Lacanche LAG 010 CKG Manual de usuario
LAG 010 CKG
Page 1 of 20– LAG010CKG – US
- Do not store or use gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance.
-WHAT TO DO IF YOU SMELL GAS.
•Do not try to light any appliance.
•Do not touch any electrical switch.
•Do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone.
Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
- Installation and service must be performed by a qualified
installer, service agency or the gas supplier.
WARNING:
THIS RANGE CAN TIP
INJURY TO PERSONS COULD RESULT
INSTALL ANTI-TIP DEVICE PACKED
WITH RANGE
SEE INSTALLATION INSTRUCTIONS
"OPTIONAL FLAME GRILL "
WARNING: If the information in this manual is not
followed exactly, a fire or explosion may result causing
property damage, personal injury or death.
Page 2 of 20– LAG010CKG – US
SPECIFICATIONS:
Layout:
Built-in cooktop option flame grill left or right of central hob (depending on model)
Description:
-A 12,500 BTU/hr gas burner, a gas valve with thermocouple safety is located under the fire tray.
-An optional bed of lava rock rests on a rack which rests on the bottom of the fire tray.
-A 275 x 460 mm grill resting on pillars is located above the fire tray.
-Electronic spark ignition.
Pressures and hourly consumption:
Table 1
Table 1
Table 1
PRESSURE
6’’ WC
10’’ WC
GAS
Natural gas
L.P.
Btu / hr
Btu / hr
12,500
12,500
Accessories
Cooking grill
Railing of recovery
Juice Tub
Ash-drawer
Fire Tray
Optional Accessory - 36 LCKG:
-Bag of lava rock. 3 kg.
-Stone rack
-Rack Support
Lava Rock Option shown here:
Page 3 of 20– LAG010CKG – US
Page 4 of 20– LAG010CKG – US
Page 5 of 20– LAG010CKG – US
"OPTIONAL FLAME GRILL"
INSTALLER'S MANUAL
Page 6 of 20– LAG010CKG – US
Appliances must be installed in a workmanlike
manner in accordance with the instructions in
this manual and locally applicable regulations.
This manual will be handed over to the user
after installation
Page 7 of 20– LAG010CKG – US
LEVELING
Cautions:
The purchaser undertakes to install or arrange for his/her equipment to be installed in a workmanlike manner and in
accordance with the applicable regulations and standards.
Any servicing or repair work on appliance must be performed by a qualified technician.
Recommendations:
Adjust this appliance by using the leveling feet. Allow a minimum clearance of 50 mm between the appliance and any
other surfaces above counter height (walls affected by heat).
If the appliance is to be built in between two surfaces, it is CRUCIAL to allow free circulation of air behind the appliance
(provide shielding at rear). Cooktops should NEVER be installed lower than adjacent work surfaces. It is also
recommended to allow the unit front panel to protrude 50 mm relative to the adjacent units (cabinets).
Must be installed under an exhaust hood.
Do not install this unit near combustible walls, partitions, pieces of furniture or decorative material unless these are
covered with adequate thermal insulation of the noncombustible type. Making sure the resulting installation meets local
fire regulations.
A shut-off valve must be installed and accessible close to the appliance in order to isolate it from the supply or to facilitate
cutting the gas supply :
Page 8 of 20– LAG010CKG – US
Changing Injector Nozzle:
Replace the injector C.
Lacanche ranges are supplied with the gas fittings requested when the order is placed.
The settings must be fine-tuned when the range is installed.
IMPORTANT: Close the main gas valve before carrying out any work.
GAS
Pressure
Ø
Natural-gas
6" WC
1.40
L.P. propane
10" WC
0.95
IMPORTANT
In case of use with a gas other than that for which the appliance was initially set up, it is crucial
to replace the injectors and modify the adjustments as defined below.
Adjusting the primary air of hob burners
Loosen the screw D that secures the air ring
Adjust the air ring.
Opening in mm /
inches
GAS
Pressure
Oven
Natural gas
6" WC
3 / 1/8
L.P. propane
10" WC
6 / 1/4
Page 9 of 20– LAG010CKG – US
Air Adjustment
Adjusting reduced flow of hob burners:
After connection or change of gas, it is crucial to modify
this adjustment :
►Remove the knob.
►Light the appropriate burner.
►Adjust to minimum setting.
►Use a small screwdriver to set the adjusting screw E.
Note: Flame is reduced to ¼of its size in the minimum
setting, the burner must remain lit when changing
from maximum setting to minimum setting.
Adjusting the safety devices for each thermocouple of the hob:
If the burner goes out, having kept the control knob pushed in for roughly twenty seconds, check that:
- The magnetic head grips the valve moderately.
- The flame touches the point of thermocouple F.
- The thermocouples and magnetic head connections are absolutely clean.
Page 10 of 20– LAG010CKG – US
Otros manuales para LAG 010 CKG
2
Tabla de contenidos
Otros manuales de Parrilla de Lacanche
