Lenoxx GTRBLACK Manual de usuario
The illustrations used in this manual are to illustrate the operation method and product
structure of the product. Where there is a small difference between the physical item and
the illustrations, please take the physical as the standard.
SAFETY INFORMATION AND WARNINGS:
1. Children using this product must be under the supervision of an adult at all times.
2. The ride-on is not to be used by persons with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction.
3. In the interests of safety, DO NOT use this product on public roads, near motor vehicles,
uneven ground, swimming pools or where there is water. Do not let children ride in the
street, anywhere dangerous including slopes with more than 10 degrees, next to bodies
of water and away from other obstacles. Use during day light hours or in an illuminated
area is advised to avoid accidents in the dark.
4. Do not drive on long or wet grass, mud, soft ground, gravel or sand.
5. Do not drive near anything flammable or explosive. Keep any hazardous chemicals out if
the drivers reach.
6. Do not immerse the ride-on or charger n water.
7. Suitable for children aged 3+ years old. It is recommended that children always wear
shoes and other protective clothing and equipment (e.g.: helmet, gloves, kneepads etc.)
during use.
8. This car must only be used by a single child, maximum load is 25 kg. This is advisable to
avoid damage to the motor, gears and to prohibit overloading.
9. When the ride-on is running, do not place anything on the moving parts such as the
motor, gear box, wheels or steering wheel.
10. Please keep the product and all parts away from children before full assembly has been
completed by a responsible adult.
11. These instructions contain important information, please retain them after product
assembly.
12. Assembly of the ride-on must be completed by an adult.
13. To avoid suffocation or choking, keep all bags and small parts away from babies and
children.
14. Never push or pull the ride-on backward when it is running.
15. Do not charge the ride-on with a broken or damaged charger. Please call 1300 666 848
to order a replacement charger.
16. Any repairs to the ride-on must be carried out by an authorised or qualified service
centre/repairer.
BATTERY CAUTIONS:
The battery must be charged only by adult .Please charge the product before use.
If the ride-on will not be used for a long period of time (3 months or longer), it is advised
that you fully charge the battery and disconnect it from the connections.
A long period of non-use will damage the battery. It is advised that the battery should be
charged once a month, even if the ride-on is not being used.
A new battery must be fully charged before its first use.
Please take care with the battery as it contains acid electrolyte. Handling of the battery by
adults only.
If the battery has leaked, do not touch the acid. Place the battery into a polybag and dispose
of it.
If the electrolyte splashes on your skin or into your eyes, immediately wash with water for
at least 15 minutes and consult your doctor.
Do not contact the batteries two terminals with any other metal objects.
It will cause short circuiting, damage or fire.
Do not plug the charger into any non‐working or faulty wall socket. This could cause short
circuiting or fire.
CAUTIONS FOR CHARGING:
The ride-on is equipped with a charge protection function. Ensure that the power switch
on the car is in the OFF position before charging.
When charging the ride-on, all the functions of the ride-on are not operational.
1. The charging time is 8 –12 hours. Avoid intermittent charging as that can affect the
battery life.
2. Do not charge the battery for over 20 hours to avoid overheating the charger.
3. When charging, connect the chargers pin to the charging socket of the ride-on and plug
the charger into a 240v power point.
4. During the charging process, the heating of the charger or battery is normal (below 60
degrees Celsius).
5. A new battery must be fully charged before its first use.
6. Ensure the charger is removed from the charging socket before the ride-on is used.
7. Ensure the charger is not damaged. If the charge lead, plug or casing is damaged, do not
use the charger.
The POWER SWITCH must be in the OFF position when charging.
1. Find the charging input socket below the seat.
2. Plug the charger port into the input socket.
3. Plug the charger plug into a wall outlet. The battery will begin charging.
4. Charger must be removed from the ride-on’s charging socket before it is used.
Location of the charging socket:
Just below the seat on the right hand side.
PARTS LIST:
Item
Name
Picture
Qty.
Note
1
Car body
1
2
Windshield
1
3
Seat
1
Screw is on the seat
4
Gearbox
2
5
Wheel
4
Each wheel is the same
6
Spoiler
1
7
Steering wheel
1
8
Mirror
2
Left and right
9
M10 washer
6
Placed on the front and rear axel
10
M8 nut
4
Placed on the front and rear axel
11
M5x35 bolt and M5 nut
1
Used with the steering wheel
12
Wheel shaft cover
4
13
Charger
1
14
M4x12 screw
6
15
Wheel cover
4
16
Socket wrench
1
17
Aux in lead
1
18
Rear free wheels
2
PARTS DIAGRAM:
Assembly info:
The ride‐on requires assembly by an adult.
Children can be harmed by small parts, sharp edges and sharp points on
The ride‐on’s unassembled state.
Care should be taken in unpacking and assembly of the ride‐on.
Children should not handle parts or help in assembly of the ride‐on.
Please identify all parts before assembly and save all packaging material
until assembly is complete to ensure that no parts are discarded.
INSTALLING THE REAR FREE WHEELS:
Optional. An added set of wheels for increased
stability.
Turn the car upside down.
Remove the M4X12mm screw that has been fixed
to the car body.
Install the rear free wheels. Then fix with the
M4X12mm screws.
INSTALLING THE REAR WHEELS:
Install drive motor on the rear axle.
Load a wheel on the rear axle.
Load a M10 washer on the rear axle.
Load a M8 nut on the rear axle.
Tighten the nut with the socket wrench.
Add a wheel shaft cover.
Repeat on the other side.
INSTALLING THE FRONT WHEELS:
Load a M10 washer on the front axle.
Load a wheel on the front axle.
Load another M10 washer on the front axle.
Add a M8 nut to the front axle.
Tighten the nut with the socket wrench.
Add a wheel shaft cover.
Repeat on the other side.
CONNECT THE POWER PLUG, UNDER THE SEAT:
Connect the plug before installing the
seat.
Ensure the black wire is connected to
the black terminal on the battery.
Ensure the red wire is connected on
the red terminal on the battery.
INSTALLING THE SPOILER AND SEAT:
Remove the M4X12mm screws that has been
fixed to the car body.
Fit the spoiler into position.
Use the M4X12mm screws to secure the spoiler
in place.
The rear of the seat hooks into the body of the
car.
Use 2 x M4X12 screws on the seat to secure the
seat into position.
INSTALLING THE WINDSHIELD:
Clip the windshield into the ride‐on’s body.
INSTALLING THE STEERING WHEEL:
Connect the lead from the steering wheel to the
corresponding connection from the body of the
ride‐on.
Insert the steering wheel into the end of the
direction bar.
Align the hole on the steering wheel with the
hole on the direction bar.
Insert the M5x35 bolt and secure it with the M5 nut.
INSTALLING THE REAR VIEW MIRRORS:
Insert the hook on the mirror into the holes on both
Sides of the body.
Repeat for the other mirror.
OPERATION INSTRUCTIONS:
After assembly and charging:
Ensure the charger is removed from the charging socket on the ride‐on.
1. Put the power switch into the on position.
2. Press the forward/reverse switch to the forward position, then press the pedal, the
ride‐on will drive forwards.
3. To stop, remove foot from the pedal to stop the ride‐on.
4. Press the forward/reverse switch to the reverse position, then press the pedal, the
ride‐on will drive backwards.
Use the horn and music buttons on the steering wheel for sound.
Press the power switch to turn off the ride‐on.
HOW TO USE THE MP3 PLAYBACK PANEL:
1. USB slot: insert a USB stick to playback MP3 files.
2. TF card slot: insert a TF memory card to playback MP3 files.
3. AUX in: Use the AUX in lead to connect to a device with an earphone socket (eg: MP3
player) to playback MP3 files.
4. PREV/ VOL ‐ button: press the button once to go back to the previous music track.
Press and hold the button to reduce volume of music playback.
5. Pause button: Press once to pause music playback, press again to resume music
playback.
6. NEXT/VOL + button: press the button once to go to the next music track.
Press and hold the button to increase volume of music playback.
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Coche de juguete motorizado de Lenoxx
