LENCO DF-831 Manual de usuario

DF-831

8” Digital photo frame

User manual

For information and support, www.lenco.eu

1. Getting started: Checking the appearance:

2. Understanding interface and on-board buttons:

(1). Menu

／

Back;

(2) .

Confirm

(3) . Down;

(4) . Up;

(5) . Right.

(6) . Left;

(7) .

On/Off

;

⑻

. mini USB port

(9). USB port;

(10). SD/MMC reader

(11). Sockets for AC power adaptor;

(12). Frame stand port

Sensor for remote control

3. Installing and recharging your unit:

Open the package and remove the protective sleeve from the unit. Screw in the stand

to the stand screw hole on the back of the photo frame, Adjust the frame position for

vertical or horizontal placement, Plug in the AC adapter into power outlet. Plug the

other end into the unit. Insert your memory card and the unit starts the slideshow digital

photos automatically.

4. Understanding the remote:

Understanding the MENU:

1. Function Navigation

Power on the unit, the unit will display the following menu if there is no card inserted.

Figure 1

You can use the function navigation above to change all aspects of your photo frame from the

transitions sytle of your slideshows to the colour balance of the display. To bring up the menu on

screen just press the MENU button on board or the ESC button on the remote to go to the above

interface.

1. Power On / OFF

2. Clock

3. Calendar

4. Go up

5. Go Left / Previous Picture

6. Confirm

7. Go Right

8. Zoom in/out

9. Go Down

10. Rotate

11. Exit / go to previous menu

12. Slideshow

13. Setup

2. Playing photos

Figure 2 Figure 3

You can slideshow the photos one by one(Figure 2), or display in thumbnail mode(Figure 3)

3. Select the media source

Figure 4 Figure 5

Select “Device” to show the media source, there are 3 media sources including internal

memory, SD card and USB drive (Figure 5). If both of SD card and USB drive are

inserted, please select the media source first.

4. Display Clock / Calendar

Figure 6 Figure 7

Select “Calendar” from the function navigation menu shown in Figure 1, the calendar &

clock window will be displayed, the frame can display a sub window to slideshow

photos as shown in Figure 6, or you can bring up a analogue clock to the screen as

shown under Figure 7.

5. System setup

To enable some customized features, please configure the frame via system setup as

below:

a. Photo Setup

Figure 8

Under “Photo Setup”, you can configure Display model, Display Ratio, Slideshow

Interval, slideshow repeat as well as transition effect. Navigate with Left / Right button

to change the options, use Up/Down to switch between menus.

b. Calendar Setup

Figure 9

As shown in Figure 9, you can configure Display mode(Analog Colck, Digital Clock),

set the right date,

Change the clock mode from 24hr to 12hr or vice versa, change the current time

settings. Navigate with Left / Right button to change the options, use Up/Down to

increase/decrease the numbers.

c. System setup

Figure 10 Figure 11

(1). Language

As show in Figure 10, select language menu, you can change the language with

left/right buttons.

(2). Auto power On/Off

To enable power on/off, firstly, please select “On” to enable power On/ Power Off, as

shown respectively in Figure 10 & Figure 11; then set time for auto power on/power off.

Use left/right or Up/Down buttons to change the numbers and menus.

(3). Reset to factory default

Figure 12

The factory default settings include the optimized configurations for consumers, in case

that there is any malfunction or some features can not function as expected, it is highly

recommended to restor to factory default (Figure 12), select “Default” then select Yes,

all the changed settings will be restored to factory default.

Trouble-shooting:

Symptom Cause Corrective Actions

Digital Picture Frame

doesn’t power on

The POWER connector to

the unit is not securely

inserted.

Make sure you connect the AC

adapter to the frame properly and

make sure you have powered on the

unit by using the On/Off button.

When you connect the AC adapter to

the frame and power up the unit,

even without a memory card, you

should see a blank screen. If you

don’t see the lit screen, check if the

power is connected to the Digital

Picture Frame and make sure it is

securely attached.

No Start-up screen Memory card is not

inserted correctly.

Insert a supported memory card

No photo on the

memory card

Card is wrongly inserted Verify if the way you inserted the

card is correct. Make sure the front

label of the memory card is facing

AWAY from you. Do not force the

memory card into the slot.

The File doesn’t play

Incompatible File Format Make sure there is at least one

supported photo file on the memory

card. Compatible Photo format:

JPEG

This symbol indicates that the relevant electrical product or battery

should not be disposed of as general household waste in Europe. To

ensure the correct waste treatment of the product and battery, please

dispose them in accordance to any applicable local laws of

requirement for disposal of electrical equipment or batteries. In so

doing, you will help to conserve natural resources and improve

standards of environmental protection in treatment and disposal of

electrical waste (Waste Electrical and Electronic Equipment Directive).

Tabla de contenidos

Otros manuales de Marco de fotos digital de LENCO

LENCO

LENCO DF-1320 Manual de usuario

LENCO

LENCO DF-1031 Manual de usuario

LENCO

LENCO DF-1520 Manual de usuario

LENCO

LENCO DPF-155 Manual de usuario

LENCO

LENCO DF 704 Manual de usuario

LENCO

LENCO DF-911 W Manual de usuario

LENCO

LENCO DF-706 Manual de usuario

LENCO

LENCO DPA-35 Manual de usuario

LENCO

LENCO DPA-35 Manual de usuario

LENCO

LENCO DF-703 Manual de usuario

LENCO

LENCO DPA-800 Manual de usuario

LENCO

LENCO DF-700 Manual de usuario

LENCO

LENCO DF-705 - V1.0 Manual de usuario

LENCO

LENCO DF-911B Manual de usuario

LENCO

LENCO DF-830 Manual de usuario

LENCO

LENCO DF-241 Manual de usuario

LENCO

LENCO DPA-24 Manual de usuario

LENCO

LENCO DF-1200 Manual de usuario

LENCO

LENCO DF-711 W Manual de usuario

LENCO

LENCO DF-711B Manual de usuario

LENCO

LENCO DF-1520 Manual de usuario

LENCO

LENCO DF-701 Manual de usuario

LENCO

LENCO DF-711B Manual de usuario

LENCO

LENCO DF-700 Manual de usuario

Manuales populares de Marco de fotos digital de otras marcas

NIX

NIX Advance X10G Manual de usuario

Nextar

Nextar N7S-100 Manual de usuario

Sungale

Sungale TD350A Manual de usuario

texet

texet DPF-830 Instrucciones de montaje

Philips

Philips SPF2017 Manual de usuario

Philips

Philips SPF1327 Manual de usuario

Philips

Philips SPF7010/10 Manual de usuario

Digital Spectrum

Digital Spectrum MemoryVue MV-1500 Manual de usuario

ViewSonic

ViewSonic VFM1042-52 Manual de usuario

YURAKU

YURAKU YUR.PHOTO 7B4C Manual de usuario

Denver

Denver PFF-710WHITE MK2 Manual de usuario

Pandigital

Pandigital PAN8000DWPCF1 Manual de usuario

Rekam

Rekam Deja View HD-850 Manual de usuario

Majestic

Majestic DF 918HD MP3 Manual de usuario

ViewSonic

ViewSonic DPF8-CAM Manual de usuario

Philips

Philips SPF2527 Manual de usuario

Digital Foci

Digital Foci Image Moments IMT-063 Manual de usuario

Nokia

Nokia SU-4 Manual de usuario