Larson Electronics EPL-MPM-150LED Manual

EPL-MPM-150LED

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

1of 2

EPL-MPM-150LED Instruction Guide

150 Watt Class 1 Div 1 Explosion Proof LED Light – Aluminum Base

Thank you for your purchase of the Larson Electronics EPL-MPM-150LED Portable Explosion Proof LED

Light. Please follow the steps below in order to operate and maintain this product.

IMPORTANT

READ CAREFULLY BEFORE OPERATING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE

REFERENCE. THE EPL-MPM-150LED MUST BE OPERATED IN ACCORDANCE WITH NATIONAL ELECTRICAL

CODE AND ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.

FOR PERSONAL SAFETY, ALWAYS CONFIRM THE RATING OF ANY KNOWN HAZARDOUS OR POTENTIALLY

HAZARDOUS LOCATION WHERE THE LIGHT IS TO BE USED.

WARNING: TO PREVENT IGNITION OF A HAZARDOUS ATMOSPHERE, THE SUPPLY CIRCUIT SHOULD BE

DISCONNECTED WHEN INSTALLING OR PERFORMING ANY MAINTENANCE ON THIS UNIT.

WARNING: WHEN INSTALLING THIS LIGHT IN HAZARDOUS LOCATIONS, CHECK THE OPERATING

TEMPERATURE LIMITS PRIOR TO INSTALLATION TO BE SURE IT CONFIRMS TO THE ENVIRONMENTAL

TEMPERATURE RESTRICTIONS AND NEC CLASSIFICATIONS. CHECK THE FIXTURE’S METAL NAMEPLATE FOR

TEMPERATURE (T) RATINGS.

WARNING: DO NOT SCRATCH OR CHIP THE FRONT LENS. TURN THE POWER OFF BEFORE STARTING

INSTALLATION OR REPAIR.

WARNING: OPERATE THIS FIXTURE ONLY AT THE VOLTAGE OF YOUR SPECIFIC SUPPLY CIRCUIT. FAILURE

TO DO SO WILL RESULT IN DAMAGE TO THE FIXTURE.

WARNING: SUBSTITUTE COMPONENTS MAY IMPAIR EXPLOSION PROOF SAFETY.

WARNING: THE BASE CONTAINS (4) 200LB. MAGNETS. PEOPLE WITH PACEMAKERS SHOULD CONSULT

THEIR PHYSICIAN(S) BEFORE USE. ELECTROMAGNETIC FIELDS IN CLOSE PROXIMITY TO HEART PACEMAKER

COULD CAUSE PACEMAKER INTERFERENCE OR PACEMAKER FAILURE.

OPERATING

Before operation, confirm that the power source will provide the correct voltage indicated on the product

nameplate. Ensure the receptacle will accept the cord cap attached to the light.

Check product nameplate for Ratings and Approvals.

Place the light in the desired location and run its power cord to a power source. Ensure all safety requirements

are followed for the hazardous area. Use the magnetic base for securing unit to metal

surfaces.

The light head can be adjusted by loosening the hand screws on each side, positioning the

light head and tightening the hand screws to hold the light in place.

This light is “instant-on” once plugged in to a live circuit.

AVOID DIRECT EYE EXPOSURE Do not look at the face of or directly into the light when plugging in or when

illuminated.

HAND SCREW

EPL-MPM-150LED

Larson Electronics, LLC Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com

2of 2

MAINTENANCE

It is recommended that you implement a standard monthly or more frequent preventive maintenance schedule.

Safety requires a thorough visual examination of the unit for physical damage that might cause a spark or

result in the ignition of hazardous atmospheres.

Maintenance includes a careful examination to ensure at least:

A. The Light Body is not cracked, broken or breeched.

B. The Lens is not cracked or chipped.

C. The Cable is not frayed and is gripping tightly in all points of cable contact.

D. The Cable Jacket is completely intact and that no internal conductors or conductor insulation

is exposed.

E. The Connection Box is not cracked, broken or breeched.

F. The Cord Plug is not cracked or damaged and the Ground Post is intact.

For your safety and to maximize the life of the light, avoid rough usage such as:

G. Pulling the Light by the Cable, which could weaken or damage the cable.

H. Impacting the lens with hard, sharp or heavy objects, which could cause the lens to scratch,

chip, crack, or shatter.

I. Disconnecting the Cord Plug from the receptacle by pulling on the Cable.

Keeping the light clean and free of material splatter, overspray, and debris during usage will ensure the

maximum life and luminosity of the light.

TROUBLESHOOTING

Refer to the guide below or contact the manufacturer if the fixture does not function properly.

Is the correct line voltage being supplied to the fixture?

Is the fixture properly grounded?

Make sure installed power switch is functioning properly (if applicable).

These instructions may not cover all details or variations of this product for your equipment or installation

requirements. Should further information not covered by these instructions be required, please contact Larson

Electronics at 1-800-369-6671 for further assistance.

Please visit LarsonElectronics.com for Warranty and Return information.

Tabla de contenidos

Otros manuales de Equipo de iluminación de Larson Electronics

Larson Electronics

Larson Electronics EPL-PM-150LED Manual

Larson Electronics

Larson Electronics MMLP-1MLED-12P Manual de usuario

Larson Electronics

Larson Electronics VPLHL-7WLED-PC-XGFI Manual de usuario

Larson Electronics

Larson Electronics HAL-SL-10-20X-LED Manual de usuario

Larson Electronics

Larson Electronics EPL-20W-HID-X12V-347V-GR50 Manual de usuario

Larson Electronics

Larson Electronics GAU-HB-160LED Manual de usuario

Larson Electronics

Larson Electronics LM-20-3S-EW-LV Manual de usuario

Larson Electronics

Larson Electronics EPP-3P4W-30A-N7 Manual de usuario

Larson Electronics

Larson Electronics VPLHL-7WLED-GR30 Manual de usuario

Larson Electronics

Larson Electronics EXP-EMG-2L-LE6 Manual de usuario

Larson Electronics

Larson Electronics EPL-EMG-CM-42W Manual de instrucciones

Larson Electronics

Larson Electronics HALD-48-1X100LED Manual de usuario

Larson Electronics

Larson Electronics GAU-HB-100LED-RT-UVA-10C Manual de usuario

Larson Electronics

Larson Electronics EPLX-SL-PT-3X80W.RD2-TRC-20X-100C Manual de usuario

Larson Electronics

Larson Electronics LEDWP-600E-M-E2E-20C Manual de usuario

Larson Electronics

Larson Electronics C1D2 Manual de usuario

Larson Electronics

Larson Electronics GVP-48-2L-LED-48VDC-R2 Manual de usuario

Larson Electronics

Larson Electronics EPL-QC-16C-2X150LED-RT-X24V-C1D1-12.3-100-EPP Manual de usuario

Larson Electronics

Larson Electronics EPL-16C-2X150LED-RT Manual de usuario

Larson Electronics

Larson Electronics WAL-C-4XM Manual de usuario

Larson Electronics

Larson Electronics EPLRL-50-16.4-HR-SWB Manual de usuario

Larson Electronics

Larson Electronics EPL-24-2L-LVSOL-80C-C1D2-20C Manual de usuario

Larson Electronics

Larson Electronics EPL-AMB-150LED-50-140DB Manual de usuario

Larson Electronics

Larson Electronics HID-35-RC-W Manual de usuario

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario