LDL TECHNOLOGY COPYRIGHTS www.aimshop.com 8/8
You have to define a wheel position for each sensor, from 4 to 32 sensors.
The different positions FL: Front Left N° 1 / 2 / 3 / 4
RL : Rear Left N° 1 / 2 / 3 / 4
FR : Front Right N° 1 / 2 / 3 / 4
RR : Rear Right N° 1 / 2 / 3 / 4
The positions will appear on the following order it is to say that the display has been parameter to learned by set of
4 wheels : FL1 (Front Left 1), RL1 (Rear Left 1), FR1 (Front Right 1) and RR 1 (Rear Right 1). It will then
automatically propose you the set n°2 : FL2, RL2, FR2 et RR2 and so on.
- To change and choose a different position short push on Bt2. To validate the position short push on Bt1.
- To change and choose the set number short push on Bt2. To validate your choice short push on Bt1.
Once the first ID is learned, the display returns to FIG 11 or 12.
Repeat this procedure for all sensors you have (up to 32).
Once you have learned all ID sensors, a short push on Bt1 enables you to see all ID learned, their position and their
set number.
To see the set 2 -> short push on Bt2 and so on for all sets.
To come back to the main menu, long push on Bt1
SUMMARY
1 –Note all your identifiers and attribute them a position on the vehicle
2 –Trig the sensor with force frame button
3 –Once the ID is received, check and validate the ID learning
4 –Choose the position and the set number
5 –Learn all ID sensors
6 –Go and see each set to check each ID position.
Be careful : When you change a wheel, you have to respect strictly the positions you attributed to this
wheel during the learning procedure. The display will then recognize automatically the wheel which was
changed and will show the right wheel information. If you have to invert one wheel –change rear right
wheel with front right wheel, you will have to do the learning again by using force frame button.
