Life Smart SCS-P760G Manual de usuario
SMART J
PELLET SMOKER GRILL
G
2
TABLE OF CONTENTS
Package Contents ......................................................3
Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Specifications .........................................................5
Assembly Instructions ...................................................6
Troubleshooting ........................................................7
Initial Set Up Procedure .................................................9
Temperature Probe .....................................................9
Control Panel .........................................................10
Operating Instructions ..................................................10
Test Modes and Adjustments ............................................11
Performance Tips .....................................................12
Temperatures .........................................................13
Maintenance and Cleaning ..............................................13
Transport and Storage ..................................................13
Manual Start Up .......................................................14
One-Year Limited Warranty ..............................................15
4
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate, or install
the product.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: FOR OUTDOOR USE ONLY! Do not use in any enclosed area. Use only
on level surface away from overhanging easements.
• Do not touch hot surfaces. Use handles or knobs.
• To protect against electrical shock, do not immerse cord, plugs, or controller in water or any other
liquid.
• Close supervision is necessary when any appliance is used by or near children.
• Unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking
off parts.
• Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or
has been damaged in any manner.
• The use of accessory attachments not recommended by the appliance manufacturer may cause
injuries.
• Do not let cord hang over edge of table or counter, or touch hot surfaces.
• Extreme caution must be used when moving an appliance containing hot oil or other hot liquids.
• Do not use appliance for other than intended use.
• Use only with GFI (Ground Fault Interrupter) protected circuit.
• To prevent smoker from being splashed or falling into water, do not use smoker within 10 feet of a
pool, pond or other body of water.
• Keep smoker and electric controller dry and out of rain at all times.
• Unplug smoker when not in use and before moving.
• Never remove grounding plug or use with an adapter to two prongs.
• Keep electric plugs off ground and dry.
• Do not use water or other liquid spray to clean product without first unplugging electric controller
and removing heating element.
• Fuel, such as charcoal briquettes, is not to be used with appliance.
• Use only on properly grounded outlet.
• Leave a minimum of 60” circumference between grill, decks, houses or any combustible materials.
• Occasionally, your appliance should be checked for fire pot obstructions to make sure proper air
flow is maintained. See cleaning instructions in this manual for correct procedures.
• Use heat-resistant barbecue mitts or gloves when operating this unit. Long handled, non-plastic
utensils are also recommended.
• Do not touch cooking chamber or attempt to move your appliance while operating or while the grill
is hot. Make sure the fire is completely out and that the grill is completely cool before transporting.
• Before covering your grill, make sure that the grill has cooled completely.
• Never put your hand in the pellet hopper or attempt to service any grill part while it is plugged in.
FOR OUTDOOR USE ONLY
DO NOT STORE OR USE COMBUSTIBLE MATERIALS IN OR NEAR THIS APPLIANCE
TO PREVENT INJURY NEVER MOVE THE GRILL WHILE HO, UPRIGHT OR WITHOUT ASSISTANCE
NEVER STORE ANY GRILL IN A SMALL SPACE OR TRANSPORT IN A VEHICLE UNLESS COMPLETELY
COOL AND VERIFIED THAT THE FLAME IS EXTINGUISHED
LEAVE A MINIMUM OF 60” CIRCUMFERENCE BETWEEN GRILL, DECKS, HOUSES OR ANY COMBUS-
TIBLE MATERIALS
USE ON LEVEL GROUND AWAY FROM OVERHANGING ROOFS OR EAVES
SAVE THESE INSTRUCTIONS
250W(IGNITE); 50W(NORMAL WORK)
1. To attach the griddle to the pellet grill. Align the mounting brackets to the pre-drilled
holes on the pellet body and using the provided screws secure the brackets.
2. Secure the griddle to the pellet body by aligning the pregrilled holes to the bracket
and secure using the provided screws and washers.
7
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Grill will not light /
turn on
Power Make sure power is plugged into working GFCI
outlet, and outlet is not tripped.
Unplug grill and check for blown fuse; refer to con-
troller schematic on page 20.
Fuse Replace fuse manually and try again. Call Customer
Service if the problem persists
Igniter Remove cooking grate, flame deflector, and drip
pan; visually inspect fire pot and if after 10 minutes:
• Your pellets are feeding
• Your blower fan is running and your grill is still not
lighting;
Then your igniter rod may
Auger Motor Remove cooking grate, flame deflector, and drip
pan; visually inspect auger turning in the fire pot.
(Note: the auger turns very slowly). If auger is not
turning, you may have an obstruction in your hopper.
Clean out pellets and try again. If problem persists,
your auger motor may need to be
Control Board UNPLUG GRILL. Check to make sure the fuse is
intact and has not blown. Check for any loose wire
connections. If any wires have become detached,
refer to controller schematic on page 19.
Grill is smoking ex-
cessively/ smoke is
discolored
Pellet quality / age Inspect pellets; ensure that pellets are dry and have
not broken down into sawdust.
If problem persists, remove pellets from the hopper
and clean ash from your fire-pot, replace with fresh
dry pellets.
Excess ash in fire
pot
Check the burn pot for ash and clean as necessary
(Its advised to clean fire pot
Blower fan Unplug grill. Remove access panel; visually inspect
blower fan for any obstructions, loose connections,
bugs, etc.
Remove obstructions. Power grill on. If problem
persists, unplug grill. Spin fan manually for several
revolutions. Plug grill back in. If problem still per-
sists, your blower fan may need to be
Grill will not heat
up to or maintain
proper
Pellet quality / age Inspect pellets; ensure that pellets are dry and have
not broken down into sawdust.
If problem persists, remove pellets from the hopper
and clean ash from your fire-pot, replace with clean
dry pellets.
Insufficient airflow Check fire pot for any obstructions/ash
Excess ash in fire
pot
Check fire pot for ash and clear as necessary.
9
INITIAL SETUP PROCEDURE
For your first lighting, follow this Initial Setup Procedure.
1. Open the main lid and remove the cooking grate, drip pan and flame deflector. Make
sure all packing material has been removed.
2. Open the pellet hopper lid found on the left side of your grill and check for any foreign
objects.
3. Plug your Pellet Grill into the nearest 110 Volt-AC GFCI outlet.
Note: If your home does not have a GFCI outlet, you should have one installed by an elec-
trician.
4. Put no more than 1/2cup of pellets directly into the fire pot to provide fuel to burn
while auger tube self-primes.
5. Pour pellets into your grills pellet hopper.
6. Wash cooking grate with mild soap and water.
7. Reinstall the flame deflector, drip pan, cooking grate, and close lid.
Note: If you want to line your drip pan with foil for ease of cleanup, we recommend you do
this before your initial burn in. When lining drip pan, keep foil inside drip pan edges
and do not wrap around as this can restrict airflow.
8. Turn on your Pellet Grill by pressing the power button at the left of the panel Set tem-
perature to 400°F by setting the digital control.
9. Within a few minutes you will see smoke, and your grill will light.
10. Once the temperature is at 400°F, allow it to run for 1hour, this will provide a final
cure and remove any residue that may have accumulated during manufacturing and
shipping.
After this initial burn, your Pellet Grill is ready for cooking.
TEMPERATURE PROBE
1. Plug your temperature probes into the grills controller probe port
2. Feed probe through the probe port hole on the left side of grill cooking chamber. Insert
probes into thickest portion of meat for most accurate reading.
Unplugging probe and cleaning with damp cloth will prolong the life and accuracy of your
probe
Reinstalling rubber protector over the connection port connection on controller after each
cook will prolong the life and quality of your controller.
DO NOT FULLY SUBMERGE PROBE IN WATER OR WASH IN DISHWASHER
Tabla de contenidos
Otros manuales de Parrilla de Life Smart
Life Smart
Life Smart SCS-P380 Manual de usuario
Life Smart
Life Smart SCS-K24B Manual de uso y cuidado
Life Smart
Life Smart SCS-P1100 Manual de usuario
Life Smart
Life Smart SCS-K18AH Manual de uso y cuidado
Life Smart
Life Smart SCS-P760 Manual de usuario
Life Smart
Life Smart PACK N GO SCS-PK13 Manual de usuario
Life Smart
Life Smart SCS-CPO21 Manual de usuario
