LG VN150 Manual de usuario

- 1 -

User Manual

LG-VN150

- 2 -

Body-worn Operation

This device was tested for typical body-worn operations with the back of the phone kept 0.79

inches (2.0cm) from the body. To comply with FCC RF exposure requirements, a minimum

separation distance of 0.79 inches (2.0cm) must be maintained between the user’s body and the

back of the phone. Third-party belt-clips, holsters and similar accessories containing metallic

components should not be used. Body-worn accessories that cannot maintain 0.79 inch (2.0cm)

separation distance between the user’s body and the back of the phone, and have not been

tested for typical body-worn operations may not comply with FCC RF exposure limits and

should be avoided.

FCC Part 15 Class B Compliance

This device and its accessories comply with part 15 of FCC rules. Operation is subject to the

following two conditions: (1) This device and its accessories may not cause harmful interference,

and (2) this device and its accessories must accept any interference received, including

interference that cause undesired operation.

Part 15.21 statement

Changes or Modifications that are not expre ssly approved by the manufa cturer could void the

user's authority to operate the equipment.

Part 15.105 statement

This equipment has been tested and found to comply with the limits for a class B digital device,

pursuant to Part 15 of the FCC Rul es. These limits are de signed to pro vide reasonable

protection against harmful interference in a reside ntial installation. This equi pment generates

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference or televisio n reception, which can b e determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

- Consult the dealer or an experienced radio/TV technician for help.

- 3 -

Getting Started

Unlocking Your Phone

If your LG-VN150 received is in the Lock status, you may need to unlock it before making calls.

1. Press soft key Unlock.

2. Enter your four-digit lock code. For security purposes, the code will not be visible as you type.

Note: If you can’t recall your lock code, try using the last four digits of your Social Security number, the

last four digits of your Phone Number or 0000.

View of Phone

1. (PWR/END) Switch: Lets you power the phone on or off.

2. Antenna: Internal antenna provides optimum reception for 800 MHz & 1900 MHz frequencies.

3. Headset Jack: Provides connection for an optional headset.

4. Volume Control Keys: Adjust the Ring Volume in the Main Menu or the Voice Volume during a call.

The keys also scroll through mouths in the Calendar or pages in the Mini Browser.

5. OK: Lets you place a call, receive a call, end a call or select menu options.

6. : Lets you clear an entry or back-up in the menu.

7. Folder : Lets you answer or end calls.

Installing and Removing the Battery

To install the battery, insert the bottom of the battery into the opening on the back of the phone. Then,

push the battery down until the latch clicks.

To remove the battery, press down on the latch and remove the battery from the phone.

- 4 -

Turning Your Phone On and Off

To turn your phone on, push the On/Off Switch for 2 ~3 seconds. Your phone performs a short self-

test before letting you know it is operational.

If your phone does not turn on, make sure the battery is installed correctly and is adequately charged or

has external power (via the AC Adapter, Cigarette Lighter Adapter).

To turn your phone off, push the On/Off Switch for 2 ~3 seconds.

Main Menu

When your phone acquires Service, the Greeting (a banner of text), the current time and date and the

Main Menu are displayed. If you are in authorized cellular provider’s service area, you are ready to send

and receive calls.

Power Save Mode

When the phone is in an area without service for 15 minutes, it stops searching for service and enters into

the power Save Mode. When your phone activates this feature, Power Save is displayed on your screen.

The phone automatically checks for service periodically or you can check manually by pressing any key.

- 5 -

Menu Navigation

The Navigation Key lets you scroll circularly through menus quickly and easily.

As you navigate through a menu, the options are highlighted (Highlighted Test Example ) . Select an

option by highlighting it and pressing . The scroll bar at the right of the menu keeps track of your

position in the menu at all times.

For example, if you want to view your last incoming call:

1. From the Main Menu, select RECENT CALLS and press “2. Received“ (It may already be

highlighted.)

2. Press the OK Key down to highlight and press .

If you have received any calls, they are displayed on the screen.

- 6 -

Entering Characters Using the Keypad(T9)

To enter a letter, punctuation or number when creating Phone Book or Scheduler entries, press the

corresponding key until the desired character appears. By default, the first letter of a word is capitalized

and following letters are lowercase. Characters in the following order:

1 . ? , ‘ & - @ ( ) / ~PQRS7pqrs

ABC2abc2 TUV8tuv8

DEF3def3 WXYZ9wxyz9

GHI4ghi4 Next0

JKL5jkl5 Shift

M N O 6 m n o 6 Space

After a character is entered, the cursor automatically advances to the next space after two seconds. You

can also advance the cursor by pressing or entering a character not on the same key.

If you make a mistake, press “Left Navigation Key” to move the cursor left or [ ] to erase a character.

To clear the entire entry, press and hold [ ] for two seconds.

1 7PQRS

9WXYZ

8TUV

6MNO

3DEF

ABC

0Space

- 7 -

Display Icons

Display icons are the symbols your phone uses to communicate important information. They are as

follows:

ICON DESCRIPTION

Alarm

Battery

Antenna

In use

No service

Location On

E911 Only

Voice

Voice Privacy

Digital

Vibrate

Roaming

TTY

SSL

Ringer

Ringer off

Text + voice

1x Active Data

1x Dormant Data

- 8 -

Antenna

The antenna on your LG-VN150 provides maximum reception by extending of retracting it.

!!! WARNING – CHOKING HAZARD –ANTENNA MAY BECOME DISLODGED

Attempting to remove or repeated twisting of the antenna will loosen the materials securing it into

antenna. Once the antenna is loosened or removed, only an authorized service provider

Representative can restore the antenna’s original integrity. Do not attempt to remove or twist the

antenna.

Signal Strength

The quality of each call you make or receive depends on the signal strength on your area. The number of

bars in the Signal Strength icon informs you of the current strength. The more bars, the stronger the signal.

Battery Capacity

Your LG-VN150 is equipped with a Lithium Polymer battery. It allows you to recharge your battery

before it is fully drained. The battery provides approximately 360 minuets of continuous digital talk time

or approximately 160 hours of continuous digital standby time.

Note: Long backlight settings affect the battery’s talk and standby times.

When the battery reaches 5% of its capacity, the battery icon blinks. When there is about one minute of

talk time left, the phone sounds an audible alert every 30 seconds and then powers down.

If the battery’s charge is completely run down, it takes 2 to 3 hours to fully recharge. It is not necessary to

let the battery completely run down before recharging.

To charge your batteries, use only approved charging accessories.

3.25

- 9 -

Using the AC Adapter

To charge the battery, plug the AC Adapter into a standard wall outlet and connect it to the phone via the

I/O Connector on the bottom of the phone. Alternatively, you can place the phone in the charging cradle

provided with your phone and connect the AC Adapter to the back of the cradle.

The battery Charge Status icon flashes during charging. When the battery is fully charged, the battery icon

stops flashing.

Using Your Phone

Placing a Call

When the phone is turned on, check the Signal Strength icon to see of you are in a Service Area or

authorized PCS CDMA provider’s service area.

1. Open the Flip.

2. Enter the phone number and press [SEND].

☞Tip! When dialing long distance, it is not necessary to dial a “1” before the area code.

3. When you are finished with your call and press [END] . Unless you use headset while you are

calling, closing the Flip will also end the call.

Roaming With Your Phone

Your Phone is you can use it to make and receive calls in many places.

Setting Your Phone’s Mode

Your Phone allows you to control your ability to roam. (See “Set Mode”)

- 10 -

Calling Experience

When you use your phone on other PCS CDMA networks, your calling experience and call quality will be

quite similar to what you experience when making calls within the Network. Although certain calling

features may not be available, your phone calls are still private and secure.

Correcting Dialing Mistakes

To delete one digit at a time, press . To delete all digits, press and hold .

Redialing Last Outgoing Number

Press and hold [SEND] for 2 seconds.

Dialing Options (phone book – Not Functioning)

When you enter numbers in the Main Menu, dialing options are displayed. To display a Phone Book entry,

enter its entry number. To use the 4- Digit Dial option, enter the last four digits of a phone number in your

Phone Book.

To select an option, highlight it and press [OK] . (phone book – Not Functioning)

 Call – Dials the phone number.

 Roam Confirm – Reminds you that you are making a call on an. (See “Disabling Roam Confirm” )

 Roam Call – Dials the phone number using the current PCS CDMA or analog cellular network.

 Save – Saves the phone number in your Phone Book. (See “Saving a Phone Number” on the

following page.)

 Find – Displays phone numbers in your Phone Book that contain the entered numbers. (See “Finding

a Phone Number” )

 Hard Pause – Inserts a Hard Pause. (See “Dialing and Saving Phone Numbers With Pauses” )

Otros manuales para VN150

Tabla de contenidos

Manuales populares de Teléfono móvil de otras marcas

Zte

Zte BLADE A520 Manual de usuario

Nokia

Nokia Lumia 620 Manual de usuario

Blackbe;rry

Blackbe;rry KEYone Manual de usuario

Bea-fon

Bea-fon X5 Premium Manual de usuario

Blackbe;rry

Blackbe;rry 8707 Series Manual de usuario

Blackbe;rry

Blackbe;rry Storm Instrucciones de funcionamiento

LifeWatch

LifeWatch V Manual de usuario

Bea-fon

Bea-fon SILVER LINE SL860 Manual de usuario

IKI Mobile

IKI Mobile KF4.5i Manual de usuario

Hitech

Hitech HT-850 Manual de usuario

Yezz

Yezz Fashion F10 Manual de usuario

Point Mobile

Point Mobile PM60 Manual de usuario

Blackbe;rry

Blackbe;rry Q10 Manual de usuario

Blackbe;rry

Blackbe;rry Bold 9900 Manual de usuario

Blackbe;rry

Blackbe;rry STORM 9500 - VERSION 5.0 Manual de usuario

ISAFE MOBILE

ISAFE MOBILE IS655.2 Manual de usuario

Blackbe;rry

Blackbe;rry CURVE 8300 - SMARTPHONE Manual de usuario

Blackbe;rry

Blackbe;rry 8707 - VERSION 4.1 Manual de usuario