Kogan SmarterHome KASHFNGDLKA Manual de usuario
QUICK START GUIDE
SmarterHome™ IP54 Battery
Powered Fingerprint Smart
Wi-Fi Door Lock
(KASHFNGDLKA)
2
CONTENTS
Before starting .......................................02
Installation..............................................03
Operation................................................. 12
Using the app ......................................... 14
Troubleshooting...................................... 16
Specifications...........................................17
3
BEFORE STARTING
NOTE
Please have a Phillips-head screwdriver and 4x AA batteries on hand before
commencing installation.
Please read the following before starting:
• It is recommended to have this installed by a professional.
• Please note that the connection line should not be pressed, bent or
folded during installation.
• Before the installation, ensure the lock is suitable for the door, or the
direction of the handle must be adjusted according to the door opening
direction.
• While installing, the door must be in a half-open state until the
installation is complete.
• After the installation is complete, test whether the front handle and
back handle unlock/lock normally.
• If it does not work properly, please check if there has been an error
during installation, and consult the Installation Troubleshooting steps
on page 11. If still experiencing difficulty, head online to Kogan.com’s
help centre at help.kogan.com
4
INSTALLATION
Installation overview
1. Front panel
2. Connection
column
3. Square steel
4. Lock body
5. Connection line
6. Back panel
7. SET button
8. Connection
column screws
9. Battery cover
10. Battery cover
screw
11. Back handle
12. Connection
column screws
13. Reverse lock knob
14. Back locking
paddle
15. Dead-bolt
16. Latch-bolt
17. Lock body screws
18. Connection
column
19. Keyhole
20. Emergency power
port
21. Front handle
5
1. Confirming door configuration
This smart lock is suitable of 4 kinds of door opening directions. Identify
the correct configuration of your door before commencing installation.
Left-hand door configurations
Right-hand door configurations
From the outside, the door
swings inwards to the left.
From the outside, the door
swings inwards to the right.
From the outside, the door
swings outwards to the left.
From the outside, the door
swings outwards to the right.
TIP
If you get stuck at Step 6.1 setting the dot position, check back here
to ensure you’ve selected the correct door configuration.
INSTALLATION (cont’d)
2. Open hole
Following the hole installation template, drill the holes in your door to
facilitate installation. If you require another installation template, these
are available as a free download from kogan.com
3. Changing the handle direction
Check if the handle direction is appropriate for the door (facing left or
right). If it is correct, continue on to step 4.
If is not the correct direction, this can be changed via the following:
a. Front handle direction change
Disassemble the direction-changing screw, carefully and slowly twist
the handle clockwise 180°, then re-tighten the direction-changing
screw. Check that the handle is not stuck in place, and can be
turned easily.
b. Rear handle direction change
Disassemble the direction-changing screw, carefully and slowly twist
the handle clockwise 180°, then re-tighten the direction-changing
screw. Check that the handle is not stuck in place, and can be
turned easily.
c. Match the front handle and back handle to make sure they are in
the correct direction.
7
4. Installing lock body
Set the installation direction of the latch-bolt in the lock body according
to the door opening direction. Check back to step 1 if you are unsure.
To change the direction of the lock body:
a. Push the reversing block to the other side.
b. Push the latch-bolt into the lock and turn it 180 degrees.
c. Put back the reversing block and the latch-bolt will pop up
automatically.
Following this, place the lock body into the door frame and tighten with
2 fixing screws.
Latch-bolt
Reversing block
Square steel hole
Dead-bolt
Lock Body (5052)
NOTE
Don’t forcefully unlock by heavily pressing down the lock handles
while reversing lock body set.
8
INSTALLATION (cont’d)
5. Select parts
Choose the suitable parts according to the following table.
Door thickness Square steel
length
Connection
column length
Connection
column screw
length
40-51 mm 80mm 35mm 30mm+50mm
52-60mm 80mm 35 or 55mm 50mm+70mm
61-80mm 100mm 55mm 50mm+70mm
81-100mm 120mm 55mm 70mm+90mm
1 00mm
(optional) 140mm 55mm 90mm+110mm
6. Installing the lock
6.1 Front panel
a. Install 2 connection columns on the front panel.
9
TIP
Check back to step 1 to ensure you’ve selected the
correct dot position for your door configuration.
b. Adjust the dot direction on the square steel sleeve with reference to
the sticker on the rubber mat:
• Left-hand door configurations: set the dot left or right
• Right-hand door configurations: set the dot at the top or bottom
c. Insert the suitable square steel into the lock body.
d. Pass the connection line through the door hole.
e. Align the square steel with the square steel hole of the front panel
and fix the front panel on the door, then press the other end of the
square steel.
10
INSTALLATION (cont’d)
6. Installing the lock (continued)
6.2 Rear panel
a. Press the front panel and connect the connection line with the
corresponding interface of the back panel, then insert the excess
line into the door hole.
b. Insert the back-locking paddle into the lock body. You can cut off
one or two sections of the back-locking paddle according to the
thickness of the door.
NOTE
The length of the back-locking paddle should not exceed the
thickness of the door.
NOTE
When installing the back lock, look through the screw hole and make
sure the connection wire is not blocking the connection column hole
to avoid damaging the connection wire when installing the screw.
c. Align the square steel with the square steel hole of the back panel
and compress the back panel.
d. Lock with 2 connection column screws to fix the back panel.
e. Install 4x AA batteries and the battery cover, then lock the battery
cover with the screw.
Otros manuales para SmarterHome KASHFNGDLKA
1
Tabla de contenidos
Otros manuales de Cerradura de puerta de Kogan
