Kolibri KCD-2000 Manual de usuario
H
This manual contains important information on safety measures and
operational features of the KCD-2000 4-way counterfeit detector.
Please read it carefully before operating your machine and keep it
for future reference.
While every effort has been made to include all features into this user
manual, specications stated may not reect all the features of the
later software versions.
If you have questions about your KCD-2000 and its operation, please
contact technical support at www.kolibriusa.com/contact/.
CHOKING HAZARD.
SMALL PARTS.
Not for children under
3 years old.
DO NOT DISPOSE
IN TRASH. Follow
appropriate local electronics
scrap procedures.
WARNING: RISK OF
ELECTRICAL SHOCK. This
equipment is to be serviced by
trained personnel only.
WARNING: HAZARDOUS
MOVING PARTS. Do not
place fingers, hair, clothes,
lanyard... near moving parts.
PROP 65 WARNING. This product may contain chemicals known to the State
of California to cause cancer, or birth defects or other reproductive harm.
https://oehha.ca.gov/
Table of Contents:
1. INTRODUCTION
1.1 About the KCD-2000_____________________________________________________ 1
1.2 Important Safety Notes ___________________________________________________1
1.3 Box Contents ____________________________________________________________2
1.4 Specications____________________________________________________________ 2
1.5 Views of the KCD-2000 __________________________________________________3
1.6 Home Screen____________________________________________________________4
2. GETTING STARTED
2.1 Powering Up ____________________________________________________________6
2.2 Checking a Bill’s Condition _______________________________________________6
2.3 Inserting the Bill _________________________________________________________7
2.4 Direction of Ejection______________________________________________________8
3. OPERATING MODES
3.1 Value Mode _____________________________________________________________9
3.2 Pass/Fail Mode __________________________________________________________9
4. FUNCTIONS
4.1 Report _________________________________________________________________10
4.2 Menu __________________________________________________________________10
5. MAINTENANCE AND TROUBLESHOOTING
5.1 Maintenance ___________________________________________________________11
5.2 Troubleshooting ________________________________________________________13
5.3 Warranty_______________________________________________________________14
5.4 Troubleshooting ________________________________________________________14
1.1 About the KCD-2000
Thank you for choosing the KCD-2000 4-way counterfeit detector.
The KCD-2000 is an automatic and powerful tool for identifying suspected counterfeit
bills. It reads the denomination of the bills with infrared sensors to catch suspected
counterfeit bills and give a full on-screen report of the genuine bills counted. With its
advanced sensors, the KCD-2000 also veries magnetic marks and UV signatures.
1.2 Important Safety Notes
When using this product, basic safety precautions should always be followed, including
the following:
• Do not use this product in areas where it may be exposed to water or any other
liquids.
• Unplug this product from the wall outlet before cleaning. Use a damp cloth or
air duster to clean the unit.
• To avoid the risk of electrical shock, do not disassemble this unit. Disassembling
will expose you to dangerous voltages and other safety risks. Incorrect reassembly
may cause electrical shock when the unit is subsequently used.
• Only use this product with the power adapter supplied with the unit. Plug the
power cord into a properly grounded wall outlet. Failure to properly ground the
unit can result in severe injury or re.
• Make sure the device is placed on a at surface. Do not operate the unit in
areas with high temperature, humidity or smoke as these conditions may impede
performance.
• This product is designed for indoor use in a well-ventilated environment. Keep
the unit away from direct sunlight and strong magnetic elds which may interfere
with the counterfeit detection sensors.
• When not using the unit for an extended period of time, disconnect the power
cord from the wall outlet.
INTRODUCTION
1.
1
1.3 Box Contents
1. KCD-2000 4-Way Counterfeit Detector
2. AC/DC Power Adapter
3. User Manual
1.4 Specications
Weight: 1.3 lbs (0.59 kg)
Dimensions: 6.9” x 5” x 3.2” (175mm x 128mm x 81mm)
Sensors: Ultraviolet (UV), Magnetic (MG), Infrared (IR)
Power Supply: AC/DC adapter, 12V 500mA
Power Consumption: 10W
Applicable Currency: United States Dollar
2
1. Screen
2. Control Panel
3. Lid
4. Magnetic Bill Guide
5. Front Slot
6. Rear Slot
7. Power Input Jack
8. Micro USB Port
1.5 Views of the KCD-2000
1
2
53
4
6
BACK VIEW
87
3
TOP VIEW
4
CONTROL PANEL
Key Function
1. Display Shows detection outcome
Shows the detailed report of bills counted
Shows settings
Selects settings in the menu
Changes the direction that bills are ejected
(front or back). Moves cursor in the menu
Goes back to home screen from menu or
report screen
2. POWER Button
3. CLEAR Button
4. REPORT Button
5. BACK Button
6. MENU Button
7. SELECT Button
8. ARROW Buttons
Turns unit ON/OFF by pressing and holding down
for three seconds
Resets the count
1
2
3
46
8
57
5
1.6 Home Screen
TOTAL VALUE:
42
10$
USD
1. Currency Selected
2. Direction of Ejection
3. Note Value/Instruction
Message (in Value Mode)
4. Total value counted
1 2
3
4
6
GETTING STARTED
2.
2.1 Powering Up
Ensure the lid is properly closed. Connect the AC/DC adapter to the KCD-2000 and
plug the adapter plug into the power outlet. Turn the KCD-2000 on by pressing the
POWER button. The unit will start loading the system after a couple of seconds and
conduct a short self-test. The screen will display the home screen, indicating it is
ready to operate.
2.2 Checking a Bill’s Condition
Avoid inserting bills that are torn, heavily worn or crumpled. Do not insert bills that
have staples attached or bills that are covered by adhesive tape. Do not insert wet
or heavily stained bills
7
2.3 Inserting the Bill
KCD-2000 is a 4-way detector, meaning that bills can be inserted in any 4 possible
orientations. After the bill is positioned in the insertion slot properly (see images
below), the detector will automatically feed and scan the bill. If a bill is recognized
as authentic, the following will occur:
1.The value of the scanned bill will be displayed (if in value mode)
2.The bill will be ejected from the selected direction
Note: Unrecognized bills will always be ejected from the front regardless
of the selected direction.
1. The machine will emit two beeps
2. An error message will be displayed
3. The bill will be ejected from the front
Correct Way Wrong Way Wrong Way
Tabla de contenidos
Otros manuales de Sensor de seguridad de Kolibri
