1. Safety Instructions
•Read the product instruction manual before using this product.
•Do not put volatile, flammable, or explosive substances in the machine, as this could cause an explosion or
fire.
•Do not place the device in an area exposed to rain, moisture, or splashing, as this may result in electrical
leakage, short circuiting, or electric shock.
•Non-professional technicians must not disassemble, repair, or modify the equipment, as improper operation
may cause fire or electric shock to personnel.
•Do not damage the power plug or the power cord. If it becomes damaged, the power cord must be
replaced, otherwise it may cause fire or electric shock.
•This equipment should be installed on a firm ground, otherwise it could cause injury to personnel due to
equipment falling.
•Please use the designated power supply indicated on the nameplate. This equipment must be installed on
the ground to prevent electric shock and fire due to electrical leakage.
•Do not touch the power plug with wet hands, as there is a risk of electric shock.
•Before carrying out any repairs or maintenance, the power must be disconnected to prevent electric shock
or injury.
•Wear gloves when repairing or maintaining the equipment to prevent injury.
•Do not damage the power cord or use a non-specified power cord. Do not connect the power cord in the
middle section or use a long, flexible wire, as this may lead to electric shock or fire.
•Do not remove the power plug during operation or pull the power cord to unplug.
•If you notice the equipment running abnormally, unplug the power plug immediately and stop the
equipment.
•If the equipment will be idle for an extended period in an unsupervised area, ensure that the equipment
door is completely closed.
Other Necessary Considerations:
•Adjust the feet so that the equipment is installed horizontally, and all four feet should be in contact with the
support surface. There should be no gaps or imbalances.
•Use a separate power outlet fitted with a grounding wire. Tighten the power plug when in use.
•Turn off the power and unplug the power plug before removing the equipment.
•Only touch the inner wall of the door carefully as it may be hot.
•Non-professional technical staff should not disassemble the machine privately. Only professional staff should
repair and replace parts.
•The internal parameters must be set by a specific management person to prevent the controller program's
function from being disrupted by incorrect setting operations.
•The installation location of the equipment must be at least 20 cm away from the wall and other objects.
•Open or close the door gently. Forceful opening or closing of the door can easily damage the equipment.
•The surface of the equipment must not be exposed to volatile chemicals such as gasoline or thinner.
•Keep the inside and outside of the machine clean by regularly removing debris and smudges.
