Konica Minolta BizHub C352 Manual de usuario

Copy, Print, Scan

User Guide 1.1

Get Support:

[email protected]

http://technology.qatar.tamu.edu

TEXAS A&M UNIVERSITY at QATAR

BizHub C352 User Guide

Table of Contents

Important Information Before First Use 3

BizHub C352 Control Panel 4

General copy operations 6

To make a copy 6

Feeding the original 7

Scanning the original in separate batches (“Separate Scan” setting) 11

Scanning a multi-page original from the original glass 13

Selecting a color setting 15

Selecting the original and copy type settings (Simplex/Duplex settings) 16

Specifying the density settings 17

Selecting finishing settings 18

To bind copies with staples 19

Punching holes in copies (Punch settings) 20

Specifying Center Binding 21

Stopping / deleting print jobs 23

General scanning operations 24

Sending data in an email message (Scan to email) 25

Entering the addresses directly 25

Selecting group addresses 26

Selecting destinations from the address book 26

General printing operations 27

Setting printing preferences 29

Orientation 30

Original size and output size 30

Zoom (enlargement and reduction) 30

Input tray (Paper source) 31

Paper type 31

Print type (Duplex printing/Booklet printing) 31

Binding position 32

Combination (printing multiple pages on one page) 32

Stapling and hole punching 34

Output method (Job management) 34

Sorting (collating) and classifying (offset) 36

BizHub C352 User Guide

Important Information Before First Use

Before you can print, copy or scan to the Konica BizHub C352, you must visit the

Information Technology Services Helpdesk to properly setup your user account. If this was

not done during a training orientation session with you, please contact the ITS Helpdesk to

set this up. An ITS Consultant will need to install the printer driver on your computer as well

as walk you through setting up your account on the main Konica BizHub unit.

BizHub C352 User Guide

BizHub C352 Control Panel

Figure 1

Icon Name Description

1 [Power Save] key Press to enter Power Save mode. While the machine is in Power

Save mode, the indicator on the [Power Save] key lights up in

green and the touch panel goes off. To cancel Power Save mode,

press the [Power Save] key again.

2 Touch panel Displays various screens and messages. Specify the various

settings by directly touching the panel.

3 [Access] key If user authentication or account track settings have been applied,

press this key after entering the user name and password (for user

authentication) or the account name and password (for account

track) in order to use this machine. This key is also used to log off.

4 [Box] key Press to enter Box mode. While the machine is in Box mode, the

indicator on the [Box] key lights up in green.

5 [Fax] key Press to enter Fax mode. While the machine is in Fax mode, the

indicator on the [Fax] key lights up in green.

6 [Scan] key Press to enter Scan mode. While the machine is in Scan mode,

the indicator on the [Scan] key lights up in green.

7 [Copy] key Press to enter Copy mode. (As a default, the machine is in Copy

mode.) While the machine is in Copy mode, the indicator on the

[Copy] key lights up in green.

8 [Reset] key Press to clear all settings (except programmed settings) entered in

the control panel and touch panel.

9 [Interrupt] key Press to enter Interrupt mode. While the machine is in Interrupt

mode, the indicator on the [Interrupt] key lights up in green and the

message “Now in Interrupt mode.” appears on the touch panel. To

cancel Interrupt mode, press the [Interrupt] key again.

10 Auxiliary power button Press to turn on/off machine operations, for example, for copying,

printing or scanning. When turned off, the machine enters a state

where it conserves energy.

11 [Stop] key Press the [Stop] key during scanning to stop the scan operation.

12 [Start] key Press to start scanning. When this machine is ready to begin

scanning, the indicator on the [Start] key lights up in green. If the

indicator on the [Start] key lights up in orange, scanning cannot

begin. Press to restart a stopped job.

BizHub C352 User Guide

13 Main power indicator Lights up in green when the machine is turned on with the auxiliary

power button.

14 Data indicator Flashes in green while a print job is being received. Lights up in

green when data is being printed.

15 [Proof Copy] key Press to print a single proof copy to be checked before printing a

large number of copies.

16 Keypad Use to type in the number of copies to be produced. Use to type in

the zoom ratio. Use to type in the various settings.

17 [C] (clear) key Press to erase a value (such as the number of copies, a zoom

ratio, or a size) entered using the keypad.

18 [Mode Check] key Press to display screens showing the specified settings.

19 [Utility/Counter] key Press to display the Utility screen and Meter Count screen.

20 [Mode Memory] key Press to register the desired copy settings as a program or to

recall a registered copy program.

21 Contrast dial Use to adjust the contrast of the touch panel.

22 [Enlarge Display] key Press to enter Enlarge Display mode.

23 [Accessibility] key Press to display the screen for specifying user accessibility

functions.

24 [Help] key

Press to display the Help Main Menu screen, where descriptions of

the various functions and details of operations can be displayed.

BizHub C352 User Guide

General copy operations

This section contains information on the general operation for making copies with the Konica

BizHub C352. The following procedure describes how to copy a single-sided original using

basic copy operations.

To make a copy

1. Press the [Copy] key to display the Basic screen in Copy mode.

2. Position the document to be copied.

3. Specify the desired copy settings.

Figure 2

4. Using the keypad, type in the desired number of copies.

If the number of copies was incorrectly entered, press the [C] (clear) key in the

keypad, and then specify the correct number of copies.

5. Press the [Start] key.

To stop the copy operation being performed, press the [Stop] key. For details, refer to

“Stopping scanning/printing” on page 23.

Figure 3

BizHub C352 User Guide

Feeding the original

The original can be fed in either of the following two ways. Be sure to position the original

correctly according to the type of original being copied. ADF stands for Automatic

Document Feeder and is used when referring to the top-loader on the printer for automatic

document feeding – rather than opening the copier lid and using the original glass.

Figure 4

To load the original into the ADF

¾Do not load originals that are bound together, for example, with paper clips or staples.

¾Do not load more than 100 sheets or so many sheets that the top of the stack is higher

than the mark, otherwise an original misfeed or damage to the original or machine

may occur. However, an original that exceeds 100 pages can be scanned in separate

batches.

¾If the original is not loaded correctly, the original may not be fed in straight or an

original misfeed or damage to the original may occur.

BizHub C352 User Guide

1. Slide the lateral guides to fit the size of the original.

Figure 5

2. Load the original face up in the original feed tray.

Load the original pages so that the top of the

original is toward the back or the right side of

the machine.

Figure 6

3. Adjust the lateral guides to the size of the original.

Figure 7

BizHub C352 User Guide

To place the original on the original glass

¾When placing the original on the original glass, be sure to lift open the ADF or the

original cover at least 15°. If the original is placed on the original glass without the

ADF or the original cover being lifted at least 15°, the correct original size will not be

detected.

¾Do not place objects weighing more than 2 kg on the original glass. In addition, do

not press down extremely hard on a book spread placed on the original glass,

otherwise the original glass may be damaged.

¾For thick books or large objects, make the copy without closing the original cover or

ADF. When an original is being scanned with the original cover or ADF open, do not

look directly at the light that may shine through the original glass. Although the light

that shines through the original glass is bright, it is not a laser beam and, therefore, is

not as dangerous.

1. Lift open the original cover or the ADF.

2. Position the original face down onto the original glass. Load the original pages so that the

top of the original is toward the back or the left side of the machine.

Figure 8

BizHub C352 User Guide

3. Align the original with the mark in the back-left corner of the original scales.

For transparent or translucent originals,

place a blank sheet of paper of the same

size as the original over the original.

Figure 9

For bound originals spread over two facing

pages, such as a book or magazine, position

the top of the original toward the back of

this machine and align the original with

the mark in the backleft corner of the

original scales, as shown.

Figure 10

4. Close the original cover or the ADF.

Otros manuales para BizHub C352

Tabla de contenidos

Otros manuales de Impresora todo en uno de Konica Minolta

Konica Minolta

Konica Minolta FK-502 Manual de usuario

Konica Minolta

Konica Minolta magicolor 2400W Manual de usuario

Konica Minolta

Konica Minolta bizhub 223 Manual de usuario

Konica Minolta

Konica Minolta bizhub C203 Series Manual de usuario

Konica Minolta

Konica Minolta bizhub C650 Series Manual de usuario

Konica Minolta

Konica Minolta bizhub 4750 Manual de usuario

Konica Minolta

Konica Minolta Bizhub C3850 Manual de lista de piezas

Konica Minolta

Konica Minolta bizhub 40p Manual de usuario

Konica Minolta

Konica Minolta magicolor 1690MF Manual de usuario

Konica Minolta

Konica Minolta bizhub C650 Series Manual de usuario

Konica Minolta

Konica Minolta bizhub C3850FS Manual de usuario

Konica Minolta

Konica Minolta Magicolor 2590 MF Manual de usuario

Konica Minolta

Konica Minolta bizhub 200 Manual de usuario

Konica Minolta

Konica Minolta Di1811p Manual de usuario

Konica Minolta

Konica Minolta bizhub250 Manual de usuario

Konica Minolta

Konica Minolta bizhub 751 Manual de usuario

Konica Minolta

Konica Minolta bizhub 501 Manual de usuario

Konica Minolta

Konica Minolta bizhub C203 Series Manual de usuario

Konica Minolta

Konica Minolta bizhub C554e Manual de usuario

Konica Minolta

Konica Minolta bizhub C353 Series Manual de usuario

Konica Minolta

Konica Minolta bizhub C654 Manual de usuario

Konica Minolta

Konica Minolta bizhub 367 Manual de usuario

Konica Minolta

Konica Minolta Drypro 832 Manual de usuario

Konica Minolta

Konica Minolta Bizhub C20P Manual de usuario

Manuales populares de Impresora todo en uno de otras marcas

Triumph Adler

Triumph Adler DC 2016 Manual

Epson

Epson WorkForce WF-2510 Guía del usuario

Epson

Epson Stylus Scan 2000 Manual de instalación y operación

Epson

Epson PictureMate Snap PM 240 Manual de instrucciones

Brother

Brother MFC-J430w Manual de usuario

Lexmark

Lexmark MX710 Series Manual

Brother

Brother MFC-9760 Manual de usuario

Lexmark

Lexmark XC8155 Manual de usuario

Lexmark

Lexmark X642E Manual de usuario

Sharp

Sharp MX-2310U Guía

Aficio

Aficio 200 Manual de usuario

Canon

Canon ImageCLASS 2300 Manual

Ricoh

Ricoh Pro C900 Manual de usuario

Lexmark

Lexmark X925 Manual de usuario

Brother

Brother Business Smart MFC-J4510dw Manual de usuario

Epson

Epson Stylus CX8400 Series Manual de usuario

Oce

Oce VarioLink 5022 Manual de usuario

Copystar

Copystar CS 4551ci Manual de usuario