
Configure Device ......................................................................................................... 3-13
Ethernet Port Configuration ............................................................................. 3-13
Straight-through Cat5 Setup: ............................................................... 3-13
Cross-over Cat5 Setup: ........................................................................ 3-13
Program the Interface ................................................................................................... 3-14
Windows Telnet Programming: ....................................................................... 3-14
Connect REMOTE P to Ethernet LAN ........................................................................ 3-19
Connect Ethernet Cable to Instrument ............................................................. 3-19
Data .............................................................................................................................. 3-19
Chapter 4 Programming
General Information ....................................................................................................... 4-1
DIP Switches .................................................................................................................. 4-1
DIP Switch Settings ....................................................................................................... 4-2
GENERAL DEFINITIONS ............................................................................... 4-2
Communications Mode .......................................................................... 4-2
REMOTE Display Mode ....................................................................... 4-2
Addressing ......................................................................................................... 4-3
Communicating with the Instrument ............................................................................. 4-4
RS-485 Port ........................................................................................................ 4-5
RS-485 Communications ................................................................................... 4-5
RS-232 Communications ................................................................................... 4-6
Configuring with REMOTE Display ............................................................................. 4-6
Configuring with the MODBUS Protocol ..................................................................... 4-6
Setting the Real Time Clock .............................................................................. 4-7
Changing the Default Instrument Parameters .................................................... 4-7
Running the Instrument ................................................................................................. 4-9
MANUAL Counting Mode .............................................................................. 4-10
AUTOMATIC Counting Mode ....................................................................... 4-10
Chapter 5 Maintenance Procedures
Safety ............................................................................................................................. 5-1
Calibration ..................................................................................................................... 5-1
Cleaning ......................................................................................................................... 5-1
Purge Test ...................................................................................................................... 5-1
Appendix A MODBUS Register Map v1.48
COMM Settings ............................................................................................................ A-1
Supported MODBUS Commands ................................................................................. A-1
Table of Contents
248083408-1 Rev 1 t-iii
Register Map ................................................................................................................. A-2
Sensor Settings Registers .................................................................................. A-2
Device Status .................................................................................................... A-7
Command Register ....................................................................................................... A-7
Data and Alarm Registers ............................................................................................. A-8
Data and Alarm Enable Registers ..................................................................... A-8
Enable Alarming for a Channel ...................................................................... A-10
Threshold Setup Registers .............................................................................. A-11
Setting the Alarm Threshold Value ................................................................ A-12
Data Registers ............................................................................................................. A-12
Device Status Word (30007 - 30008) ............................................................. A-14
Valid Data in Channels (30073 - 30076) ........................................................ A-15
Data Type Registers ........................................................................................ A-16
Data Units Registers ....................................................................................... A-17
Appendix B Zero Count Test
How to Run the Test ...................................................................................................... B-1
Appendix C Limited Warranty
Limitation Of Warranties: .................................................................................. C-1
Warranty Of Repairs After Initial Two (2) Year Warranty: .............................. C-1
Index
Lighthouse REMOTE 2014P, 3014P 5014P Operating Manual
t-iv 248083408-1 Rev 1
Este manual sirve para los siguientes modelos
3
Tabla de contenidos
Otros manuales de Equipo de laboratorio de Lighthouse
Manuales populares de Equipo de laboratorio de otras marcas
Agilent Technologies
Agilent Technologies 5800 ICP-OES Manual de usuario
Endress+Hauser
Endress+Hauser Cleanfit CPA875 Manual de usuario
NI
NI PXI-5422 Manual
Collomix
Collomix Aqix Manual de usuario
SPEX SamplePrep
SPEX SamplePrep 6875 Freezer/Mill Series Manual de usuario
Ocean Insight
Ocean Insight FLAME-NIR+ Manual de usuario
