Kinetico Kube Manual de usuario

Installation Instructions

Kube Drinking Water Filter

0808 164 2019

www.kubewater.co.uk

Pantone 1235 Pantone 185 Pantone Process Blue Pantone 360 Pantone Cool Grey 10

02 Kube Drinking Water Filter

Installation Instructions

Visit: kubewater.co.uk

Pantone 1235 Pantone 185 Pantone Process Blue Pantone 360 Pantone Cool Grey 10

Thank you

We are thrilled you're only moments away from amazing ﬁltered

water on tap...

Kinetico Installation Service

To ensure peace-of-mind, compliance with

water regulations and warranty compliant

workmanship, we recommend your new

Kube Drinking Water Filter is installed by an

experienced Kinetico Technical Engineer.

Installation takes up to 1 hour. Access under

your kitchen sink will be required.

If the need arises to drill through granite

worktops, an additional charge may be

payable. This will be agreed prior to

installation.

Self Installation

If you decide to install the Kube Drinking Water

Filter yourself, please ensure the installation

complies with our instructions and all necessary

water regulations.

Pantone 1235 Pantone 185 Pantone Process Blue Pantone 360 Pantone Cool Grey 10

Kube Drinking Water Filter

Installation Instructions

Visit: kubewater.co.uk

Let’s get started

This manual has everything you need to get your new

Kube Drinking Water System up and running!

Installation pre-check 5

What's in the box? 6

Preparing for Kube 7

Customer support 7

Connecting Kube 8

Installation - Kinetico 1 way tap 12

Installation - Kinetico Gemini 3 way tap 13

Installation - Kinetico Carina 3 way tap 14

FAQs 15

Warranty 15

Pantone 1235 Pantone 185 Pantone Process Blue Pantone 360 Pantone Cool Grey 10

Kube Drinking Water Filter

Installation Instructions

Visit: kubewater.co.uk

CAUTION:

• Do not use the Kube with water that is

microbiologically unsafe or of unknown

quality.

• The Kube Drinking Water System must be

properly located and installed in accordance

with these Installation Instructions.

• Use the Kube on a safe-to-drink, COLD water

supply only.

• Do not install on a HOT WATER supply.

• Do not install the Kube outside or anywhere it

is likely to freeze, water freezing in the system

may cause damage. The temperature of the

water supply to the Kube must be above 2°C.

• The Kube will withstand up to 6 bar water

pressure.

• To order replacement ﬁlters visit kinetico.co.uk

Installation pre-check

The installation kit includes a saddle valve for a 15mm copper pipe. For

any further assistance please contact Kinetico on 0808 164 2019.

If in doubt, give us a call on 0808 164 2019, we are here to help.

06 Kube Drinking Water Filter

Installation Instructions

Visit: kubewater.co.uk

Pantone 1235 Pantone 185 Pantone Process Blue Pantone 360 Pantone Cool Grey 10

What's in the box?

1 x Kube Drinking

Water Filter head

1 x high-capacity

ﬁlter cartridge

1 2 1 x drinking

water tap

1 x ¼" plastic tubing 1 x tap adaptor

41 x self-cutting

saddle valve

5 6

1 x carafe 1 x ¾" adaptor

8 9

2 x screws and

2 x wall plugs

Pantone 1235 Pantone 185 Pantone Process Blue Pantone 360 Pantone Cool Grey 10

Kube Drinking Water Filter

Installation Instructions

Visit: kubewater.co.uk

Preparing for Kube

Adjustable wrench

22mm basin wrench OR Adjustable basin wrench

Advisable Tools:

Necessary Tools

Utility knife

Dry towel/paper towels

To complete installation you should have a basic knowledge of

plumbing ﬁttings.

Customer support

The Kinetico customer services team is always on hand to assist and help

you with any questions or support you require.

For all enquiries, please send an e-mail to info@kinetico.co.uk or contact us on: 0808 164 2019.

Please also check out our FAQs, see page 15.

Tape measure

Flat bladed

screw driver

Cross headed

screw driver

12mm drill bit

Drill

08 Kube Drinking Water Filter

Installation Instructions

Visit: kubewater.co.uk

Pantone 1235 Pantone 185 Pantone Process Blue Pantone 360 Pantone Cool Grey 10

STEP 1

Check the clearance

Clean out the area under your sink and ensure

that there is enough room for your Kube

Drinking Water System.

Check that the cold water supply, the proposed

location of the system and the location of the

drinking water tap requires no more than 1.5m

of the supplied ¼" pipe.

Connecting Kube

STEP 2

Shut o the water!

Isolate the supply to your cold water tap. Open

the tap and drain any residual water to ensure it

is fully isolated.

STEP 3

Attach the saddle valve

Locate the 15mm ø copper cold water supply

pipe to your kitchen tap.

Select a suitable position to attach the saddle

valve, down stream of the isolation point.

Remove the screws and back plate from the

saddle valve. Place the back plate on the back

of the 15mm pipework and place the front plate

(rubber grommet facing inwards) opposite.

Using the two screws, bring the plates together,

taking care to secure ﬁrmly. Do not over tighten

and crush the copper pipe.

1.55

BACK

PLATE

FRONT

PLATE

SCREWS

RUBBER

GROMMET

BLADE

LOCKING

NUT

ON/OFF

HANDLE

Pantone 1235 Pantone 185 Pantone Process Blue Pantone 360 Pantone Cool Grey 10

Kube Drinking Water Filter

Installation Instructions

Visit: kubewater.co.uk

STEP 4

Cut the pipe

Push and twist the saddle valve body into the

threaded hole in the front plate, then wind

clockwise until almost fully wound.

STEP 5

Attach the 3/4" adaptor

Attach the 3/4" adaptor to the 3/4" male thread

on the saddle valve by turning clockwise.

Lock the body in place by tightening the locking

nut against the front plate with a spanner.

10 Kube Drinking Water Filter

Installation Instructions

Visit: kubewater.co.uk

Pantone 1235 Pantone 185 Pantone Process Blue Pantone 360 Pantone Cool Grey 10

STEP 8

Connect the water supply

Push the cut length of tubing all the way into

the adaptor ﬁtted to the saddle valve. Pull

back to check it is secure.

STEP 6

Secure the ﬁlter head

Attach the ﬁlter head to the side of your kitchen

cupboard, ensuring there is a minimum of 35cm

clearance below the ﬁlter head to allow for easy

removal and replacement of the ﬁlter cartridge.

STEP 7

Cut the tubing

Measure the length of tubing required from the

saddle valve to the left hand connection on the

ﬁlter head, allowing for a bit of slack.

Taking care not to kink the tubing, use a sharp

utility knife to make a perpendicular cut at the

correct length.

1.55

35cm

Otros manuales para Kube

Tabla de contenidos

Otros manuales de Sistema de filtración de agua de Kinetico

Kinetico

Kinetico K5 Manual de usuario

Kinetico

Kinetico POWERLINE PRO Series Manual de usuario

Kinetico

Kinetico Premier RO Manual de usuario

Kinetico

Kinetico PRO CP 213f OD Carbon Manual de usuario

Kinetico

Kinetico Undersink 7000 Manual de usuario

Kinetico

Kinetico ERGO RO BLUE Manual de usuario

Kinetico

Kinetico premier FILTER Series Manual de usuario

Kinetico

Kinetico SuperSoft Manual

Kinetico

Kinetico Commercial Plus Series Manual de usuario

Kinetico

Kinetico Reverse Osmosis Compact Series Manual de usuario

Kinetico

Kinetico MACH Series Manual de usuario

Kinetico

Kinetico K10 Manual de usuario

Kinetico

Kinetico Mach Series 2060f Manual de usuario

Kinetico

Kinetico SMF Series Manual de usuario

Kinetico

Kinetico B Series Manual de usuario

Kinetico

Kinetico Pacifica Manual de usuario

Kinetico

Kinetico TQ 172 Manual de usuario

Kinetico

Kinetico K5 Manual de usuario

Kinetico

Kinetico Undersink 7000 Manual de usuario

Kinetico

Kinetico K5 Manual de usuario

Kinetico

Kinetico 2025s Manual de servicio

Kinetico

Kinetico Essential Manual de usuario

Kinetico

Kinetico Powerline PRO Series Manual de usuario

Kinetico

Kinetico S Series Manual de usuario

Manuales populares de Sistema de filtración de agua de otras marcas

Wisy

Wisy LineAir 100 Manual de usuario

Schaffner

Schaffner Ecosine FN3446 Series Manual de funcionamiento

Pentair

Pentair FLECK 4600 SXT Guía del usuario

H2O International

H2O International H20-500 Manual de usuario

Renkforce

Renkforce 2306241 Manual de usuario

Neo-Pure

Neo-Pure TL3-A502 Manual de usuario

FLTR

FLTR OBF Manual de usuario

STA-RITE

STA-RITE VERTICAL GRID DE FILTERS S7D75 Manual de usuario

Applied Membranes

Applied Membranes W-G844EM Manual de usuario

BEGA

BEGA 116 Manual de usuario

WATA

WATA Standard Manual de usuario

Price

Price FFU series Manual

Gaggenau

Gaggenau BRITA INTENZA 467873 Manual de usuario

Brita

Brita SAFF-100 Manual de usuario

HEISSNER

HEISSNER FPU24000-00 Manual de usuario

BGS technic

BGS technic 1518 Manual de usuario

Reverse Osmosis

Reverse Osmosis RF Series Manual de usuario

ubbink

ubbink Filtramax Series Manual de usuario