25 26 27
28 29 30
INSTRUCTIONS FOR USE
FOLDING AND UNFOLDING OF THE PRAM CHASSIS
To unfold the pram chassis, lay it down flat, push the lock (fig. 1) and pull it up strongly while
holding the handle until the locking mechanism will lock into place (fig. 2).
WARNING! Before using the pram, ensure the locking mechanisms are activated, if not, pull
them tighter.
To fold chassis first lock the front wheels by positioning them perpendicularly to the pram.
Then, press the lock button with your thumb (fig. 3) and then simultaneously pull the levers on
both sides of the handle (fig. 4). To reduce the size of folded pram you can additionally take off
two front wheels (fig. 5) and rear wheels (fig. 6).
WARNING! Before folding the pram chassis, remove the carrycot, sport seat and car seats.
Otherwise folding the pram may be impossible.
PARKING DEVICE
To activate the parking device, you need to step on the lever at the bottom of the pram (fig. 28).
The parking device will be released when the lever is lifted.
WARNING! The pram must not be pushed when the parking device is activated.
WARNING! The pram should not be left unsupervised on a sloping surface when a child is
inside, even when the parking device is activated.
FOOTREST ADJUSTMENT
The footrest can be adjusted by simultaneously pressing side buttons while putting it in the
desired position (fig. 19).
MOUNTING AND REMOVAL OF REAR WHEELS
To mount the rear wheels, press the metal button in the central part of the wheel (fig. 6) and
then slide the wheel on the axis as far as it will go, release the button and pull back the
wheeluntil you hear a “click” sound.
Always check whether the wheels are mounted correctly. In case the pram wheel comes of
when pulled, repeat the wheel mounting procedure until mounted properly.
FASTENING THE HARNESS
In order to fasten the harness, click the ends of the harness in hooks on both sides of the carrycot.
(The harness is not provided with the pram).
HARNESS IN CARRYCOT
The hooks for attaching the harness are in the gondola. When mounting the harness,
fasten it to the harness hooks and check the correctness of the attachment.
WARNING Use the harness when your child begins to sit up.
SHOULDER BAG
The carry bag on the frame has hooks for attaching to the handle of the trolley. In order
to attach the bag to the handle of the trolley, the hooks should be hooked (locked) by
snooping them onto the protruding mounts (fig. 30).
GUIDELINES AND WARNINGS
- Before assembling the pram, ensure that all the components are fit to use. If they are
damaged, the product should not be used.
- When you fold and unfold the pram, ensure that the child is at a safe distance.
- The parking device must be used every time the pram is stopped.
- While adjusting the pram, you must ensure that no moving parts are directly touching
the child.
- Any additional weight on the handle of the pram, the front/back of the seat and/or sides
of the pram makes it unstable.
- When going up a curb or any other step, it is important that you lift the front wheels.
- Store the pram in an area inaccessible to the child.
The pram must not be ridden down the stairs.
The pram should only be used with its original parts authorized by the manufacturer.
The chassis of the pram is compatible only with an original carrycot, seat and car seat
provided by the manufacturer. Only original components included in the set guarantee
full compatibility and proper functioning of the pram.
Every Kunert pram is marked with the company logo for product identification
purposes.
Do not use a mattress thicker than 10 mm.
The upholstery of the pram may be cleaned with a soft cloth, using soap or other mild
cleaning agents.You can apply oil or grease to the pram’s axes, thus protecting it from
excessive wear.
Any additional seat should be equipped with a clear compatibility statement with a
specific pram.
Accessories not accepted by the manufacturer should not be used.
