Swing the bucket support frame down and insert the
ends of the cross brace into the cross brace sockets on
each side frame by depressing the push pins and
pushing until they click securely into place (C).
Commode Seat
Unfold frame (A) making
sure sides of frame are
at right angles to the
rear of the frame and
the open ends of the
Cross Brace Sockets are
facing the center of the
frame (B).
Insert the back brace into the back of the frame making sure push pins
click securely into place.
Attach commode seat by resting the groove at the rear of
commode seat on the rear cross brace and aligning the
grooves alongside the commode bucket with the side rails
on the bucket support frame. Then lower the front of the
commode seat onto the front cross brace and push down
until it snaps securely into place (D).
D
Insert the commode bucket from the rear.
5
5
Adjust height, if necessary, and remove the back brace. Then replace the commode bucket with the
splash guard.
Lift the toilet bowl seat and place the commode over the toilet centering the splash guard directly
over the toilet bowl. Then lower the commode seat for use.
Lifestyle Mobility Aids, Inc. is not liable for personal injury or property damage due to failure to follow the
instructions or recommendations in this manual or improper use of this product.
> If you don’t understand these instructions, contact your dealer or a health care provider for
assistance.
> If any parts are missing or damaged, contact your dealer for replacement. Do not substitute parts.
> Ensure Commode Seat is securely attached to frame and all legs are set at the same height before use.
> Users with limited physical strength will require assistance/supervision.
Adjustable legs
Non-slip tips
Padded arms OPERATING INSTRUCTIONS
USING AS A BEDSIDE COMMODE
USING COMMODE OVER TOILET
ADJUST LEG HEIGHT
Adjust the leg height by pushing the button and sliding the tube up or down. The height will
adjust one hole at a time. Ensure that all legs are adjusted to the same height.
SAFETY PRECAUTIONS
MAINTENANCE
Clean after each use with disinfectant.
> Do NOT use organic solvents, such as acetone or abrasive cleansers.
> Inspect weekly for wear and to ensure all components are secure. If any component appears worn or
is not working properly, contact your dealer for repair and/or appropriate replacement parts.
ASSEMBLY
WARRANTY
Limited Lifetime warranty against manufacturing defects.
This warranty does not cover product failure due to misuse, negligence, improper storage or handling, improper
operation or unauthorized modifications.
For Warranty Service, it is recommended but not required that the product be returned to the Lifestyle Mobility Aids
dealer through whom it was originally purchased. However, all Lifestyle Mobility Aids Dealers are qualified to assist
you in obtaining warranty service. If the product is to be returned to Lifestyle Mobility Aids, prior authorization will
be required. In the event of a defect covered by this warranty, Lifestyle Mobility Aids will determine if the product
will be repaired or replaced.
Lifestyle Mobility Aids product are identified by a serial or lot number label at the time of manufacture. Removing or
defacing the label may void this warranty. If you have questions about your Lifestyle Mobility Aids product or this
warranty, please contact us at contactus@lifestylemobilityaids.com.
Lift commode seat and place commode bucket on support rails. Make sure it is directly below the
opening. Then lower commode seat for use.
Place the lid on the commode bucket when not in use to contain odor and use the handle on commode
bucket to remove for cleaning.
DIAGRAM
