StarCore Debugger and Trace | 3
©1989-2022 Lauterbach
SYStem.Option.ICFLUSH Instruction cache flush before step/run 27
SYStem.Option.IMASKASM Disable interrupts while single stepping 27
SYStem.Option.IMASKHLL Disable interrupts while HLL single stepping 27
SYStem.Option.IPLDI Sets interrupt mask strategy 28
SYStem.Option.LittleEnd Switches between endian modes 28
SYStem.Option.MCKO Nexus output clock ratio 28
SYStem.Option.MPU MPU disabled 29
SYStem.Option.Nexus Nexus port width 29
SYStem.Option.OCEBASE Base address for OnCE registers 29
SYStem.Option.OCECORE OnCE selection 30
SYStem.Option.OVC Trace message overrun control 30
SYStem.Option.PTM Enables program trace messages 30
SYStem.Option.SAMPLE Adjust NEXUS sample point 31
SYStem.Option.SLOWPOLL Change timing of JTAG during runtime 31
SYStem.Option.SLOWRESET Expand reset time for additional reset module 31
SYStem.Option.VBA Set up VBA value for analysis 32
SYStem.Option.WaitReset Halt the core after reset 33
SYStem.Option.WATCHDOG Enable WATCHDOG 34
SYStem.JtagClock Define JTAG clock 34
CPU specific MMU Commands ........................................................................................ 38
MMU.DUMP Page wise display of MMU translation table 38
MMU.List Compact display of MMU translation table 38
MMU.SCAN Load MMU table from CPU 39
BenchMarkCounter ........................................................................................................... 40
TrOnchip ............................................................................................................................ 41
TrOnchip Control of on-chip resources 44
TrOnchip.CONVert Automatically convert range to single address 45
TrOnchip.REGister Shows custom on-chip trigger registers 45
TrOnchip.RESet Set on-chip trigger to default state 45
TrOnchip.VarCONVert Automatically convert range to single address 45
TrOnchip.state Opens configure panel 46
On-chip Trace .................................................................................................................... 47
Onchip.Mode Select mode to control trace buffer and contents 47
Onchip.VTBA Set the destination address of the onchip trace 48
General Restrictions ......................................................................................................... 49
Floating Point Formats ..................................................................................................... 50
Integer Access Keywords ................................................................................................. 50
File I/O Support .................................................................................................................. 51
Metrowerks MSLIO Support 51
JTAG Connection .............................................................................................................. 52
