Lazer3D LZX-15 Manual de usuario
LZX-15 User Manual
LAZER3D
PERFORMANCE SFF PC CASES
Lazer3D LZX-15 Instruction Manual
PAGE CONTENTS
1 Contents
2 Specification
3 Component List and Tips
4 Quick Assembly Reference
5 - 6 Main Panels Assembly
7 Corner Columns
8 - 10 Internal Frame Assembly
11 Front Case Fans
12 Support Rail Assembly
13 - 14 PSU + GPU Mounting
15 - 16 Storage Options
17 - 18 Case Cooling Options
19 Internal PSU Cable
20 Side Panels
21 Top Panel
22 Case Feet
23 - 24 Vertical Stand Assembly
25 - 26 Reference Diagrams
Page 1
LAZER3D
PERFORMANCE SFF PC CASES
Page 2
LAZER3D
PERFORMANCE SFF PC CASES
SPECIFICATION
WARNING: The case is not at full strength until fully built,
please take care when assembling.
WARNING: Do not over-tighten the screws when securing
the panels as this can reduce thread life.
NOTE:
Peel off protective film
from BOTH sides of
each panel before
assembling the case.
COMPONENT LIST
LAZER3D
PERFORMANCE SFF PC CASES
Page 3
Page 4
LAZER3D
PERFORMANCE SFF PC CASES
QUICK ASSEMBLY REFERENCE
PLEASE READ THESE INSTRUCTIONS
CAREFULLY BEFORE ASSEMBLING THE CASE
Page 5
LAZER3D
PERFORMANCE SFF PC CASES
1
Don’t forget to
insert your IO Shield!
Attach 2x metal blocks
to the rear panel with 2x
M3x8mm Screws
3
ASSEMBLY TIP:
Use a PH1 screwdriver with the M3x8 and M3x5 screws
2Attach I/O board
to rear panel with
2x M3x6mm
Screws
Page 6
LAZER3D
PERFORMANCE SFF PC CASES
Attach the rear panel to
the the base panel with 2x
M3x8mm Screws
4
Attach 3x metal blocks
to the base panel with 3x
M3x8mm Screws
Mount Power Button
to IO Panel
5
6
7
Attach IO Panel to Rear Panel
with 2x M3x8mm Screws
Page 7
LAZER3D
PERFORMANCE SFF PC CASES
8Attach the 2x Corner Pieces to the base
panel with 2x M3x8mm screws.
Orientate corners with
thicker edge facing the
front of the case
FRONT EDGE
CORNER COLUMNS
9
Page 8
LAZER3D
PERFORMANCE SFF PC CASES
INTERNAL FRAME SUPPORTS
For Mini-ITX motherboard layout at-
tach 4x metal blocks with 4x M3x8mm
Screws to these 4 support types in
these orientations
Mini-ITX Layout
Micro-ATX Layout
10a
10b For Micro-ATX attach 4x metal blocks
with 4x M3x8mm Screws to these 4
support types in these orientations
Page 9
LAZER3D
PERFORMANCE SFF PC CASES
12a
MINI-ITX LAYOUT
11a
TIP - Connect wiring for
power button and I/O
panel to your motheboard
Using 4 x M3x6mm screws mount
your motherboard (with CPU cooler,
RAM and memory pre-assembled) to
the base panel
Attach the 4
frame supports
to the base
panel with 4 x
M3x8mm screws
Otros manuales de Recinto de Lazer3D
