LG LDF 7810WW Manual de usuario

_/° / i_

III IRL III"°

Dishwasher

MODEL : LDF7810WW/LDF7810BB/LDF7810ST

LDF7811WW/LDF7811BB /LDF7811ST

LDS5811WW/LDS5811BB/LDS5811ST

LDF6810WW/LDF6810BB /LDF6810ST

Please read this manual carefully.

Retain for future reference.

Ifyou havequestions,call 1-800-243-0000

orvisitour website at: http://www.lgservice.com

orhttp://us.lgservice.com

PART 1. SAFETY AND CAUTION ............................................................................................... 2

PART 2. DISHWASHER SPECIFICATIONS ................................................................................. 3

PART 3. TOOLS AND MATERIALS NEEDED ............................................................................. 4

PART 4. INSTALLATION INSTRUCTIONS ............................................................................ 5~11

IMPORTANT SAFETY INSTRUCTIONS

When installing and using your dishwasher, follow basic precautions, including the

following:

•Disconnect electrical power before you start !

• All electrical wiring and grounding should be done in accordance with national and local

codes.

• If electrical supply is damaged, it must only be replaced by the manufacturer or its service

agent or a similar qualified person in order to avoid a hazard.

• This dishwasher must be connected to a hot water supply between 120°F (49 °C)-149°F (65 °C).

This temperature range provides the best washing results and shortest cycle time.

Temperature should not exceed 149°F (65 °C) to prevent damage to dishes.

• This appliance must be positioned close to an electrical power supply.

• The appliance is to be connected to the water supply using new hoses. Old hoses should not

be reused.

GROUNDING INSTRUCTIONS

•For a permanently connected dishwasher:

This appliance must be connected to a grounded metal, permanent wiring system, or an

equipment-grounding conductor must be run with the circuit conductors and connected to the

equipment-grounding terminal or lead on the appliance.

Fully Integrated

LDF7810WW/BB/ST

LDF7811WW/BB/ST

LDF6810WW/BB/ST

• Power supply: 120V, 60Hz AC only

• Water Pressure: 20 - 120 psi

(140 - 830 kPa)

• Size: Fully /Semi (WxDxH):

23 7/8"x 24 5/8"x 33 7/8"

(606mm x 625mm x 860mm)

• Inlet Water Temperature:

120°F (49°C)

• Weight: 115 Ibs. (52kg, Fully-

Integrated), 110 Ibs. (50kg, Semi-

Integrated)

Specifications are subject to change

to improve performance.

The features on your dishwasher

may vary from the figure shown.

Semi Integrated

LDS5811WW/BB/ST

Product Dimension

1/5"(5mm)

Felt

(insulating

material)

may be

compressed

24-5/8"(625mm)

=20-3/8"(518mm) =

, 1

3-1/4"(83mm) Water supply hose, Drain hose

and Electric Cable

33-7/8"

(860mm)

Should be passed through by this area

1-3/8"(35mm)

ii i ii ii ii ii ii ii ii

ii i i

_ _ _, _ _ [i¸__i_i...._

[Seepage8 lor inslallalion delaill

INSTALL BRACKET WOOD SCREW

ELECTRICALCABLE

(Notprovided]

0 o©

FITTINGS

WATERSUPPLYTUBE ELBOW FORTUBE RUBBER

CONNECTOR PLUMBERS'

TAPE

TWIST-ON WIRE

AIR GAP CONNECTOR HOSE CLAMP STRAINRELIEF ELECTRICAL TAPE

STANDARD PHILLIPS

SCREWDRIVER SCREWDRIVER HOLE CUTTER ELECTRIC DRILL GLOVES

ADJUSTABLE

WRENCH TAPE MEASURE CUTTING KNIFE LEVEL

SAFETY GLASSES

TUBING CUTTER

NIPPER PLIERS WIRE STRIPPER

PREPARE CUPBOARD OPENING

This dishwasher is designed to fit a standard dishwasher opening as shown below.

Select a location as close to sink as possible for easy connections to water and drain lines.

The dishwasher should not be installed more than 10 ft. (3m) from the sink for proper

drainage.

If dishwasher is to be installed in a corner, a minimum of 2 in. (50mm) is required between

the dishwasher and an adjacent a wall.

To allow for proper clearance of plumbing and electrical measure a 4"x4" target area (figure

#1 ) on the side of the cabinet where the cabinet meets the back wall. Using a 2 1/2"

diameter hole saw drill a hole (in the target area) within 4" from the floor, and no more than

an 1 5/8" from the back wall. If there is a floor in the cabinet under the sink, it will also be

necessary to drill or cut through the floor to connect the water and drain under the sink.

Failure to cut this opening will result in the drain hose interfering with the rear wall not allowing

for flush mount installation.

figure #1 figure #2

Must have this opening (on either

side) to route plumbing and

electrical.

For FLUSH INSTALL, you may

remove the Cabinet brace inside of

• Ensure the floor under the dishwasher is at the same level as the rest of the room to

allow for any service requirements,

ii i ii ii ii ii ii ii ii

i i

ii i ii

PREPARE T HE ELECTRICAL W IRIN G

WARNINGS

For personal safety; remove house fuse or open circuit breaker before

insta!lation. Do not usean extension cord or adapter plug with this dishwasher,

Electrical and grounding connections must comply with the national electrical

code/provincial and municipal code and!or other local codes.

This appliance must be operated with correct voltage as shown in this manual and on the

rating plate, and connected to an individual, properly grounded branch circuit, protected by

time delay fuse. Wiring must be 3 wires including ground.

The wiring or cord should be in an accessible location adjacent to, and not behind the

dishwasher and within 4 ft. (1.2m) of the dishwasher side.

The wiring or cord must be grounded properly, if in doubt, have it checked by a qualified

electrician. No other appliance shall be connected to the same outlet by a double adapter

or similar plug.

The wiring or cord must be oriented as shown in Figure below.

Check the dishwasher for any damage before trying to install it.

Make sure Electrical line are oriented in the bottom channels as shown in the figure below.

If you find any damage to the dishwasher, Please contact your dealer or builder

immediately.

Electrical Cable

5 1/2- 6 114"(140- 160ram)

PREPARE THE WATER SUPPLY CONNECTION

1. This dishwasher must be con nected to a hot water supply between 120 °F(49 °C)- 149 °F(65 °C).

This temperature range provides the best washing results and shortest cycle time.

Temperature should not exceed 149°F(65 °C) to prevent damage to dishes.

2. When connecting the dishwasher water line, sealing tape or compound should be used to

avoid leaks.

3. When connecting the dishwasher water line, the house supply should be shut off.

4. The Water Supply Tube must be oriented in the bottom channels as shown in the figure below.

: Electrical Cable

8 1/4 - 9 1/4" (208 - 233mm)

PREPARE DISHWASHER

Don't pull handle.

Doing so can result in door distortion. Open door and grab body frame and top

front opening of tub.

ii i ii ii ii ii ii ii ii

i i

ii i ii

_xll i

REIVl0 VE L0 W ER C OV ER

•Remove two screws attaching lower cover

to dishwasher.

• Remove lower cover from base.

FITTING 90 ° ELBOW

• When fitting elbow into the inlet valve,

sealing tape or sealing compound should

be used to avoid water leaks.

• Install a 90 ° elbow onto the water valve.

SLIDEDISHWASHERINTOCABINET

• Slide the dishwasher into the cabinet opening

carefully.

• Make sure the drain hose inside the cabinet

is not kinked.

Drain Hose

Electrical

Cable

Water Supply Tube

LEVEL DISHWASHER

•Check that the dishwasher is level. (Fig. A)

Attach level on top front opening of tub from side to side

•Check that the dishwasher is plumb. (Fig. B)

Attach level on front side of cabinet

Fig. C

Fig. D

-It •Check that gap between door and tub is equal on both side's

(L, R) (Fig. C)

• If the dishwasher is not level or both side gap is not equal,

adjust four leveling feet up or down until dishwasher is level

and both side gap is equal. (Fig. D)

SECURE DISHWASHER TO THE COUNTERTOP

• Secure dishwasher to the countertop or the cabinet.

When the countertop is made of wood or will not be damaged by drilling, use Step 9-1.

When the countertop is made of granite, marble or others which could be damaged by

drilling, Use Step 9-2.

STEP 9-1

1. Locate the installation brackets in the slot

2. Bend the brackets to secure them to the

dishwasher tub

3. Secure the dishwasher to the countertop

with the screws provided through the

holes in the bracket

STEP 9-2

1. Remove the Plastic Bushing

2. Drive Wood Screw through the hole

(Install Bracket is located between tub

and side cabinet by manufacturer)

3. Reinstall Plastic Bushings.

9ii i ii ii ii ii ii ii ii

i i

ii i ii

_xll i

DRAIN LINE CONNECTION

1. If the end of the drain hose does not fit to the drain line, use an adapter (not supplied) that

must be resistant to heat and detergent and may be obtained from a plumbing shop.

2. There are 2 typical connections as shown in Fig. E & F.

(b There may be other options than shown here for connection of the drain hose. The drain

connection must meet local plumbing regulations.

(2) The S trap spigot must be drilled out cleanly and free of obstruction to its maximum

internal diameter, if used for drainage.

(3) To prevent syphoning, one of the following instruction methods must be followed:

Fig. E: Connection to Disposer or Waste Tee.

Sink

Drain Hose

Dishwasher

Min. 20" (508mm)

Min. 30" (770ram) __

Max. 40" (1000mm)

Fig. F: Connection to Air Gap.

Sink

Air Gap Dishwasher

Drain Hose

In case Fig. F, Cut off the

Drain Hose in a dotted line

• Follow local codes and

ordinances.

• Do not exceed 10 ft. (3m)

distance to drain.

• Do not connect drain lines from

other devices to the dishwasher

drain hose.

Otros manuales para LDF 7810WW

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Lavavajillas de LG

LG DFC612 Series Manual de usuario

LG SDWB24S3 Manual de usuario

LG LDF6920BB Manual de usuario

LG LDF9810ST - Fully Integrated 6 Wash Cycles... Manual de usuario

LG LDT779# series Manual de usuario

LG XD3 15 Series Manual de usuario

LG LDS6040ST Manual de usuario

LG LD-12AS1 Manual de usuario

LG DFC532 Series Manual de usuario

LG LDF 7811WW Manual de usuario

LG LDS4821WW - Full Console Dishwasher Manual de usuario

LG LDF6920WW Manual de usuario

LG LD1455W FCS2 Series Manual de usuario

LG LDS4821WW - Full Console Dishwasher Manual de usuario

LG LSDTS9882S Instrucciones de uso

LG D1420WF Manual de usuario

LG LDF8572ST Manual de usuario

LG LD-14AT 3 Manual de usuario

LG DB242 Series Manual de usuario

LG LDF8874ST Manual de usuario

LG LUDP899 Series Manual de usuario

LG KD-C705NW Manual de usuario

LG LDF7920 Manual de usuario

LG LDS 5811BB Manual de usuario

Manuales populares de Lavavajillas de otras marcas

Electrolux

Electrolux ESI5211LOX Manual de usuario

KitchenAid

KitchenAid KUDB230B Manual de usuario

Brandt

Brandt BDJ424DB Manual de usuario

Asko

Asko DSD767UXXL.AU Manual de usuario

Beko

Beko DFN26210W Manual de usuario

NEFF

NEFF S153ITX00E Hoja de especificaciones

Midea

Midea SV 4.45 wi Manual de usuario

Gorenje

Gorenje GV63214 Manual de usuario

Hotpoint

Hotpoint HDA1100ZWH Manual de servicio

Blomberg

Blomberg LDFN2240W Manual de usuario

AEG

AEG FFB83836PM Manual de usuario

Cylinda

Cylinda DM3220RFD Manual de usuario

Atag

Atag DW8214MB Manual de usuario

GE GLD8000 Series Manual de usuario

Siemens

Siemens SN23HI02KE Hoja de especificaciones

Omega

Omega ODW717X Manual de usuario

BORETTI

BORETTI BVW-683 Manual de usuario

Siemens

Siemens SN 56N591 Manual de usuario