Larson Electronics EPLC2-EMG-HB-150LED-RT Manual de usuario

EPLC2-EMG-HB-150LED-RT

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

1of 2

- EPLC2-EMG-HB-150LED-RT-

Instruction Manual

Do not attempt operation until you are familiar with all warnings, precautions, and procedures outlined within this

instruction sheet. Read carefully before operating. Retain these instructions for future reference.

WARNING:

This fixture is not factory sealed.

This fixture is designed to be used in a explosion proof environment.

Ensure periodic inspections to be sure that the fixture is still fully functional.

To avoid the risk of fire, explosion, or electric shock, this product should be installed, inspected, and maintained by a

qualified electrician only in accordance with all applicable electrical codes.

Be certain electrical power is OFF before and during installation and maintenance.

Luminaire must be connected to a wiring system with an equipment-grounding conductor.

Make sure the supply voltage is the same as the rated luminaire voltage.

The technical data indicated on the LED luminares are to be observed.

Changes of the design and modifications to the LED luminare are not permitted.

Observe the national electrical safety rules and regulations during installation.

Installing the EPLC2-EMG-HB-150LED-RT.

This EPLC2-EMG-HB-150LED-RTcomes preconfigured with a backup battery and two run configurations. The light can

be wired to accommodate Incoming Power while not emitting any visible light until the incoming power is stopped. IE:

Emergency Only Mode. However, the light also can be wired to provide visible light with or without incoming power. This

ensures that the light will operate in all conditions. IE: Backup Supported Mode

1. Emergency Only Mode Instructions –Wire the “Neutral”, “Hot”, and “Ground”wires normally. Leave the “Switch”

wire unconnected and terminated.

2. Backup Supported Mode –Wire the “Neutral”, “Hot”, and “Ground”wires normally. Wire the “Switch”wire in with

the “Hot”wire.

*For detailed instruction or clarification please call Larson Electronics at 1-800-369-6671.

EPLC2-EMG-HB-150LED-RT

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

2of 2

OPERATION

During normal operation, AC power is supplied to the AC ballast/driver through the backup micro inverter and the inverter

charges the battery. Connecting the inverter connector wires (red and white) enables the emergency circuit and supplies

power to the control/monitor circuit. The backup micro inverter detects AC input line voltage (120/277) and automatically

sets the output voltage during emergency mode.

When AC power fails, the backup micro inverter automatically switches to emergency mode, keeping the load illuminated

for a minimum of 90 minutes. When AC power is restored, the backup micro inverter returns to charging mode. The

backup micro inverter consists of a low-battery voltage disconnect which is reset when AC power is restored. The unit can

also detect an abnormal load condition (open or shorted load) during emergency mode operation and will protect the

inverter from damage.

MAINTENANCE

Although no routine maintenance is required to keep the backup micro inverter functional, it should be checked

periodically to ensure that it is working .The following schedule is recommended:

1. Visually inspect the charging indicator light monthly. It should be illuminated.

2. Test the emergency operation of the fixture at 30-day intervals for a minimum of 30 seconds. The lam p

should operate at full illumination.

3. Conduct a 90-minute discharge test once a year. The lamp should operate at full illumination f or at

least 90 minutes.

!!!! REFER ANY SERVICING INDICATED BY THESE CHECKS TO QUALIFIED PERSONNEL !!!!

REPLACEMENT PARTS

The EPLC2-EMG-HB-150LED-RTis designed to provide years of reliable lighting performance. Should the need

for replacement parts arise, please contact Larson Electronics at the contact information below.

Should further information not covered by these instructions be required, please contact Larson Electronics at

1-800-369-6671 or sales@larsonelectronics.com for further assistance.

Please visit LarsonElectronics.com for Warranty and Return information.

Tabla de contenidos

Otros manuales de Equipo de iluminación de Larson Electronics

Larson Electronics

Larson Electronics EPL-16BS-1X150LED-25 Manual

Larson Electronics

Larson Electronics WAL-TL-3XTL-C-SOL-100C Manual de usuario

Larson Electronics

Larson Electronics EXP-EMG-EXT-LE6-1L Manual de usuario

Larson Electronics

Larson Electronics LED10W-1X4LT Manual de usuario

Larson Electronics

Larson Electronics GL-9051-F-M Manual de usuario

Larson Electronics

Larson Electronics EXP-LED-1XB-9W Manual de usuario

Larson Electronics

Larson Electronics ORS-120-8M-4X150W-LED Manual de usuario

Larson Electronics

Larson Electronics LM-20-3S-EW-LV Manual de usuario

Larson Electronics

Larson Electronics EPLRL-50-16.4-HR-SWB Manual de usuario

Larson Electronics

Larson Electronics LEDB-4-IR Manual de usuario

Larson Electronics

Larson Electronics EPL-PM-150LED Manual

Larson Electronics

Larson Electronics IND-RL-HDB-BX9-120V Manual de usuario

Larson Electronics

Larson Electronics IND-AHF-CD-UVC-R1-220V-50C Manual de usuario

Larson Electronics

Larson Electronics GL-2051-F-M Manual de usuario

Larson Electronics

Larson Electronics GAU-PT-150LTL-LED-480V Manual de usuario

Larson Electronics

Larson Electronics GL-29000GB Manual de usuario

Larson Electronics

Larson Electronics EPL-SBDL-150RT-72 Manual de usuario

Larson Electronics

Larson Electronics EPL-TL-1X10W-C-PA-XFSW Manual de usuario

Larson Electronics

Larson Electronics LEDP5W-60XC-1227 Manual de usuario

Larson Electronics

Larson Electronics LED18W-PAR36 Manual de usuario

Larson Electronics

Larson Electronics LM Multi Stage Series Manual de usuario

Larson Electronics

Larson Electronics EPL-LB-50LED-RT-180B Manual de usuario

Larson Electronics

Larson Electronics ATX-EXPCMR-BP-HH-QXGA Manual de usuario

Larson Electronics

Larson Electronics GSLEDIP6-C1D2 Manual de usuario

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario