Manual of 2FE1-4ETH Protocol Converters Equipment
Chapter One Overall Introduction
1.1 Summary
2FE1-4ETH Interface Protocol Converters are capable to support four
network devices or other devices for remote centralized management. Remote
users can perform centralized management for 2FE1-4ETH series devices by
Telnet, WEB Server or centralized management software. It also can remotely
perform such actions like restart and upgrade the 2FE1-4ETH series devices;
The devices are widely used for remote management of devices room,
servers, routers and other key equipment in the situation of industrial control,
water treatment, radio and television, public facilities and unattended room
management.
1.2 Features of Equipment
Support 220V AC or 48V DC Power Input
Build in intelligent switch fabric, provide 4 fast Ethernet ports
Support packet length up to 2047 Bytes
Provide up to 2K MAC address entries
Support IEEE802.1Q VLAN
Support QinQ double tagging
Support HDLC/PPP-BCP(RFC3518)/GFP-F encapsulation when
1xE1 mode; GFP for 2xE1 mode.
Support E1 frame or un-frame application when select 1xE1 HDLC
mode
GFP-F encapsulation comply with ITU-T G.7041 standard
Support LCAS and VCAT function comply with G.7042 and G.7043
Provide statistics for each ports
Support Console or telnet CLI management
Support SNMP(v1/v2c) and Web management
Support software and firmware upgrade
Support E1 floated or connected to PGND by switch
75Ωand 120Ωimpedances are selected by switch
