Klipsch Flexus CORE 200 Manual de usuario
Flexus CORE 200
Sound Bar | Barre de son | Barra de sonido | Barra sonora | 条形音箱 | サウンドバー
2
KLIPSCH CONNECT APP
ADD TO YOUR SYSTEM
1. Download the Klipsch Connect app
2. Follow the instructions
APPLICATION KLIPSCH CONNECT • APLICACIÓN KLIPSCH CONNECT • KLIPSCH CONNECT APP • APP KLIPSCH CONNECT • APLICATIVO KLIPSCH CONNECT
KLIPSCH CONNECT应用 • KLIPSCH CONNECTアプリ
Flexus Sound System is built to grow with you. Add up to two wireless subwoofers and wireless surround speakers to
create a home theater.
For more information, please visit: <link to Flexus landing page>
IMPORTANT SAFETY INSTRUCTIONS
1. Read these instructions
2. Keep these instructions
3. Heed all warnings
4. Follow all instructions
5. Do not use this apparatus near water
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance with the manufacture’s
instructions.
8. Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or grounding plug. A polarized plug has
two blades with one wider than the other. A grounding plug has two blades and a third
grounding prong. The wide blade or the third prong is provided for your safety. If the
provided plug does not fit into your outlet, consult an electrician for replacement of the
obsolete outlet.
10. Protect the power cord from being walked on or pinched particularly at the plugs,
convenience receptacles, and at the point where they exit from the apparatus.
11. Only use attachments/accessories specified by the manufacturer.
12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or
sold with the apparatus. When a cart or rack is used, use caution when moving the
cart/apparatus combination to avoid injury from tip-over.
13. Unplug the apparatus during lightning storms or when unused for long periods of time.
Refer all servicing to qualified personnel. Servicing is required when the apparatus has been
damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
FCC AND CANADA EMC COMPLIANCE INFORMATION
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
2. Any Changes or modifi cations not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit diff erent from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF Radiation Exposure Statement
1. This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment.
2. This transmitter must not be colocated or operating in conjunction with any other antenna
or transmitter.
3. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
CE RF Radiation Exposure Statement
This device can be operated in at least one Member State without infringing applicable
requirements on the use of radio spectrum.
This equipment complies with EU radiation exposure limits set forth for an uncontrolled
environment.
This equipment should be installed and operated with minimum distance 20 cm between
the radiator and your body.
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to
the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement."
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless Device is below the Industry Canada (IC) radio
frequency exposure limits. The Wireless Device should be used in such a manner such that
the potential for human contact during normal operation is minimized.
This device has also been evaluated and shown compliant with the IC RF Exposure limits
under mobile exposure conditions. (antennas are greater than 20cm from a person’s body).
for each off mode, standby mode (or another condition which does not exceed the applicable
power consumption requirements for off mode or standby mode) and networked standby into
which the equipment is switched by the power management function or similar function:
— the power consumption expressed in watts rounded to the first decimal place;
— the period after which the equipment reaches automatically standby mode, off mode or
networked standby in minutes and rounded to the nearest minute;
DC OUT 1 ---------USB Type-C(5V/2.0A)
DC OUT 2----------USB Type-A(connect with Flexus Transport 100) ,data
transmission
3
INSIDE
Sound Bar
Remote
Wall-Mount Template
HDMI Cable
Wall Mount Brackets (2) Wall Mount Screws (2)
CONTENU • CONTENIDO • INHALT • CONTENUTO • CONTEÚDO • 内 • 内部
Sound Bar
Barre de son
Barra de sonido
Sound Bar
Sound Bar
Barra sonora
条形音箱
サ ウンドバ ー
Wall-Mount Template
Gabarit de montage mural
Plantilla de montaje en la pared
Wandbefestigungsschablone
Dima per il fissaggio a parete
Modelo para instalação na parede
挂壁模板
壁取付け用テンプレート
Remote
Télécommande
Control remoto
Fernbedienung
Telecomando
Controle remoto
遥控器
リモ ート
Wall Mount Brackets
Supports pour montage mural
Soportes de montaje en la pared
Wandhalterungen
Staffe per montaggio a parete
Suportes para montagem em parede
壁挂式支架
壁取付け用ブラケット
Wall Mount Screws
vis pour montage mural
Tornillos de 1/4 plg.
1/4” Schrauben
Viti per montaggio a parete
Parafusos 1/4”
1/4” 螺钉
壁取付け用ねじ
Power Cord
Cordon d’alimentation
Cordón de alimentación
Gleichstromkabel
Cavo di alimentazione
Cabo de alimentação
直流电源线
電 源コ ード
HDMI Cable
Câble HDMI
Cable de HDMI
HDMI-Kabel
Cavo HDMI
Cabo HDMI
HDMI 电缆
HDMIケーブル
Power Cord
4
SOUND BAR CONTROLS
On / Off
Volume
Down
Source
Volume
Up
BARRE DE SON • BARRA DE SONIDO • SOUND BAR • SOUND BAR • BARRA SONORA • 条形音箱 • サ ウ ンドバ ー コ ントロ ー ル
On / Off
Sous tensio / Hors tension
Encendido / Apagado
Ein / Aus
Acceso / Spento
Ligar / Desligar
开/关
オン／ オフ
Source Select (Toggle)
Sélection de la source (commutation)
Selección de fuente (cíclica)
Quellenwahl (Umschalten)
Selezione segnale (in sequenza ciclica)
Seleção da fonte (Alternar)
电源选择（切换）
ソ ー ス 選 択（ ト グ ル ）
Volume Down
Volume bas
Bajada de volumen
Leiser
Riduzione volume
Diminuir o volume
音量减小
音量 ダウン
Volume Up
Volume haut
Subida de volumen
Lauter
Aumento volume
Aumentar o volume
音量增大
音 量 アップ
5
SOUND BAR CONTROLS
2
DIRECT WALL MOUNTING
3
1
{
4”
10cm
MONTAGE MURAL DIRECT • MONTAJE DIRECTO EN LA PARED • DIREKTE WANDBEFESTIGUNG • MONTAGGIO DIRETTO A PARETE • MONTAGEM DIRETA NA PAREDE
直接墙上安装 • 壁への直接取付け
4
6
CONNECTING TO POWER
PUISSANCE DE CONNEXION • CONEXIÓN PODER • VERBINDUNGSSTROM • COLLEGAMENTO ALLA PRESA DI CORRENTE • PODER DE CONEXÃO • 连接电源
電源に接続する
7
CONNECTING TO POWER
LFE IN
CROSSOVER /
LOW PASS
LFE
SUB OUT
CONNECTING WIRED SUBWOOFER
CONNEXION CÂBLÉE DU CAISSON DE GRAVES • CONEXIÓN DE SUBWOOFER DE CABLE • KABELANSCHLUSS EINES SUBWOOFERS • COLLEGAMENTO A UN
SUBWOOFER CABLATO • CONEXÃO DO SUBWOOFER COM FIO • 连接有线低音炮 • 有線サブウーファーの接続
Tabla de contenidos
Otros manuales de Sistema de altavoces de Klipsch
Klipsch
Klipsch Quintet III Manual de usuario
Klipsch
Klipsch 6-02 Manual de usuario
Klipsch
Klipsch ProMedia Ultra 2.0 Manual de usuario
Klipsch
Klipsch BAR 48 Manual de usuario
Klipsch
Klipsch CA-650-T Manual de usuario
Klipsch
Klipsch SB 120 Manual de usuario
Klipsch
Klipsch HD THEATER SB 3 Manual de usuario
Klipsch
Klipsch CS-700 Manual de usuario
Klipsch
Klipsch CINEMA 800 Manual de usuario
Klipsch
Klipsch iGroove Manual de usuario
Klipsch
Klipsch ProMedia ProMedia 5.1 Manual de usuario
Klipsch
Klipsch ProMedia 2.1 Wireless Manual de usuario
Klipsch
Klipsch BAR 40 Manual de usuario
Klipsch
Klipsch Flexus CORE 100 Manual de usuario
Klipsch
Klipsch ROOMGROOVE Manual de usuario
Klipsch
Klipsch ProMedia GMX D-5.1 Manual de usuario
Klipsch
Klipsch R-10B Manual de usuario
Klipsch
Klipsch HD THEATER SB 3 Manual del propietario
Klipsch
Klipsch RSB-6 Manual de usuario
Klipsch
Klipsch RSB-11 Manual de uso y cuidado
Manuales populares de Sistema de altavoces de otras marcas
Sondpex
Sondpex Active Speaker System and Digital Music... Manual de usuario
JVC
JVC NX-PN7 Manual de usuario
Marshall Amplification
Marshall Amplification AR-DM61-BT Manual de usuario
Yamaha
Yamaha NX-A01 - Speaker Sys Manual de usuario
SE Audiotechnik
SE Audiotechnik I-LINE Manual de usuario
Gemini
Gemini WRX-843 Series Manual de usuario