Kirby Morgan SuperMask MOD-1 Manual de usuario

Kirby Morgan Dive Systems, Inc.®

1430 Jason Way Santa Maria, California 93455

Phone: 805/928-7772 Fax: 805/928-0342

www.KirbyMorgan.com email: [email protected]

Part #815-060

SuperMask®/MOD-1

Communications Assembly

PART # DESCRIPTION QTY

815-060 SuperMask®/MOD-1 Communications Assembly 1

Tools Required:

• Scissors

• Tie Wrap Gun or Diagonal Cutters

POD should be removed from Mask when installing or removing communication assembly. Mask strap DOES

NOT need to be removed for installation or removal or communications assembly.

Procedures for installing assembly into mask is the same for both the right and left communications ports.

1) Using a sharp pair of scissors cut off the end of one

of the communications ports, located below the bottom

edge of the mask frame.

2) Push the microphone into the port. (The microphone

will appear to be too large, but the seal easily stretches.)

Ensure the main body is fully inserted into the com-

munications ports with the leading edge of the cut port

resting on the upraised edge on the main body of the

communications assembly.

Conﬁrm solid black side of the microphone is facing to-

wards diver’s mouth

Kirby Morgan Dive Systems, Inc.®

1430 Jason Way Santa Maria, California 93455

Phone: 805/928-7772 Fax: 805/928-0342

www.KirbyMorgan.com email: [email protected]

3) Use the included tie wrap P/N 520-038 to secure the

communications assembly to the mask. Position the end

or termination of the tie wrap so it won’t be touching the

diver’s face.

If the mask strap is installed, ensure the earphone wires

are routed on the inside of the strap NOT THE OUTSIDE.

4) Bend the lens body away from the jaw frame and

route the longer earphone wire across the front of the

mask. Ensure the wire is pushed down into the gap found

between these two parts of the mask. When the mask is

released the wire should ﬁt snugly into the groove.

Kirby Morgan Dive Systems, Inc.®

1430 Jason Way Santa Maria, California 93455

Phone: 805/928-7772 Fax: 805/928-0342

www.KirbyMorgan.com email: [email protected]

5) Insert the earphone into the earphone pocket, gray shiny side facing diver’s ear

Operating considerations

Microphone

The microphone is supplied with a “ﬂexible contacts protective band”. The band prevents interaction of the

mouth with the connectors.

The dynamic microphone is encapsulated and protected by a hydrophobic membrane. The microphone is

waterproof and is designed to handle operating under pressure. If the POD is removed underwater the micro-

phone WILL NOT suffer any damage. However, continuing to descend WITHOUT the POD sealed to the mask

of a distance greater than 33 fsw/10m may damage the microphone.

Ascending at a rate greater than 33 FSW/10m with an exposed microphone (POD not on the mask) can also

cause damage to the microphone. An ascent rate of 33 FSW/10m or slower will allow the expanding gas to

vent properly through the membrane, causing no damage to the microphone element.

Earphones

It is designed to work underwater so the best quality is achieved when the unit is submerged.

Post Dive

The communicator and microphone should be rinsed with fresh water (immersed, not a strong “ﬂow of water”)

after each dive and should be placed in a well-ventilated area that is not exposed to direct sunlight to dry. D-

Mic does not have a polarity restriction when assembled on the PTT contacts. Be careful to unscrew the two

screws before removing it. Clean the contacts and lubricate them on a timely base.

Kirby Morgan Dive Systems, Inc.®

1430 Jason Way Santa Maria, California 93455

Phone: 805/928-7772 Fax: 805/928-0342

www.KirbyMorgan.com email: [email protected]

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Instrumento de buceo de Kirby Morgan

Kirby Morgan

Kirby Morgan M-48 SuperMask Manual de usuario

Kirby Morgan

Kirby Morgan KMB 18 Instrucciones de funcionamiento

Kirby Morgan

Kirby Morgan 100-075 Manual de usuario

Kirby Morgan

Kirby Morgan 525-757 Manual de usuario

Kirby Morgan

Kirby Morgan KM 97 Manual de usuario

Kirby Morgan

Kirby Morgan SuperFlow 525-757 Manual de usuario

Kirby Morgan

Kirby Morgan 77 Manual de usuario

Kirby Morgan

Kirby Morgan SuperLite 27 Manual de usuario

Kirby Morgan

Kirby Morgan 37SS Manual de usuario

Kirby Morgan

Kirby Morgan EXO original Manual

Kirby Morgan

Kirby Morgan M-48 MOD-1 Manual de usuario

Kirby Morgan

Kirby Morgan 37 Manual de usuario

Kirby Morgan

Kirby Morgan KM 37 Manual de usuario

Kirby Morgan

Kirby Morgan EXO Full-Face Mask Manual

Kirby Morgan

Kirby Morgan SuperLite 17C Helmet Manual de usuario

Kirby Morgan

Kirby Morgan 17A/B Manual de usuario

Kirby Morgan

Kirby Morgan 525-100 Manual de usuario

Kirby Morgan

Kirby Morgan 17A/B Documento técnico

Kirby Morgan

Kirby Morgan SuperLite 27 Manual de usuario

Kirby Morgan

Kirby Morgan One Way Valve Manual de usuario

Kirby Morgan

Kirby Morgan MOD-1 Manual de usuario

Kirby Morgan

Kirby Morgan SuperLite 17B Manual de usuario

Kirby Morgan

Kirby Morgan 525-115 Manual de usuario

Kirby Morgan

Kirby Morgan 415-107 Manual de usuario

Manuales populares de Instrumento de buceo de otras marcas

Sherwood

Sherwood Amphos Manual de usuario

Zeagle

Zeagle N2ition Manual de usuario

Tusa

Tusa Q 1203 CE Guía

Sherwood Scuba

Sherwood Scuba Insight Instrucciones de montaje

SUBMERSIBLE SYSTEMS

SUBMERSIBLE SYSTEMS Spare Air 600 Manual de usuario

OCEANS

OCEANS S1 Supersonic Manual de usuario

heinrichs weikamp

heinrichs weikamp OSTC 2 Manual de usuario

Omer

Omer SP2 Manual de usuario

Scott

Scott PRO-PAK Manual de usuario

Apeks

Apeks BLACK SAPPHIRE Manual de usuario

Waterproof

Waterproof DRYSUIT Manual de usuario

Dräger

Dräger PAS AirPack 1 Manual de usuario

Dive Lab

Dive Lab KIRBY MORGAN KMB 18 Manual de usuario

Ratio Computers

Ratio Computers iDive Manual de usuario

Oceanic

Oceanic PROPLUS X Manual de usuario

CFA

CFA MSA G1 Manual de usuario

Genesis

Genesis Centauri Manual de usuario

TREND

TREND GAUGE/60 Manual de usuario